Controlling thickness to tune performance of high-mobility transparent conducting films deposited from Ga-doped ZnO ceramic target

Structure modification has been found to tune significantly the transparent-conducting performance, especially mobility and conductivity of hydrogenated Ga-doped ZnO (HGZO) films. The strong correlation between film thickness and mobility of the films is revealed. The mobility increases quickly with increasing the thickness from 350 to 900 nm, and then tends to be saturated at further thicknesses. A higher mobility than 50 cm²/Vs can be achieved, which is an extra-high value for polycrystalline ZnO films deposited by using the sputtering technique. The thickness-dependent mobility originates from scatterings on grain boundaries and dislocation-induced defects controlled by thin-film growth. Based on the Volmer-Weber model, an expansion model is built up to describe the thickness-dependent crystal growth of the HGZO films, especially at the thick films. As a result, the 800 nm-thick HGZO film obtains the highest performance with high mobility of 51.5 cm²/Vs, low resistivity of 5.3 × 10^?4 Ωcm, and good transmittance of 83.3 %.     

Effect of Boronizing on Operating Stability of Steel AISI 304L under Erosion Impact of Hard Particles

Metal Science and Heat Treatment - The effect of solid boronizing at 950°C for 2 and 4 h on the phase composition, microstructure, hardness and abrasive wear of steel AISI 304L is studied...     

Advanced Surface of Fibrous Activated Carbon Immobilized with FeO/TiO2 for Photocatalytic Evolution of Hydrogen under Visible Light

FeO-doped TiO₂ nanoparticle photocatalysts were immobilized onto the surface of fibrous activated carbon (ACF) via a sol-gel process. As an adsorbent and photocatalyst, FeO-TiO₂ on immobilized ACFs (FeO-TiO₂/ACF) greatly improved the photocatalysis rate of hydrogen production as compared with pure TiO₂ and ACF-TiO₂ under UV irradiation and visible light. The addition of ACFs surface significantly reduced the photogenerated pairs of electrons-hole recombination, thereby promoting the photocatalysis action of doped photo-metal oxides of FeO-TiO₂. Co-doping of FeO onto the lattice of the TiO₂ approach can improve the absorption activity of visible light through photo-metal oxide of TiO₂ and further enhance hydrogen production under visible light. The photocatalytic fabrics (FeO-TiO₂/ACF) were effortlessly split out from the experimental solution for re-utilization and exhibited high stability even after five complete regeneration cycles.     

On keys' meanings and modes: the impact of different key solutions on children's efficiency using a mobile phone

The present study investigates the impact of different key solutions of mobile phones on users' effectiveness and efficiency using the devices. In the first experiment, 36 children (9 - 14 years) and in the second experiment 45 young adults (19 - 33 years) completed four common phone tasks twice consecutively on three simulated phones that had identical menus, but different key solutions. An approach was undertaken to quantify the complexity of keys in three models, incorporating different factors contributing to the keys' complexity (number of key options, number of modes and number of modes with a semantically dissimilar meaning), in order to predict users' performance decrements. As a further main factor, the degree of the users' locus of control (LOC) was measured and interactions with performance outcomes were studied. As dependent measures, the number of inefficient keystrokes, the number of tasks solved and the processing time were determined. Results showed a significant effect of control key solutions on users' efficiency and effectiveness for both children and young adults. Moreover, children's LOC values significantly interacted with performance: children with low LOC values showed the lowest performance and no learnability, especially when using keys with a high complexity. From the three factors contributing to the complexity of keys, keys exerting different functions with semantically inconsistent meanings had the worst effect on performance. It is concluded that in mobile user interface design keys with semantically inconsistent meanings should be generally avoided.     

Fabrication of Schottky barrier MOSFETs using self-assembly CoSi2 nanopatterning and spacer gate technologies

A self-assembly patterning method for generation of epitaxial CoSi₂ nanostructures was used to fabricate 50 nm channel-length MOSFETs. The transistors have either a symmetric structure with Schottky source and drain or an asymmetric structure with n⁺-source and Schottky drain. The patterning technique is based on anisotropic diffusion of Co/Si atoms in a strain field during rapid thermal oxidation. The strain field is generated along the edges of a mask consisting of 20 nm SiO₂ and 300 nm Si₃N₄. During rapid thermal oxinitridation (RTON) of the masked silicide structure, a well-defined separation of the silicide layer forms along the edge of the mask. These highly uniform gaps define the channel region of the fabricated device. The separated silicide layers act as metal source and drain. A poly-Si spacer was used as the gate contact. The asymmetric transistor was fabricated by ion implantation into the unprotected CoSi₂ layer and a subsequent out-diffusion process to form the n⁺-source. I–V characteristics of both the symmetric and asymmetric transistor structures have been investigated.     

Management, Market, and Financial Factors Separating Winners and Losers in E-Business

There have been many successful e‐businesses as well as many failed e‐businesses. The methods and practices that were evident in the development of both surviving e‐businesses and failed ones have much to teach us. Why did some e‐businesses fail while others survived? At present few guidelines exist to assist e‐business owners and managers wanting to succeed in their Internet‐based ventures. This study empirically investigated factors that may lead to e‐business success or failure; these were categorized as management, market, and financial factors. The results of a survey were combined with one‐on‐one interviews of venture capitalists who funded successful and failed e‐businesses. The results indicate that certain factors deemed applicable to an e‐business may have contributed to the firm’s eventual success or failure.     

Comparison of morphologic assessment of hypertrophic cardiomyopathy by magnetic resonance versus echocardiographic imaging

To compare the value of echocardiography and magnetic resonance imaging (MRI) in the assessment of the amount and extent of hypertrophy in hypertrophic cardiomyopathy (HC) and, second, to correlate the degree of hypertrophy, as assessed by MRI, with clinical and electrocardiographic parameters, 30 consecutive patients (16 men and 14 women, aged 20 to 74 years) with HC were studied. Measurements of left ventricular wall thickness were performed at 11 predetermined segments (5 basal, 5 midventricular, and 1 apical) by 2-dimensional echocardiography and MRI. Two parameters derived from MRI studies were considered as indicators of the degree and extent of hypertrophy: (1) mean of the measured wall thickness at the 11 segments, and (2) the number of segments with thickness > 15 mm. Results showed that, from a total of 330 myocardial segments, thickness could be measured by echocardiography in 221 (67%), whereas MRI allowed measurement of 320 segments (97%). When compared with clinical and electrocardiographic data, no correlation was found regarding mean wall thickness and number of hypertrophied segments by MRI except for the presence of an abnormal electrocardiographic repolarization pattern. It is concluded that MRI allows a better assessment of the degree and extension of left ventricular hypertrophy than echocardiography in HC. Despite the precise information on hypertrophy provided by MRI, the amount and degree of hypertrophy bears no correlation with most of the clinical data in these patients.