Localized corrosion of (lean) duplex stainless steels in immersion units of urban wastewater treatment plants

With lower alloying cost and higher mechanical properties, lean duplex stainless steels can be an alternative to the more commonly used austenitic stainless steels. However, these alloys are still not the preferred choice, probably due to a lack of field experience. A study was thus initiated in view of defining the limits of use of selected (lean) duplexes for urban wastewater treatment units. The present paper shows the localized corrosion performance of selected lean duplexes in chloride contaminated solutions. The results are compared with austenitic S30403 and S31603 and with the more standard duplexes S82441 and S32205. The effect of welding was also investigated. Exposures in field municipal wastewater plants were conducted for 1 year in low and high chloride content units. The results show that lean duplexes S32101 and S32202 can be used as alternatives to S30403 and S31603 in low chloride electrolytes. At 500 ppm of chloride content, duplex stainless steel S32304 showed better corrosion resistance than S30403 and S31603. For higher chloride contents (1000 ppm and above) the standard duplexes S82441 and S32205 shall be preferred.     

Theory of correlations in partly labelled homopolymer melts

Small-angle neutron scattering by a polymer melt with partly tagged chains is considered. When several types of chain (differently labelled) are present in the system a new long-range correlation effect which modifies the scattering spectrum is predicted. This effect will arise because of the chemical polydispersity of the sample. A general formalism is developed to calculate the scattering intensity and is applied to special cases: diblock and triblock chains. It is shown that even a small chemical polydispersity leads to important long-range fluctuations and modifies the scattering spectrum substantially.     

A Nonvolatile Organic Memory Device Using ITO Surfaces Modified by Ag‐Nanodots

We report on a single‐layer organic memory device made of poly(N‐vinylcarbazole) embedded between an Al electrode and ITO modified with Ag nanodots (Ag‐NDs). Devices exhibit high ON/OFF switching ratios of 10⁴. This level of performance could be achieved by modifying the ITO electrodes with some Ag‐NDs that act as trapping sites, reducing the current in the OFF state. Temperature dependence of the electrical characteristics suggest that the current of the low‐resistance state can be attributed to Schottky charge tunnelling through low‐resistance pathways of Al particles in the polymer layer and that the high‐resistance state can be controlled by charge trapping by the Al particles and Ag‐NDs.     

Les qualités psychométriques de l'échelle de comportements d'adaptation Loranger-Pépin.

Presents results of 3 studies on the psychometric properties of the LP-ABC (M. Loranger and M. Pépin, 1993), a French-language instrument for assessing general functioning in adults with mental retardation. The studies involved a total of 299 male and female Canadian adults with mental retardation. Results confirm the internal consistency, construct validity, criterion validity, discriminant validity, interrater reliability, and test–retest reliability of the LP-ABC. (English abstract) (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

An efficient 3-dim FFT for plane wave electronic structure calculations on massively parallel machines composed of multiprocessor nodes

Three-dimensional Fast Fourier Transforms (FFTs) are the main computational task in plane wave electronic structure calculations. Obtaining a high performance on a large numbers of processors is non-trivial on the latest generation of parallel computers that consist of nodes made up of a shared memory multiprocessors. A non-dogmatic method for obtaining high performance for such 3-dim FFTs in a combined MPI/OpenMP programming paradigm will be presented. Exploiting the peculiarities of plane wave electronic structure calculations, speedups of up to 160 and speeds of up to 130 Gflops were obtained on 256 processors.     

Comparative influence of a single allergen exposure on the different components of airway response to methacholine

We compared the effects of an allergen challenge on airway responsiveness to methacholine, the slope of the dose-response curve (DRC) and post-methacholine fall in forced vital capacity (FVC) or forced expiratory volume in 1 s (FEV1)/FVC, and determined whether any changes in these parameters were related to the presence and magnitude of the late asthmatic response (LAR) in mild stable asthma. Twenty-three allergic asthmatic subjects had an allergen challenge, preceded and followed 24 (n = 12) and/or 48 (n = 22) h later by a methacholine challenge. Sixteen subjects had a dual asthmatic response to the allergen. On the post-allergen methacholine challenge, as compared with the pre-allergen test, differences in mean fall in FVC or FEV1/FVC at 20% fall in FEV1 and the slope of the DRC did not achieve statistical significance, even in the group with LAR, which showed a significant increase in airway responsiveness at 24 h. There was, however, a correlation between allergen-induced changes in PC20 and (1) the change in post-methacholine FVC fall in the LAR group at 48 h, and (2) the change in the slope of the DRC in the early-asthmatic-response group at 24 h. In conclusion, allergen-challenge-induced changes in airway response to methacholine are heterogeneous among asthmatic subjects and although it may increase airway responsiveness (PC20), particularly in late responders, it minimally affects the other aspects of airway response to methacholine, suggesting that a more powerful or sustained allergic stimulus is required to modify the latter.     

Preparation of Poly(D,L-Lactide/Glycolide) Nanoparticles of Controlled Particle Size Distribution: Application of Experimental Designs

This study investigates the use of the solvent evaporation method for preparing acid and glycolic acid-based copolymer nanoparticles. Initially, appropriate technological and formulation factors for elaboration of polymeric particles were selected by screening. Most favourable results were obtained using polyvinyl alcohol as a dispersing agent and a high pressure homogenizer to reduce the droplet size of the emulsion initially formed. On the basis of the conclusion thus drawn, a composite rotational experimental design was employed to evaluate the joint influence of three formulation variables (phase volume ratio of the emulsion formed, polymer concentration and homogenization pressure) on the micromeritic properties of the suspension finally obtained (mean particle size, coefficient of variation and polydispersity of the particle size distribution). Analysis of variance corresponding to the experimental design, showed a significant influence of the volume phase ratio and the polymer concentration on the mean particle size and the coefficient of variation, whereas the polydispersity is also affected by the homogenization pressure. Considering this information, a 3² experimental factorial design was then selected to investigate the possible interaction between the phase volume ratio and the concentration of polyvinyl alcohol in the aqueous phase. Analysis of variance and subsequent sequencial regression analysis evidenced last hypothesis providing the way to determine the experimental conditions required to achieve a specific particle size distribution.     

Retrospective Versus Prospective Statements and Outcome of Presidential Elections

This study investigates retrospective and prospective voting from a communication perspective, looking to see whether there is relationship between election outcome and the relative emphasis U.S. presidential candidates place on retrospective (past) versus prospective (future) utterances in campaign messages. The sample includes a variety of presidential campaign messages (acceptance addresses, primary and general television spots, debates, direct mail advertising) from several campaigns (1948–2004) by numerous candidates. In the primary phase of the campaign, there is no difference between winners and losers in relative emphasis on retrospective and prospective statements. However, in the general phase of the presidential campaign, winners use a significantly larger proportion of retrospective (and a smaller proportion of prospective) utterances than losers. Furthermore, the relationship between emphasis on retrospective utterances and election outcome was larger for incumbents than challengers (but significant for both types of candidates). These findings support retrospective voting in the general, but not the primary, campaign.     

High accuracy path tracking for vehicles in presence of sliding: Application to farm vehicle automatic guidance for agricultural tasks

When designing an accurate automated guidance system for vehicles, a major problem is sliding and pseudo-sliding effects. This is especially the case in agricultural applications, where five-centimetre accuracy with respect to the desired trajectory is required, although the vehicles are moving on slippery ground. It has been established that RTK GPS was a very suitable sensor to achieve automated guidance with such high precision: several control laws have been designed for vehicles equipped with this sensor, and provide the expected guidance accuracy as long as the vehicles do not slide. In previous work, further control developments have been proposed to take sliding into account: guidance accuracy in slippery environments has been shown to be preserved, except transiently at the beginning/end of curves. In this paper, the design of this control law is first recalled and discussed. A Model Predictive Control method is then applied in order to preserve accuracy of guidance even during these curvature transitions. Finally, the overall control scheme is implemented, and improvements with respect to previous guidance laws are demonstrated through full-scale experiments.