UTEC and Ferut: the University of Toronto's computation centre

Although not well known, the University of Toronto had a very early computer-development program and in 1952 was one of the first few institutions with an operable computer in North America. This article describes the university's initial attempt to build the UTEC computer and how it acquired the pioneering Ferut machine     

Thermomechanical behaviour of composites

This paper derives the governing equations for the thermomechanical behaviour of composites. When the basic equations for the thermoelastic behaviour of solids were first derived in the nineteenth century several approximations were made. The effect of these assumptions are discussed and illustrated by the results of a simple laboratory test. The implications of this work on the analysis of impact damaged laminates are then discussed.     

A rubber-modified thermoplastic where the morphology produced by phase-separation induced by polymerization disappears at high conversions

An unexpected experimental finding is reported where the primary morphology developed during polymerization-induced phase separation in a rubber-modified thermoplastic practically disappears at high conversions. This process was evidenced by light scattering (LS) and scanning electron microscopy (SEM) for a particular composition of solutions of polyisobutylene oligomers (PIB) in isobornylmethacrylate (IBoMA), during the free-radical polymerization of the monomer. The primary phase separation produced a dispersion of domains rich in PIB containing significant amounts of the monomer (IBoMA). Polymerization of the monomer in these domains occurred at high overall conversions producing the filling of dispersed domains with a PIBoMA-PIB blend that could not be distinguished from the matrix. Under these conditions the final material had the appearance of a homogeneous blend.     

X-ray topography studies of dislocations in single crystal CVD diamond

X-ray topography has been used to study single crystal diamond samples homoepitaxially grown by microwave plasma-assisted chemical vapour deposition (CVD) on high pressure high temperature (HPHT) and CVD synthetic diamond substrates. Clusters of dislocations in the CVD diamond layers emanated from points at or near the interface with the substrate. The Burgers vectors of observed dislocations have been determined from sets of {111} projection topographs. Dislocations have line directions close to the [001] growth direction and are either edge or 45° mixed dislocations. Where groups of dislocations originated at isolated points they tended to be of the edge variety. Where the substrate surface was deliberately damaged before growth, two sets of dislocations were observed to have propagated from each line of damage and there was a tendency for dislocations to be of the 45° mixed variety with a component of their Burgers vector parallel to the polishing direction. It is demonstrated that X-ray topography can be used to deduce the growth history of CVD synthetic diamond samples produced in multiple growth stages.     

Integrating trust into the CyberCraft Initiative via the Trust Vectors model [Application Notes]

This research supports the hypothesis that the Trust Vector model can be modified to fit the CyberCraft Initiative, and that there are limits to the utility of historical data. This research proposed some modifications and expansions to the Trust Model Vector, and identified areas for future research.     

Emission of trace toxic metals during pulverized fuel combustion of Czech coals

A study of the trace elements emission (As, Se, Cd, Co, Cr, Cu, Zn, Hg, Tl, Pb, Ni, Sn, Sb, V, Mn and Fe) from pulverized coal combustion has been made at six heating and power stations situated in the Czech Republic. The amount of chlorine in coal has considerable influence on volatilization of some elements such as Zn, Cu, Pb, Hg and Tl, which is explained by the formation of thermodynamically stable compounds of these elements with chlorine. Generally, the affinities for Cl follows the order Tl > Cu > Zn > Pb > Co > Mn > Sn > Hg. The experimental data indicates enrichment of some of the trace toxic elements in the emissions (Cu, Zn, As, Se, Cd, Sn, Sb, Hg and Pb) and good agreement was obtained by thermodynamic equilibrium calculations with a few exceptions. In the case of Fe, Mn, Co, Cr and Sn calculated values are overestimated in the bottom ash and there are zero predicted amounts of these elements in the fly ash. In comparison, the results from experiments show up to 80% of these elements retained in fly ash. This implies that there exist additional steps leading to the enrichment by Fe, Mn, Co, Cr and Sn of small particles. Such mechanisms could include the ejection during devolatilization of small inorganic particles from the coal of bottom ash particles, or disintegration of the char containing these metals to small particles of fly ash. On the other hand, there are slightly overestimated or similar values of relative enrichment factors for As, V, Cu, Cd, Sb, Tl and Pb in the fly ashes and zero predicted values for bottom ashes. Our experimental results show about 5% or less of these elements are retained in bottom ashes, so they probably remain in the bottom ash inside unburned parts of coal. Copyright © 2003 John Wiley & Sons, Ltd.     

A case-mix classification system for medical rehabilitation

Dissatisfaction with Medicare's current system of paying for rehabilitation care has led to proposals for a rehabilitation prospective payment system, but first a classification system for rehabilitation patients must be created. Data for 36,980 patients admitted to and discharged from 125 rehabilitation facilities between January 1, 1990, and April 19, 1991, were provided by the Uniform Data System for Medical Rehabilitation. Classification rules were formed using clinical judgment and a recursive partitioning algorithm. The Functional Independence Measure version of the Function Related Groups (FIM-FRGs) uses four predictor variables: diagnosis leading to disability, admission scores for motor and cognitive functional status subscales as measured by the Functional Independence Measure, and patient age. The system contains 53 FRGs and explains 31.3% of the variance in the natural logarithm length of stay for patients in a validation sample. The FIM-FRG classification system is conceptually simple and stable when tested on a validation sample. The classification system contains a manageable number of groups, and may represent a solution to the problem of classifying medical rehabilitation patients for payment, facility planning, and research on the outcomes, quality, and cost of rehabilitation.