Grinding is critical in modern manufacturing due to its capacity for producing high surface quality and high-precision parts. One of the most important parameters that indicate the grinding quality is the surface roughness (Ra). Analytical models developed to predict surface finish are not easy to apply in the industry. Therefore, many researchers have made use of artificial neural networks. However, all the approaches provide a particular solution for a wheel–workpiece pair, not generalizing to new grinding wheels. Besides, these solutions do not give surface roughness values related to the grinding wheel status. Therefore, in this work the modelling of the dynamic evolution of the surface roughness (Ra) based on recurrent neural networks is presented with the capability to generalize to new grinding wheels and conditions taking into account the wheel wear. Results show excellent prediction of the surface finish dynamic evolution. The absolute maximum error is below 0.49 µm, being the average error around 0.32 µm. Besides, the analysis of the relative importance of the inputs shows that the grinding conditions have higher influence than the wheel characteristics over the prediction of the surface roughness confirming experimental knowledge of grinding technology users.
The snowpack can impact atmospheric chemistry by exchanging adsorbed or dissolved gases with the atmosphere. Modeling this impact requires the knowledge of the specific surface area (SSA) of snow and its variations with time. We have therefore measured the evolution of the SSA of eight recent surface snow layers in the Arctic and the French Alps, using CH4 adsorption at liquid nitrogen temperature (77 K). The SSA of fresh snow layers was found to decrease with time, from initial values in the range 613-1540 cm2/g to values as low as 257 cm2/g after 6 days. This is explained by snow metamorphism, which causes modifications in crystal shapes, here essentially crystal rounding and the disappearance of microstructures. A parametrization of the rate of SSA decrease is proposed. We fit the SSA decrease to an exponential law and find that the time constant alpha(exp) (day(-1)) depends on temperature according to alpha(exp) = 76.6 exp (-1708/7), with Tin kelvin. Our parametrization predicts that the SSA of a snow layer evolving at -40 degrees C will decrease by a factor of 2 after 14 days, while a similar decrease at -1 degrees C will only require 5 days. Wind was found to increase the rate of SSA decrease, but insufficient data did not allow a parametrization of this effect. 相似文献
Current theories of snow metamorphism indicate that sublimating snow crystals have rounded shapes, while growing crystals have shapes that depend on growth rates. At slow growth rates, crystals are rounded. At moderate rates, they have flat faces with rounded edges. At fast growth rates, crystals have flat faces with sharp edges, and they have hollow faces at very fast growth rates. The main growth/sublimation mechanism is thought to be by the homogeneous nucleation of new layers at or near crystal edges. It was also suggested that the equilibrium shape of snow crystals would be temperature dependent: rounded above -10.5 degrees C, and faceted below. To test these paradigms, we have performed SEM investigations of snow samples having undergone metamorphism under natural conditions, and of snow samples subjected to isothermal metamorphism at -4 degrees and -15 degrees C in the laboratory. In general, current theories predicting crystal shapes as a function of growth rates, and of whether crystals are growing or sublimating, are verified. However, the transition in equilibrium shapes from rounded to faceted at -10.5 degrees C is not observed in our isothermal experiments that reveal a predominance of rounded shapes after more than a month of metamorphism at -4 and -15 degrees C. Some small crystals with flat faces that also have sharp angles at -15 degrees C, are observed in our isothermal experiments. These faces are newly formed, and contradict current theory. Several hypotheses are proposed to explain their occurrence. One is that they are due to sublimation at emerging dislocations. 相似文献
Selective hydrogenation is the habitual industrial process to eliminate the most unsaturated hydrocarbons, which are harmful for later applications. In this paper, the kinetics of the selective hydrogenation of a C2 mixture over two palladium/alumina catalysts with both front end and tail end variants, have been studied. Experiments have been carried out to analyse the influence of temperature, hydrogen/acetylene molar ratio, carbon monoxide content in the feed and hydrocarbon volumetric flow rate on the corresponding conversion and selectivity.
The experiments were performed in an integral plug flow reactor and the integral method was used for the kinetic analysis. The minimization of the objective function was made by the Marquardt algorithm for multiple response and the continuity equation set integrated by fourth order Runge-Kutta technique.
The most adequate models were the power law type for the experimental range. The comparison between experimental and observed values of the acetylene and ethane molar fraction in the hydrocarbon mixture, which are used for minimization, confirm the suitability of the fit. 相似文献
This paper presents the design and development of a real-time monitoring and diagnostic system for diagnosing the degraded behaviour in wire-electro discharge machining. The detection in advance of the degraded behaviour is crucial since this can lead to the breakage of the cutting tool (the wire), reducing the process productivity and the required accuracy (Ho et al., Tools Manuf 44:1247–1259, 2004). This work presents the design and development of a real-time monitoring system that alerts the degraded behaviour. It can detect different types of degraded behaviours that have been previously identified during the analysis phase. Unlike other works found in the literature review, which are focussed on proprietary hardware, the present paper proposes a flexible real-time platform based on a commercial data acquisition board that can be easily configured for different purposes. It has been applied to develop a real-time monitoring and diagnostic system that uses virtual sensors to diagnose the degradation of the process. The results of this work show a satisfactory performance of the presented approach. 相似文献
Patatin was extracted from potato tubers (Solanum tuberosum L. cv. Spunta) and purified to homogeneity by ammonium sulfate salt fractionation and one sole chromatographic step. A spectrophotometric
mixed micellar assay for patatin lipid acyl hydrolase (LAH) activity was designed with the detergent octaethylene glycol monododecyl
ether (C12E8). Patatin LAH used p-nitrophenyl butyrate (PNP-butyrate) as substrate when solubilized in (C12E8) micelles. In the mixed micellar system, patatin LAH responds to the PNP-butyrate surface concentration expressed as mol%
(=[PNP-butyrate]·100/([detergent]-critical micellar concentration)) and not to the molarity of PNP-butyrate. The kinetic parameters
were determinined; Vmax was independent of the mixed micelle concentration, as was Km, when expressed as mol%. However, Km was dependent on C12E8 concentration when expressed in molar concentration. C12E8/PNP-butyrate proved to be a reliable system for assaying patatin LAH activity and is superior to the commonly used Triton
X-100 and SDS methods. It permits investigation of the substrate requirements of patatin LAH activity because the concentration-independent
Km can be determined both in mol% and as the absolute number of substrate molecules per micelle. In addition, the detergent
did not affect the enzyme activity. 相似文献
Diolefins and alkynes in C2-C3 olefins streams can be selectively hydrogenated to produce high-purity mono-olefins for downstream polyolefin production. The aim of this paper is on the experimental study of the tail end selective hydrogenation of a stream cracking C2-C3 cut, over two different palladium/alumina catalysts. A series of integral reactor type experiments were performed and the integral method was used for the kinetic analysis. The minimization of the objective function was made by the Marquardt algorithm for multiple response and the continuity equation set integrated by fourth order Runge-Kutta technique. The comparison between experimental and observed values of the acetylene, ethylene, ethane, MAPD, propylene and propane molar fraction in the hydrocarbon mixture, which were used for the minimization, confirm the suitability of the fit. 相似文献
The functionality of interfaces in hybrid inorganic/organic (opto)electronic devices is determined by the alignment of the respective frontier energy levels at both sides of the heterojunctions. Controlling the interface electronic landscape is a key element for achieving favourable level alignment for energy and charge transfer processes. Here, it is shown that the electronic properties of polar ZnO surfaces can be reversibly modified using organic photochromic switches. By employing a range of surface characterization techniques combined with density functional theory calculations, it is demonstrated that self‐assembled monolayers (SAMs) of photochromic phosphonic acid diarylethenes (PA‐DAEs) can be employed to reversibly change the electronic properties of polar ZnO/SAM structures by light stimuli. The highest occupied molecular orbital level of PA‐DAE is raised by 0.7 eV and the lowest unoccupied one lowered by 0.9 eV, respectively, upon illumination by ultraviolet light and the levels shift back to their original position upon illumination by green light. The results thus provide a pathway to tailor hybrid interface electronic properties in a dynamic manner upon simple light illumination, which can be exploited to reversibly tune the electrical properties of photoswitchable (opto)electronic devices. 相似文献