Crosstalk between microstrip transmission lines

Methods for prediction of crosstalk between microstrip transmission lines are reviewed and simplified for the weak-coupling case. Classical coupled transmission line theory is used for uniform lines, and potential and induced EMF methods are used for crosstalk between nonuniform lines. It is shown that the potential method is equivalent to classical coupled transmission line theory for the case of uniform lines. An experiment was performed for uniform coupled microstrip lines for frequencies from 50 MHz to 5 GHz, and good agreement between theory and measurement was obtained for both near- and far-end crosstalk     

The apolipoprotein E allele epsilon 4 is overrepresented in patients with the Lewy body variant of Alzheimer's disease

We determined apolipoprotein E (ApoE) genotypes in 122 autopsied demented patients. The frequency of the ApoE epsilon 4 allele was 39.6% in Alzheimer's disease (AD), 29.0% in the Lewy body variant of AD (LBV), and 6.25% in diffuse Lewy body disease. For AD and LBV patients, the epsilon 4 frequency was significantly higher than that reported in nondemented controls (10 to 15%). Therefore, LBV and AD share ApoE epsilon 4 as a genetic risk factor, providing further evidence that these conditions overlap.     

In vivo studies of an implantable energy convertor for skeletal muscle powered cardiac assist

A device that harnesses the mechanical energy of skeletal muscle contracting in a linear configuration has been implanted in goats. This energy convertor transforms muscle work to hydraulic energy that could drive a variety of cardiac assist devices. The device is mounted with a rib clamp and plate affixed to the sternum by cortical bone screws. A transcutaneous hydraulic line carries a silicon based working fluid to an external system that controls the muscle load. In 60 to 70 kg goats, the latissimus dorsi insertion was reattached to the energy convertor. A Telectronics myostimulator with intramuscular electrodes stimulated the latissimus dorsi. In acute implants, hydraulic pressures in excess of 150 psi were obtained. Chronic implantation of the device allowed system evaluation in the conscious unanesthetized animal. Two weeks after implant, hydraulic pressures in excess of 200 psi were obtained and energy transferred to the external loading system exceeded 1 J per contraction. Six weeks after implant, the device continued to cycle freely. These initial results are very promising and suggest an implantable energy convertor is feasible. Development of an energy convertor is an important step toward tether-free skeletal muscle powered cardiac assist devices.     

Pressure swing adsorption: Development of an equilibrium theory for gas separations

Two versions of the pressure swing adsorption process are analysed as a means for purification of the light component of a binary feed of arbitrary composition. Local equilibrium with linear, uncoupled isotherms is assumed. The results of the analysis show that a critical pressure ratio must be exceeded before complete purification is possible and that this pressure ratio increases as the light-component content of the feed decreases. When clean up of the light component is complete, pressurization with product leads to higher light-component recoveries than pressurization with feed. This difference becomes large for small separation factors, small fractions of the light component in the feed, and large pressure ratios.     

Parallel path consistency

Filtering algorithms are well accepted as a means of speeding up the solution of the consistent labeling problem (CLP). Despite the fact that path consistency does a better job of filtering than arc consistency, AC is still the preferred technique because it has a much lower time complexity. We are implementing parallel path consistency algorithms on multiprocessors and comparing their performance to the best sequential and parallel arc consistency algorithms.^(1,2) (See also work by Kerethoet al. ⁽³⁾ and Kasif⁽⁴⁾) Preliminary work has shown linear performance increases for parallelized path consistency and also shown that in many cases performance is significantly better than the theoretical worst case. These two results lead us to believe that parallel path consistency may be a superior filtering technique. Finally, we have implemented path consistency as an outer product computation and have obtained good results (e.g., linear speedup on a 64K-node Connection Machine 2).     

Disorder effects on the strain response of model polymer networks

Molecular dynamics simulations are used to investigate polymer networks made by either end-linking or randomly crosslinking a melt of linear precursor chains. The resulting network structures are very different, since end-linking leads to nearly ideal monodisperse networks, while random crosslinking leads to polydisperse networks, characterized by an exponential strand length distribution. Networks with average strand length 20 and 100 were generated. These networks were used to study the effects of disorder in the network connectivity on observables averaged either over the entire network or selected sub-structures. Heterogeneities in the randomly crosslinked networks cause significant differences in the localization of monomers, however, neither the localization of crosslinks nor the microscopic strain response are significantly affected. Compared to end-linked networks, randomly crosslinked networks have a slightly increased tube diameter, and as a result a slightly decreased shear modulus, but otherwise identical stress-strain behavior. For the investigated systems, we conclude that the microscopic strain response, tube diameter, and stress-strain relation are all insensitive to the heterogeneities due to the linking process by which the network were made.