Effects of hydrolysis on the physical properties of short glass-fibre reinforced poly(ethylene terephthalate)

The mechanical fracture strength and toughness of short-fibre composites, injection moulded from compounds of poly(ethylene terephthalate) (PET) containing 10 and 30% (by weight) (w/o) glass, have been investigated and the dependence upon matrix hydrolytic stability determined. Mouldings have been characterised by several physical techniques to evaluate molecular weight, degradation rates, crystallinity and morphology, whilst time-dependent gravimetric data were derived to quantify sorption kinetics and allow comparisons with theoretical reaction rates to be made. During melt processing, PET is hydrolysed extremely rapidly by traces of moisture (<0.02w/o). yet the inherent strength of moulded composites declines significantly only below an apparently critical molecular weight. However, on long-term humid ageing in hot water, impact behaviour especially is rendered more complex by simultaneous crystallisation, molecular reorder and losses of interfacial bond strength.     

Ozone measurement in visible region: an optical fibre sensor system

Ozone measurement based on the optical absorption of visible light at 603 nm using polymer optical fibres is investigated and tested. Comparisons with a commercial UV based sensor demonstrate the ability of the visible based sensor to measure high concentrations over a range 27-127 mg/litre. A resolution of 5 mg/litre is also demonstrated for this sensor.     

Crystal structure of tyrosine hydroxylase at 2.3 A and its implications for inherited neurodegenerative diseases

Tyrosine hydroxylase (TyrOH) catalyzes the conversion of tyrosine to L-DOPA, the rate-limiting step in the biosynthesis of the catecholamines dopamine, adrenaline, and noradrenaline. TyrOH is highly homologous in terms of both protein sequence and catalytic mechanism to phenylalanine hydroxylase (PheOH) and tryptophan hydroxylase (TrpOH). The crystal structure of the catalytic and tetramerization domains of TyrOH reveals a novel alpha-helical basket holding the catalytic iron and a 40 A long anti-parallel coiled coil which forms the core of the tetramer. The catalytic iron is located 10 A below the enzyme surface in a 17 A deep active site pocket and is coordinated by the conserved residues His 331, His 336 and Glu 376. The structure provides a rationale for the effect of point mutations in TyrOH that cause L-DOPA responsive parkinsonism and Segawa's syndrome. The location of 112 different point mutations in PheOH that lead to phenylketonuria (PKU) are predicted based on the TyrOH structure.     

Measurements of Stress Intensity Factors of an Interface Crack Under Mixed Mode Loading

The optical method of caustics has been utilised to measure both the stress intensity factor for a crack lying along the interface of an aluminium/epoxy bimaterial specimen, and the mode mixity arising from the difference in the elastic properties across the interface. Measurements were carried out by using a novel modification to the method whereby caustics are produced and measured from both sides of the specimen, so compensating automatically for the distortion induced in the specimen due to misaligned loading fixtures. A flat reflective surface across the interface was obtained by adhering a reflective coating to the specimen. Verification that this coating does not affect measurement accuracy was obtained by comparing stress intensity factors measured from coated and uncoated monolithic aluminium specimens where good agreement was found to exist between both measurements.     

Perceptions of general practice among homosexual men

BACKGROUND: Primary care has an important role to play in the prevention and management of the human immunodeficiency virus (HIV). It has been suggested that homosexual men experience a variety of problems in relation to primary care. AIM: As part of a larger study, it was decided to examine the extent to which a sample of homosexually active men experienced difficulties in general practice and whether they consulted their general practitioner for problems related to HIV or the acquired immune deficiency syndrome (AIDS). METHOD: Homosexual men were recruited for interview in 1991-92 from a variety of sources including genitourinary clinics and homosexual organizations. RESULTS: Of 623 men registered with a general practitioner 44% had not informed their general practitioner of their sexual orientation and 44% of the 77 men who were HIV antibody positive, as confirmed by the study, had not informed their general practitioner of this fact. Men who viewed their practice as unsympathetic towards homosexual men were less likely to have informed their general practitioner of their sexual orientation or HIV status. The majority of men (87%) nevertheless viewed primary care as an appropriate source of HIV/AIDS advice. CONCLUSION: There is considerable scope for improvement in the acceptability of general practice to homosexual men.     

Determining pheromone content of hairpencils from individual virgin males ofPseudaletia unipuncta (Haw.) (Lepidoptera: Noctuidae)

Levels of benzaldehyde recovered from virginPseudaletia unipuncta (Haw.) males were not influenced by (1) the time hairpencils remained in the solvent (1-72 hr), (2) anesthetization or agitation of males prior to excision of hairpencils, or (3) the time (photophase or scotophase) that hairpencils were excised. Thus the interindividual variability observed is not a methodological artifact. Most males had similar concentrations in both hairpencils, although in some cases only one hairpencil contained pheromone. In one case, a male with partially extruded hairpencils had no benzaldehyde at all. Neither pupal weight nor hairpencil length proved to be reliable indicators of pheromone content.Contribution No. 373, Département de biologie, Université Laval.     

Effect of thermal residual stresses on fatigue crack opening and propagation behavior in an Al/SiC p metal matrix composite

The effects of a thermal residual stress field on fatigue crack growth in a silicon carbide particle-reinforced aluminum alloy have been measured. Stress fields were introduced into plates of material by means of a quench from a solution heat-treatment temperature. Measurements using neutron diffraction have shown that this introduces an approximately parabolic stress field into the plates, varying from compressive at the surfaces to tensile in the center. Long fatigue cracks were grown in specimens cut from as-quenched plates and in specimens which were given a stress-relieving overaging heat treatment prior to testing. Crack closure levels for these cracks were determined as a function of the position of the crack tip in the residual stress field, and these are shown to differ between as-quenched and stress-relieved samples. By monitoring the compliance of the specimens during fatigue cycling, the degree to which the residual stresses close the crack has been evaluated. formerly Research Student, Department of Materials Science and Metallurgy, University of Cambridge formerly Lecturer, Department of Materials Science and Metallurgy, University of Cambridge This article is based on a presentation made in the symposium entitled “Creep and Fatigue in Metal Matrix Composites” at the 1994 TMS/ASM Spring meeting, held February 28–March 3, 1994, in San Francisco, California, under the auspices of the Joint TMS-SMD/ASM-MSD Composite Materials Committee.     

Algorithm and architecture for a Galois field multiplicative arithmetic processor

We present a new algorithm for generic multiplicative computations of the form ab/c in GF(p/sup m/), including multiplication, inversion, squaring, and division. The algorithm is based on solving a sequence of congruences that are derived from the theory of Grobner bases in modules over the polynomial ring GF(p)[x]. Its corresponding hardware and software architectures can be successfully used in applications such as error control coding and cryptography. We describe a versatile circuit associated with the algorithm for the most important case p=2. The same hardware can be used for a range of field sizes thus permitting applications in which different levels of error control or of security are required by different classes of user. The operations listed are all performed by the hardware in the same number of clock cycles, which prevents certain side-channel attacks. The loss in performance by having 2m iterations for multiplication is compensated by the full parameterization of the Galois field and the ability to perform division and multiplication in parallel.