Effect of Freezer Programs on Real-Time Storage Results of Dissolution Profiles

Carstensen and Rhodes¹ have suggested that when, in stability programs, assays cannot be performed immediately after the protocol-designated storage time, then freezing them until such a time when assays can be performed would be a reasonable manner to retain the protocol schedule. They caution, however, that such a procedure may not be valid for dissolution data. The article to follow deals with real-time data showing that such a process is feasible for Nalidixic Acid tablets (and presumably for other tablets as well), and that, furthermore, the dissolution pattern would seem to be “frozen” as well.     

Exit effect on hydrodynamics of the internal circulating fluidized bed riser

This is the first time an extensive investigation has been carried out regarding the effects of riser exit geometry on pressure drop and solid behaviour inside the Internal Circulating Fluidized Bed (ICFB) riser, using different riser exit geometries at several operating conditions.The Radioactive Particle-Tracking (RPT) technique was used for solid concentration measurements and solid residence time distribution at the exit zone. Experiments were conducted using Geldart B particles, in the gas superficial velocity range of 4 to 10 m/s. Axial solid hold-up, solid residence time distribution in the exit zone, and the reflux ratio factor k_m, (defined earlier by [E.H. Van der Meer, R.B. Thorpe, J.F. Davidson, Flow patterns in the square cross-section riser of a circulating fluidized bed and the effect of riser exit design, Chem. Eng. Sc. 55 (19) (2000) 4079-4099]), were the main criteria used to investigate the impact of gas-solid separator devices implemented at the ICFB riser exit.Solid residence time distribution results and axial solid hold-up profiles provided clear evidence that the separator device at the riser exit strongly influences the hydrodynamic structure of the ICFB riser. The V-shaped riser exit geometry was found to be the optimum of all the configurations studied.     

程控电流源无需电源支持

工程实验室通常都配有各种电源设备、伏特计、函数信号发生器和示波器。然而．许多这样的工程实验室却缺少电流源。这令人感到非常遗憾，因为电流源有助于生成I-V（电流对电压）曲线，它能对电池进行充放电操作，对电源设备预加负荷，并可实现许多其他的应用。     

Analysis of the Datagram Congestion Control Protocol’s connection management procedures using the sweep-line method

State space explosion is a key problem in the analysis of finite state systems. The sweep-line method is a state exploration method which uses a notion of progress to allow states to be deleted from memory when they are no longer required. This reduces the peak number of states that need to be stored, while still exploring the full state space. The technique shows promise but has never achieved reductions greater than about a factor of 10 in the number of states stored in memory for industrially relevant examples. This paper discusses sweep-line analysis of the connection management procedures of a new Internet standard, the Datagram Congestion Control Protocol (DCCP). As the intuitive approaches to sweep-line analysis are not effective, we introduce new variables to track progress. This creates further state explosion. However, when used with the sweep-line, the peak number of states is reduced by over two orders of magnitude compared with the original. Importantly, this allows DCCP to be analysed for larger parameter values. Somsak Vanit-Anunchai was partially supported by an Australian Research Council Discovery Grant (DP0559927) and Suranaree University of Technology. Guy Edward Gallasch was supported by an Australian Research Council Discovery Grant (DP0559927).     

Polarization control in a vertical cavity surface emitting laser submitted to optical feedback

We study experimentally and theoretically two polarization effects in a vertical cavity surface emitting laser submitted to optical feedback. In a first experiment, we obtain flips between two linearly polarized laser modes up to a frequency of 50 MHz using an external cavity with a polarizer. In a second experiment, polarization self modulation is demonstrated up to a frequency of 2.6 GHz, using a quarter wave plate instead. Numerical calculations, based on a four levels model for the active medium, show a good agreement with the experiments.     

A single-chip 12.7 Mchips/s digital IF BPSK direct sequencespread-spectrum transceiver in 1.2 μm CMOS

This paper describes a fully integrated digital-spread spectrum transceiver chip fabricated through MOSIS in 1.2 μm CMOS. It includes a baseband spread spectrum transmitter and a coherent intermediate frequency (IF) receiver consisting of a Costas loop, an acquisition loop for the pseudo-noise (PN) sequence, and a clock recovery loop with a 406.4 MHz onchip numerically controlled oscillator (NCO). The transceiver is capable of operating at a maximum IF sampling rate of 50.8 MS/s and a maximum chip rate of 12.7 R Mchips/s (Mcps) with selectable data rates of 100, 200, 400, and 800 kbps. At the maximum operating speed of 50.8 R MS/s, it dissipates 1.1 W. In an additive white Gaussian noise channel the IF receiver achieves a receiver output SNR within 1 dB of theory and can acquire code with a wide range of input SNR from -17 dB to over 30 dB. The transceiver chip has been interfaced to an RF up/down converter to demonstrate a wireless voice/data/video link operating in the 902-928 MHz band     

Multifocal primary neuroblastoma

The purpose of this study is to present three patients with multifocal primary neuroblastoma, to review the literature, and describe the radiographic findings. SUBJECTS AND METHODS: Three children with multifocal neuroblastoma have been identified. The case histories and imaging findings in these patients are reviewed. RESULTS: Two children had synchronous and one child had metachronous multifocal primary neuroblastoma. The primary tumors were both in the abdomen in one patient, both in the chest in another patient, and in the chest and abdomen in the third patient. Evidence for multifocal origin of these tumors, rather than metastatic spread, is presented. CONCLUSION: Multifocal primary neuroblastomas can occur. The tumors maybe synchronous or metachronous. Awareness of this disorder may prevent errors in diagnosis and staging. Although not identified in our patients there is a strong familial incidence of neuroblastomas in those patients with multifocal tumors.