A CMOS multichannel 10-Gb/s transceiver

We describe a CMOS multichannel transceiver that transmits and receives 10 Gb/s per channel over balanced copper media. The transceiver consists of two identical 10-Gb/s modules. Each module operates off a single 1.2-V supply and has a single 5-GHz phase-locked loop to supply a reference clock to two transmitter (Tx) channels and two receiver (Rx) channels. To track the input-signal phase, the Rx channel has a clock recovery unit (CRU), which uses a phase-interpolator-based timing generator and digital loop filter. The CRU can adjust the recovered clock phase with a resolution of 1.56 ps. Two sets of two-channel transceiver units were fabricated in 0.11-/spl mu/m CMOS on a single test chip. The transceiver unit size was 1.6 mm /spl times/ 2.6 mm. The Rx sensitivity was 120-mVp-p differential with a 70-ps phase margin for a common-mode voltage ranging from 0.6 to 1.0 V. The evaluated jitter tolerance curve met the OC-192 specification.     

Oxygen potential measurements of Am0.5Pu0.5O2−x by EMF method

The dependence of the oxygen potentials on oxygen non-stoichiometry and temperature of Am_0.5Pu_0.5O_2−x has been obtained by the electromotive force (EMF) method with the cell: (Pt) air |Zr(Ca)O_2−x| Am_0.5Pu_0.5O_2−x (Pt). The x value of Am_0.5Pu_0.5O_2−x was changed at 1333 K over 0.02 < x ? 0.25 by the coulomb titration method. The temperature dependence of the oxygen potential was also measured over the range of 1173-1333 K. It was found that the oxygen potential decreased from −80 to −360 kJ mol⁻¹ with increasing x from 0.021 to 0.22 at 1333 K and that it remained almost constant at −360 kJmol⁻¹ around x = 0.23. It was concluded that Am_0.5Pu_0.5O_2−x should be composed of the single fluorite-type phase over 0.02 < x ? 0.22 and the mixed phases of fluorite-type and (Am, Pu)₉O₁₆ at around x = 0.23.     

Colloidal gold submonolayer-coated thin-film glass plates for waveguide-coupled surface plasmon resonance sensors

A novel optical sensor based on spectroscopic measurement of the plasmon absorption of a colloidal gold submonolayer immobilized upon a planar waveguide has been developed for label-free detection of biomolecular interactions at the sensor's surface. We fabricated the sensor by locally modifying a 50-microm-thick glass plate with hemoglobin (Hb) and then self-assembling gold colloids from the aqueous solution onto the Hb-modified area of the glass plate. Polychromatic light from a xenon-arc lamp was launched into the thin-film glass plate by use of a broadband fiber-coupling method. With the use of a CCD detector to monitor the light beam emitted from an end face of the glass plate, the plasmon absorption spectrum of the colloidal gold submonolayer was determined to depend on the polarization states of the guided light and to change with the refractive index of the medium in contact with the colloids. In addition to simplicity of fabrication and the ease of use, the sensor yields a larger absorbance sensitivity than the normal transmission measurement.     

Microwave-assisted steam distillation for simple determination of polychlorinated biphenyls and organochlorine pesticides in sediments

A novel sample extraction technique for polychlorinated biphenyls (PCBs) and organochlorine pesticides (OCPs) analysis using microwave-heating device is developed. In this study, microwave-assisted extraction (MAE) and steam distillation techniques were combined. Desorption of the anatytes from solid matrixes was accelerated with water vapor which was generated by microwave irradiation. A sample holder in a commercial microwave extraction cell kept the sample from direct contact with the organic solvent for analytes trapping during the treatment process. Therefore, relatively clean extracts were obtained with small amount of solvents. Without any cleanup steps, the obtained extract could be analyzed with gas chromatograph/mass spectrometers (GC/MS). Six PCB congeners (PCB15, 28, 70, 101, 180, 194, 209) and three OCPs (gamma-HCH, 4,4'-DDE, 4,4'-DDD) in two marine sediment samples (a sediment collected from a bay of Kyusyu Island, Japan, and a certified reference material NIST SRM1944) were analyzed by using this microwave-assisted steam distillation (MASD) technique and another extraction method (exhaustive steam distillation, MAE, and Soxhlet extraction); and comparisons of the results are shown in this report. Although recovery yields of highly chlorinated biphenyls (PCB180, 194, 209) and relatively polar OCPs (gamma-HCH, 4,4'-DDD) were low (30-60%) compared with other analytes (PCB15, 28, 70, 101, 4,4'-DDE; recovery, 80-100%), use of isotope labeled internal standards for the MASD technique gave comparable results with the values obtained by other extraction methods and the certified values in the samples.     

Oxygen Potential Measurement of Americium Oxide by Electromotive Force Method

The oxygen potentials of AmO_{2− x} were measured in the x range of 0.01–0.5 and the temperature range of 1000–1333 K by the electromotive force method. The oxygen potentials at 1333 K were −19.83 kJ/mol for x =0.019 and −319.1 kJ/mol for x =0.485, which were higher than those of CeO_{2− x} by approximately 200 kJ/mol for the corresponding x values. From the dependence of the oxygen potentials on x and temperature, a tentative phase diagram of Am–O system was proposed, which suggested the presence of the intermediate phases of Am₇O₁₂ and Am₉O₁₆ in the Am–O system.     

CHAOTIC BEHAVIOR AND TRANSITION TO TURBULENCE IN POROUS MEDIA

An experimental study has been made of the chaotic behavior in the transition to turbulence of flow through porous media consisting of a bank of tubes in a narrow gap. Judging from the examination of the correlation dimension and the maximum Lyapunov exponents, we can identify the chaotic behavior in porous media for Re > ～60. Rapid increase in the maximum Lyapunov exponents was observed for Re > ～300. Also, the spatial distribution of the Lyapunov exponents is discussed.     

Localization of the gene encoding the alpha subunit of human interleukin-5 receptor (IL5RA) to chromosome region 3p24-3p26

The chromosomal location of the human gene for the alpha subunit of interleukin-5 receptor (IL5RA) has been determined. The human IL5RA gene was localized to the short arm of chromosome 3 by Southern blot analysis of DNA from a panel of mouse-human hybrid somatic cell lines. The IL5RA gene has been further localized to human chromosome region 3p24-3p26 by in situ hybridization of a molecularly cloned IL5RA cDNA fragment to metaphase chromosomes. The results suggest that the IL5RA locus is unlinked to other members of the hematopoietic receptor family. Assignment of the IL5RA gene to chromosome 3 at bands p26-p24 raises the possibility that it may be altered by certain nonrandom chromosomal abnormalities arising in human hematopoietic malignancies and solid tumors.     

Intranuclear mitochondria in human myocardial cells

Dentin phosphoproteins are thought to have a primary role in the deposition of mineral on the collagen of dentin. In this study we determined the type of binding between collagen and phosphoproteins necessary for mineral formation onto collagen fibrils and whether the phosphate esters are required. Bovine dentin phosphophoryn or phosvitin from egg yolk were immobilized on reconstituted skin type I collagen fibrils by adsorption or by covalent cross-linking. In some samples the ester phosphate was removed from the covalently cross-linked phosphoproteins by treatment with acid phosphatase. All samples were incubated at 37 degrees C in metastable solutions that do not spontaneously precipitate. Reconstituted collagen fibrils alone did not induce mineral formation. The phosphoproteins adsorbed to the collagen fibrils desorbed when the mineralization medium was added, and mineral was not induced. The mineral induced by the cross-linked phosphoproteins was apatite, and the crystals were confined to the surface of the collagen fibrils. With decreasing medium saturation the time required for mineral induction increased. The interfacial tensions calculated for apatite formation by either phosphoprotein cross-linked to collagen were about the same as that for phosphatidic acid liposomes and hydroxyapatite. This similarity in values indicates that the nucleation potential of these highly phosphorylated surfaces is about the same. It is concluded that phosphoproteins must be irreversibly bound to collagen fibrils for the mineralization of the collagen network in solutions that do not spontaneously precipitate. The phosphate esters of phosphoproteins are required for mineral induction, and the carboxylate groups are not sufficient.