Tunable laser for sensing atmospheric transmission in the infrared region of 11 ∼ 16 µm

We succeeded in observing the continuously tunable, pulsed InSb SFR (Spin-Flip Raman) laser emission in the infrared region of 11～16µm (11.4～16.3µm) from only one InSb device, merely by adjusting the pumping wavelength (11 lines from the infrared NH₃ laser) and the applied magnetic field (0～80 kGauss).     

A sensorless brushless dc motor system

This paper describes a brushless dc motor system without position or speed sensor. The brushless motor consists of a permanent magnet synchronous motor and a voltage-source inverter capable of controlling the amplitude and frequency of voltage. The rectangular-shaped stator current with a conducting interval of 120° (electrical) is controlled to be in phase with the trapezoidal back electromotive force. This results in producing maximum torque. Variable speed is achieved by adjusting the average motor voltage similarly to chopper control of dc motors. In this paper, two sensorless position detecting methods, i.e., an “indirect method” suited for the lower-speed range and a “direct method” suited for the higher-speed range are proposed. The combination of the two makes it possible to detect the rotor position over a wide-speed range. Furthermore, a speed-sen-sorless PLL control is proposed in applying the principle of the direct method. Experimental results obtained from a prototype brushless dc motor are shown to confirm the validity of the sensorless drive. The starting procedure of the motor also is discussed because it is impossible to detect the rotor position at a standstill.     

Transient analysis of an advanced static var compensator using quad-series voltage-source PAM inverters

This paper deals with an advanced static Var compensator (ASVC) using quad-series voltage-source PAM inverters. The ASVC consists of four three-phase voltage-source inverters with a common dc capacitor and four three-phase transformers, each primary winding of which is connected in series with each other. Each inverter outputs a square-wave voltage, while the synthesized output voltage of the ASVC has a 24-step wave shape. This results not only in a great reduction of harmonic currents and dc voltage ripples but also in fewer switching and snubbing losses. In this paper, transient analysis is performed with the focus on the response of reactive power and the resonance between the dc capacitor and ac reactors. Experimental results obtained from a small-rated laboratory model of 10 kVA are also shown to verify analytical results based on the p-q transformation. The analytical results help in the design of system parameters such as the capacity of the dc capacitor and feedback gains.     

DNA-inorganic hybrid material as selective absorbent for harmful compounds

Double-stranded DNA is one of functional polymers, but the large amounts of DNA sources, such as salmon milt and shellfish gonads, have been discarded as industrial wastes. Therefore, conversion of this discarded DNA to be a useful material would be beneficial to utilize the unique property of DNA. These materials including DNA have been prepared by mixing with the organic polymers, such as alginic acid, collagen, and chitosan. However, since these materials have consisted from entirely organic components, these do not have the mechanical strength for a material. So, we prepared the organic-inorganic hybrid materials by mixing DNA with silane coupling reagents bis(trimethoxysilylpropyl)amine or bis[(3-trimethoxysilyl)propyl]ethylenediamine. These hybrid materials with the flexibility were water-insoluble and resistant to hydrolysis by nuclease. In addition, the mechanical strength of this hybrid material was approximately twice as high as that of DNA without mixing with silane coupling reagents. Furthermore, the double-stranded DNA in the hybrid materials has been maintained in a B-form structure in aqueous solution. Thus, we demonstrated the utilization of DNA as a functional material. As a result, this material could selectively accumulate harmful DNA-intercalating compounds with the planar structure, such as dibenzo-p-dioxin, dibenzofuran, and ethidium bromide. Organic-inorganic hybrid material including double-stranded DNA has potential to serve as a useful biomaterial for medical, engineering, and environmental applications.     

Quantitative trait loci affecting 4-nitroquinoline 1-oxide-induced tongue carcinogenesis in the rat

The incidence of tongue carcinomas (TCs) induced by oral administration of 4-nitroquinoline 1-oxide in rats is strain dependent. The inbred Dark-Agouti (DA) strain showed a much higher susceptibility to large mass-forming infiltrative TCs than did the Wistar-Furth (WF) strain. Our previous study (M. Kitano et al, Jpn. J. Cancer Res., 87: 1097-1101, 1996) on crosses between these two strains postulated a dominant susceptibility gene in DA and a dominant resistance gene in WF rats. The present study mapped these loci by analyzing the backcrosses to each parent with simple sequence repeat polymorphisms. Five quantitative parameters were analyzed: (a) the number of TCs > 5 mm in diameter; (b) the total number of TCs per rat; (c) the diameter of the largest TCs (DTCmax values); (d) the number of non-TC cancers per rat; and (e) and the number of cancers of any site per rat. All of these parameters were closely correlated (P < 0.0001). DA rats had a semidominant gene (Stc1) favoring the development of 4-nitroquinoline 1-oxide-induced cancers on chromosome 19, closely linked to D19Mit9. Peak linkage was observed 4 cM distal from D19Mit9, with a logarithm of the odds (lod) score of 5.72 for the number of large TCs and 6.08 for the DTCmax. On the other hand, WF rats had a semidominant gene (Rtc1) mapped between D1Mit1 and D1Mit3, approximately 20 cM from D1Mit1, with a peak lod score of 3.30 for both the number of large TCs and the DTCmax. The main effect of Rtc1 seemed to be to reduce the size of the TCs. The action of these genes was dose dependent and cooperative. The final incidence of TC in DA, WF, F1, and backcross rats seemed to be explained by combinations of genotype at these two loci. Possible candidate genes for Stc1 and Rtc1 are discussed.     

The effect of gas atmospheres on resistivity of indium tin oxide films at high temperature

The effects of heat treatment in Q₂, O₂ and N₂, and Ar gases on the high temperature (500 C) electrical resistivity of indium tin oxide (ITO) film 52 nm thick prepared by chemical spray pyrolysis method were studied. The partial oxygen pressure effect on the resistivity was found to be to . The resistivity changes for cyclic exchange of O₂ by Ar gas at 500 C. These lead to the conclusion that chemisorption of oxygen atoms in the film surface is dominant for this thin film, for thicker films such as 640 nm oxygen diffusion is found to occur. The Langmuir model of the monolayer isothermal adsorption of oxygen atoms in the surface is applicable to the rapid change of resistivity.     

Alteration of substrate specificity of cholesterol oxidase from Streptomyces sp. by site-directed mutagenesis

Despite the structural similarities between cholesterol oxidasefrom Streptomyces and that from Brevibacterium, both enzymesexhibit different characteristics, such as catalytic activity,optimum pH and temperature. In attempts to define the molecularbasis of differences in catalytic activity or stability, substitutionsat six amino acid residues were introduced into cholesteroloxidase using site-directed mutagenesis of its gene. The aminoacid substitutions chosen were based on structural comparisonsof cholesterol oxidases from Streptomyces and Brevibacterium.Seven mutant enzymes were constructed with the following aminoacid substitutions: L117P, L119A, L119F, V145Q, Q286R, P357Nand S379T. All the mutant enzymes exhibited activity with theexception of that with the L117P mutation. The resulting V145Qmutant enzyme has low activities for all substrates examinedand the S379T mutant enzyme showed markedly altered substratespecificity compared with the wild-type enzyme. To evaluatethe role of V145 and S379 residues in the reaction, mutantswith two additional substitutions in V145 and four in S379 wereconstructed. The mutant enzymes created by the replacement ofV145 by Asp and Glu had much lower catalytic efficiency forcholesterol and pregnenolone as substrates than the wild-typeenzyme. From previous studies and this study, the V145 residueseems to be important for the stability and substrate bindingof the cholesterol oxidase. In contrast, the catalytic efficiencies(k_cat/K_m) of the S379T mutant enzyme for cholesterol and pregnenolonewere 1.8- and 6.0-fold higher, respectively, than those of thewild-type enzyme. The enhanced catalytic efficiency of the S379Tmutant enzyme for pregnenolone was due to a slightly high k_catvalue and a low K_m value. These findings will provide severalideas for the design of more powerful enzymes that can be appliedto clinical determination of serum cholesterol levels and assterol probes.