海面油膜的偏振反射特性仿真实验

为了给海面溢油污染识别检测提供理论基础,根据菲涅尔反射公式的偏振反射系数,结合偏振双向反射率因子和粗糙海面的概率密度分布函数,建立了完善的pBRDF模型,仿真在不同太阳入射角度、不同探测器观测角度以及不同海面风速风向等条件下海水和油膜的偏振反射分布函数。结果表明:海水和油膜太阳天顶角为53°和56°时P偏振反射率分别为1.0×10^-5和2.5×10^-5,S偏振反射率随着太阳天顶角的增加而增加;海面风速越大偏振反射率峰值越小;海面风向只改变pBRDF的空间位置;海水和油膜线偏振度空间分布有明显差异。搭建实验平台相机以40°拍摄时,得出海水和油膜的线偏振度分别在0.2~0.4, 0.5~0.7之间,同时表明利用偏振探测获取目标场景的偏振度和偏振角图可提高图像质量。     

起重搬运作业的安全风险分析

用安全系统的理论和方法 ,以起重作业为研究对象 ,通过危险识别 ,对造成人员损伤的危险事件发生的可能性和导致伤害后果的严重程度 ,进行了定性的风险分析 ,介绍了我国采取的针对性综合管理对策     

Quantification of trace amounts of impurities in high purity cobalt by high resolution inductively coupled plasma mass spectrometry

An analytical method using high resolution inductively coupled plasma mass spectrometry (HR-ICP-MS) for rapid simultaneous determination of 24 elements (Be, Mg, Al, Ti, V, Cr, Mn, Fe, Ni, Cu, Zn, Ga, Ge, As, Se, Mo, Ag, Cd, Sn, Sb, Ba, Pt, Au, and Pb) in high purity cobalt was described. Sample digestions were performed in closed microwave vessels using HNO3 and HCl. The matrix effects because of the presence of excess HCl and Co were evaluated. The usefulness of high mass resolution for overcoming some spectral interference was demonstrated. The optimum conditions for the deter- mination were tested and discussed. The standard addition method was employed for quantitative analysis. The detection limits were 0.016-1.50 μg?g?1, the recovery ratios were 92.2%-111.2%, and the RSD was less than 3.6%. The method was accurate, quick, and convenient. It was applied to the determination of trace impurities in high purity cobalt with satisfactory results.     

ICP-MS法测定陶瓷容器中重金属元素的研究

采用电感耦合等离子体—质谱(ICP—MS)法同时测定了陶瓷容器中重金属元素PB、CA、Cr、Ni，对影响其测量的各种因素进行了较为详细的研究，确定了实验的最佳测定条件。结果表明，方法的检出限为0．002—0．008μg/L，回收率为90．0％-110．0％，RSD小于9．21％。该法准确、快速、简便，应用于陶瓷容器中重金属元素的测定，结果满意。     

水泥中硫的高频红外分析方法研究

采用高频红外吸收法测定了水泥中硫的含量,并对样品作测定前的预处理(物理处理),在测定中选用复合型助熔剂,解决了高频感应炉中因顶吹氧气流的作用而导致的样品喷溅问题。该法可准确测定水泥中0.001％～5％的硫,回收率为98.6％～102.5％,RSD为0.78％～1.35％。     

Preparation of porous poly(lactic acid)/Sio2 hybrid microspheres

With 3‐aminopropyltriethoxysilane (APTES) as coupling agent, poly(lactic acid) (PLA)/SiO₂ hybrid material was prepared to produce poly(lactic acid)/SiO₂ hybrid microspheres (PLAHs) with porous structure bythe oil‐in‐water, single‐emulsion solvent evaporation method. Field scanning electron microscopy results show that the PLAHs were porous microspheres about 20 μm in diameter. The holes in the PLAHs opened outside and were not complicated. A nitrogen adsorption–desorption experiment showed that the nitrogen adsorbed in the holes was easily desorbed, and the specific surface area of the PLAHs was calculated to be 6.87 m²/g according to the Brunauer–Emmett–Teller equation. Fourier transform infrared spectroscopy results show that PLA was amidated with APTES successfully and formed a kind of organic–inorganic hybrid material by hydrolysis and con‐condensation with tetraethoxysilane. Moreover, the molecular structure of the hybrid material was confirmed by X‐ray photoelectron spectroscopy. Differential scanning calorimetry results show that the melting point ofthe PLAHs was higher than that of PLA by about 11.2°C. These PLAHs may be used in the controlled release of drugs by the embedding of the drugs in the holes of the PLAHs, and the drug loading amount can be controlled by the size and number of holes in the PLAHs. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 102: 679–683, 2006     

高水平研究型大学学科综合性建设的路径探析——以重庆大学为例

把重庆大学建设成为一所综合性的世界高水平研究型大学,既有历史积淀的因素,更是国内外经济社会、科技教育发展的必然要求。阐述了重庆大学学科综合性建设的历史与现实背景,回顾了重庆大学学科综合性的发展历程。根据综合性大学的内涵界定与特征表现,梳理了重庆大学学科综合性建设的制约因素,提出了“既追求‘综合性’,又必须表现出自身的差异性,强化办学特色”的学科综合性建设思路和基本路径。     

Preparation and characterization of nano-hydroxy apatite/konjac glucomannan composite scaffolds

A novel nano-hydroxyapatite (HA)/konjac glucomannan composite scaffold with high porosity was developed by blending nano-HA particles with konjac glucomannan in alkaline solution. The scanning electron microscopy, porosity measurement, X-ray diffraction(XRD), and Fourier transformed infrared(FTIR) spectroscopy were used to analyze the physical and chemical properties of the composite scaffolds. The pure konjac glucomannan scaffolds and composite scaffolds were similar in their macroscopic morphology, however, the microscopic morphology on porewall surfaces was quite different. The diffraction patterns of XRD revealed the presence of konjac glucomannan and HA in the composite scaffolds. In addition, the results of FTIR also showed the existence of the functional group of HA. These results reveal that the newly developed nano-HA/konjac glucomannan composite scaffold may serve as a good three-dimensional substrate in bone tissue engineering.     

高频熔样-ICP-AES法测定陶瓷中多元素的研究

采用高频熔样，电感耦合等离子体原子发射光谱(ICP-AES)法实现了对陶瓷中的Mg、Ca、Fe、Ti和Zr的同时测定。对影响其光谱测量的各种因素进行了较为详细的研究，确定了实验的最佳测定条件。结果表明，方法的检出限为0.008—0．255μg／ml，回收率为95．14—107．72％，RSD小于3．40％。该法准确、快速、简便，应用于陶瓷的测定，结果满意。     

Improving the cold flow properties of biodiesel from waste cooking oil by ternary blending with bio-based alcohols and diesel from direct coal liquefaction

The utilization and popularization of biodiesel are always limited by its poor cold flow properties. Both bio-based alcohol and diesel from direct coal liquefaction (DDCL) has potential to enhance the cold flow properties of biodiesel. In this study, ternary blends of waste cooking oil biodiesel (BWCO) with DDCL and bio-based ethanol (ET) or 1-butanol (BT) were conducted to improve the cold flow properties of biodiesel. The pour point (PP), cold filter plugging point (CFPP), and cloud point (CP) of BWCO-ET, BWCO-BT, and BWCO-DDCL binary blends, and BWCO-ET-DDCL and BWCO-BT-DDCL ternary blends were comparatively assessed. Ternary phase diagrams were also applied to analyze the blending effect of the three components on the cold flow properties of biodiesel. Results showed that both DDCL, ET, and BT can remarkably enhance the cold flow properties of BWCO. When the ternary blends contain 20 vol.% BWCO and less than 40 vol.% ET or BT, DDCL together with ET or BT exerted positive effects on enhancing the low-temperature flow properties of BWCO, especially on the CP and CFPP. For ternary blends in 20:10:70 blending ratio, BWCO-BT-DDCL exhibited the lowest PP, CFPP, and CP of −23, −19, and −17°C, respectively. The crystallization behavior and crystal morphology of blended fuels are also observed via a polarizing optical microscope, and find that DDCL together with BT in biodiesel can effectively retard the aggregation of large crystals and inhibit crystals growth.