燃煤锅炉除尘专用滤料的开发

介绍机械制造厂燃煤锅炉的烟尘特点,分析滤料失效的原因,提出一套针对该工况的滤料解决方案。介绍针对复杂工况条件所选用的纤维种类以及复合面层原料成分配比的确定,最终选用针刺工艺加工并对该新产品的基本性能进行了测试分析。     

Structural health analysis on cyber physical system based on reliability

The Journal of Supercomputing - Cyber physical system (CPS) is consisting of two interdependent networks, i.e., a cyber network embedding into a physical network. Although interdependence makes the...     

Preparation and characterization of Fe‐Tetranitro phthalocyanine/polyurethane blends

In this article, Fe‐Tetranitro phthalocyanine (Fe‐TNPc)/polyurethane (PU) blends were prepared by solution blending. The mechanical properties of the samples were studied by tensile tests. The results showed that the tensile strength and the elongation at break of the samples increased with increasing Fe‐TNPc content. The improved mechanical properties for the samples containing Fe‐TNPc was attributed to the increased microphase separation degree of PU, which was further investigated by dynamic mechanical analysis (DMA) and Fourier transform infrared analysis. The lower T_g of the soft segments and the higher T_g of the hard segments for the samples containing Fe‐TNPc indicated an increase of microphase separation degree of PU. The increased hydrogen bonded carbonyl groups in the samples with increasing Fe‐TNPc content also proved the conclusion. Quantitative evaluation of the interaction between Fe‐TNPc and PU was also investigated by analyzing the physical crosslinking density of the samples. The results indicated that the physical crosslinking density of the samples increased with increasing Fe‐TNPc content. The antibacterial properties of the samples were investigated. The results showed that the percentage bacterial inactivation toward S. aureus and E. coli of the samples were 98.9% and 90.9%, respectively, when Fe‐TNPc was added to 1%. © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015 , 132, 41284.     

小像元红外探测器读出电路设计研究

介绍了基于SMIC 0.18 μm 3.3 V工艺设计研究的第一款小像元红外探测器读出电路,间距10 μm,规模1024×1024。文章详细介绍了像素输入级以及列级、输出级运放的设计,为提高线性摆伏,设计选用了低阈值NMOS管nmvt 33,仿真分析证明低阈值管nmvt 33的噪声性能优于普通管n 33；版图设计对关键信号线和敏感点采取隔离处理措施,对像元间串扰进行了仿真分析,有效控制了信号串扰。电路经测试使用各项功能正常,最大电荷处理能力达到4.3 Me-,动态范围≥65 dB,读出速率达到10 MHz,性能指标满足设计要求。     

Pretreatment of Highly Polluted Pharmaceutical Waste Broth by Wet Air Oxidation

The preoxidation of a highly polluted waste pharmaceutical fermentation broth using wet air oxidation (WAO) has been studied as a possible method for the effective removal of organics. The applied (pre)treatment method should enhance the biotreatability of the pharmaceutical fermentation broth in terms of reduced initial toxicity and higher biodegradability. Preliminary experiments in the pilot biological treatment plant were successful only at low organic loads, whereas the system collapses at higher ones. The characterization of the fermentation broth was started by common physicochemical analysis, whereas several bioassays were used to determine its impact on biological treatment plants and the environment. Toxicity prior to and after WAO was determined using the acute Vibrio fischeri test, measurement of inhibition of O2 consumption, and the Daphnia magna acute test. Ready biodegradability of the treated and untreated broth has also been assessed. WAO experiments were accomplished in the 2?L batch reactor at different temperatures (240/280°C) and operating pressures. WAO experiments confirmed reduction of the toxicity toward microorganisms, whereas oxidized wastewater was more toxic to daphnids. Biodegradability of the oxidized broth has also been enhanced. Further work has been focused on designing appropriate combination of WAO and biological processes.     

GS-08乙苯脱氢催化剂在广石化的应用

乙苯脱氢催化剂GS-08催化剂在广州石化总研制的首次应用。     

Compressive deformation of semi-solid SiC_p/ZA27 composites

1　INTRODUCTIONTheapplicationofcastingSiCp/ZA2 7compositesisgreatlylimitedduetotheinhomogeneousdistribu tionofSiCpandtheporosityexistedinthematrix[1] .However,semi solidformingtechnology (SSF )e mergedintherecentyearscannotonlydecreaseore liminatetheporosityandenhancethecompactnessofthematrix ,butalsoimprovetheuniformdistributionofthereinforcementthroughtheredistributionofthereinforcementfromitsuniquecharacteristicsofmouldfilling[2 ] .Inaddition ,SSFisanearnet shapeform ingtechnology …     

无线移动自组网络的动态源路由策略

文章介绍无线移动自组网中动态源路由策略的路由发现和路由维护,并提出改进思路和今后研究的方向。     

邕宁闸坝混凝土施工温控方案研究

为了探究邕宁闸坝混凝土施工温控方案,以该工程12^#溢流闸坝为研究对象,建立三维有限元模型进行仿真计算,分析混凝土在3种施工方案下的温度场和温度应力。研究表明：低温季节采用方案1进行施工时,施工过程中温度场与温度应力均满足规范要求;高温季节采用方案2进行施工时,施工过程中最高温度与最大温度应力值均不满足规范要求;高温季节采用方案3进行施工时,施工过程中最高温度与最大应力值均满足规范要求。建议低温季节浇筑时采用自然入仓的浇筑方式;高温季节浇筑时,应控制底板混凝土浇筑温度不超过14 ℃,闸墩混凝土浇筑温度不超过16 ℃,同时采取通水冷却措施。计算结果可为邕宁闸坝及类似工程施工方案设计提供参考。     

某电动汽车三换热器热泵空调系统设计

本文分析了一种三换热器热泵空调系统的工作原理,基于公司某款纯电动汽车,设计了三换热器热泵空调系统。详细说明了系统的车内制冷、电池制冷、车内制热的工作过程、系统性能计算、12种工作模式切换策略、系统舒适性标定及节能效果。