基于状态空间法的电动机故障诊断和识别

电动机的初期故障信号一般较弱,不易辨别,而状态空间法在小信号的处理中灵敏度很高。为达到对电动机故障的诊断和识别,试图把状态空间法应用到对电动机的故障诊断中,先通过推导,从数学理论层面分析了状态空间法对于电动机故障信号的可辨别性,再使用Matlab软件搭建状态空间的辨别模型,把实验台测试的三组数据导入到模型中进行测试。测试的结果有力地证明了此方法的可行性,并能克服快速傅里叶变换(FFT)中数据采集量较大、分辨率不高的缺点。     

长江九江河段河势演变及治理探讨

对九江河段历史的和近期的演变分析表明,该河段由于受来水来沙及上游河势变化的影响,深泓有一定的摆动幅度,由此引起潜洲、边滩、浅滩出现相应的冲淤变化,以致影响船舶停靠和通航.对该河段进行治理,一方面可通过挖泥疏浚来缓解目前的矛盾;另一方面,从长运考虑应实施综合治理工程来彻底根治目前九江河段存在的问题.     

沁水盆地北端煤层气储层特征及富集机制

煤层气的富集与储层特征密切相关,并受地质条件的制约。在详细研究煤储层特征及煤层气富集机制的基础上,对沁水盆地北端煤层气的开发前景进行了初步评价。煤岩、煤质、煤体结构及孔渗性、吸附性的观察和测试显示,该区煤层厚度大,热演化程度高,局部发育构造煤,裂隙较发育,吸附性能力强,含气量高,含气饱和度偏低,适合煤层气的开发。该区煤层气的富集主要受控于热演化史和埋藏史。在区域变质的背景上,叠加了岩浆热变质作用,生气强度大。另外,煤层的埋深、顶底板封闭性及水文地质条件都会影响煤层含气量的大小,煤层气富集是多因素有效配置的结果。      

低渗透油藏生产井关井测压时间的计算与应用

低渗透油藏的生产井压裂后，在单井试油试采过程中，压力恢复测试关井时间不同，其中有些井压力恢复曲线不能出现边界反应段，渗流不能反映地层中真实流动特征。针对这种情况，基于长庆绥靖油田塞39井区长：低渗透油藏大量试井和实际生产资料，利用现代试井解释理论，研究合理关井时间的界限及其计算方法。结果表明，当油井关井测压时间达到3倍地层径向流开始出现的时间后，利用此时的压力数据解释地层参数和地层压力，其结果的误差小于5％，同时能较准确地判断边界类型。计算的理论曲线和霍纳法解释值非常接近，对于塞39井区，若预先知道某生产井地层有效渗透率值，可从理论曲线查出压力恢复试井的关井时间，否则，建议按照该井区地层有效渗透率（大约在6mD左右），将不稳定试井测试时间控制在25d以上为宜。图4表3参14     

复杂深井尾管固井及回接技术实践

尾管悬挂固井是一种工程经济效益较高、注水泥环空阻力较低且有利于改善套管柱轴向设计和再钻进水力条件的固井方法，常常应用于深井超深井的固井作业。鄯科1井是一口科学探索井，完井尾管具有井径极不规则（实测井径扩大率最大为139.82%，最小为－6.02%）、施工压力高（15~20 MPa）、封固段长（考虑水泥余量的情况下封固段可长达1500 m）和尾管回接固井要求封固两头且不使用分级注水泥等难点。文章针对固井难点，总结出一套适用于复杂深井尾管及其回接固井的优化设计关键技术，它主要包括管串选择、套管扶正器加法、水泥浆体系优选、施工压力校核和配套工艺措施。实践证明，这些技术对类似井的固井作业具有实际的参考价值。     

Transient aspects of inner wall temperatures at different spatial positions in fluidized bed evaporators

In this work, the instantaneous data of inner wall temperatures obtained at given axial positions but for different heated tubes or at various axial positions but at the same heated tube in a tube-bank fluidized bed evaporator with a vapor–liquid–solid external natural circulation flow were analyzed by employing linear and nonlinear time series analysis methods, including correlation dimension and Kolmogorov entropy analyses besides time domain, power spectrum and autocorrelation analyses. It is found that nonlinear characteristics of the wall temperature time series vary with spatial position in the evaporator at given operation conditions, and thus the multi-phase flow boiling behavior. However, the signals obtained at given axial position but different heated tubes in the evaporator exhibit more similar nonlinear evolution behavior, and those measured in the same heated tube but at different axial heights in the evaporator undergo more distinct nonlinear dynamic behavior. Multi-scale phenomena in different spatial positions are also found and discussed. These transient aspects of inner wall temperatures are closely related to the average holdup of solid particles and motion of vapor bubbles in vapor–liquid–solid flow. These results can provide some valuable information on the system modeling and controlling from the point of view of nonlinearity.     

Effects of chemical and plasma surface treatments on the O2-annealed Ni/Au contact to p-Gan

The effects of boiling Aqua Regia (AQ), N₂/Cl₂ plasma followed by AQ and O₂ plasma followed by AQ surface treatments prior to Ni/Au (20 nm/20 nm) metallization to p-GaN:Mg (∼ 3 × 10¹⁷ cm^− 3) have been investigated. N₂/Cl₂ plasma was employed in a bid to lower the Ga/N and O/Ga ratios of the GaN surface to improve the contact properties to p-GaN, while O₂ plasma was employed as an alternative to incorporate O into the Ni/Au system. Results show that a low Ga/N ratio does not necessarily correspond to a better contact. The positive effect of O₂ over N₂ anneal is observed only for the AQ-treated sample, although the mechanisms responsible for its positive effect: NiO formation and Ni/Au layer-reversal were observed for all O₂-annealed contacts. We conclude that the effect of O₂ anneal on the Ni/Au contact is dependant on the p-GaN surface prior to metallization.     

电流变体特性及电流变体应用器件的进展

本文详细评述了电流变体(ERF)材料的组成、工作机理及其流变力学性能,提出以Bingham塑性体来近似描述电流变体的流变特性,综述了电流变体在智能材料、汽车离合器、液压阀门等器件中的应用,给出了含电流变体的双层智能复合材料梁单层、双层加电状态对其振动特性的影响,设计了含电流变体的主动控制式减振器,并对其在外加电场作用下的减振性能进行了评价。