Cyclamate intake and cyclohexylamine excretion are not related to male fertility in humans

Cyclamate and its metabolite cyclohexylamine affect male fertility in high dose animal studies, but this affect has not been investigated in epidemiological studies. This paper reports the first epidemiological study designed to investigate the possibility of a relationship between cyclamate and cyclohexylamine and male fertility in humans, in which 405 cases of clinically defined infertility in men and 379 controls were surveyed. Semen evaluation, urine analysis for cyclamate and cyclohexylamine and dietary questionnaires were compared between cases and controls. No evidence was found of a significant association between cyclamate intake and male infertility; neither high cyclamate nor high cyclohexylamine excretion were associated with elevated risk. The lack of association remained after adjusting by age, area of residence, education, total energy intake and other variables. No significant correlations were observed between cyclamate intake, metabolism or excretion, and sperm count and motility. The results demonstrate no effect of cyclamate or cyclohexylamine on male fertility at the present levels of cyclamate consumption.     

Exploring the possibilities of using Brazilian subbituminous coals for blast furnace pulverized fuel injection

The current study investigates the combustion and blast furnace injection performance of three Brazilian subbituminous coals (Mina do Recreio) and their beneficiation products using laboratory scale combustion tests. The coals have relative high ash yields (up to 40 wt%) that were reduced stepwise to levels as low as 12 wt%, dry basis. The reduction of ash yields is paralleled by a significant decrease in sulphur and inertinite contents.The combustion tests were performed in a drop tube reactor operating at 1300 °C using two different atmospheres (2.5 and 5% O₂). The chars exhibited preferentially rounded shapes with thick walls and abundant secondary porosity for the 2.5% O₂ chars, whereas the 5% O₂ chars showed very thin walls as a consequence of extensive burnout. The intrinsic reactivities of both set of chars were similar. The differences in conversion between the two working atmospheres were 24-37% and roughly tend to increase with increasing mineral matter content. Conversions as high as 76-81% were reached operating under 5% O₂ indicating that the coals are easy to burn. The small differences in burnout among the coals and their beneficiation products cannot be clearly attributed neither to mineral matter or inertinite content. A rough inverse relationship was found between the intrinsic reactivity of the chars and the inertinite content of the parent coal indicating that the char material derived from inertinite was intrinsically less reactive than that derived from vitrinite. These differences were no longer relevant at high temperature.Blast furnace injection performance was studied through thermobalance experiments using CO₂ atmosphere and 1050 °C temperature. It is apparent that the beneficiation process has no effect on the reactivity of the coals from Recreio Mine. The only exception is the low ash coal-2-LabB (11.5 wt%), for which a higher reactivity is indicated. The reactivity tests show also that the coals have adequate properties to be used together with imported coal blends in pulverized coal injection in the blast furnace (PCI).     

Understanding reductions in water consumption in tourist areas: a case study of the Costa Brava,Spain

With nearly three million tourists per year, the Costa Brava (Spain) is one of the most frequently visited tourist areas on the Mediterranean coast. The aim of this article is to understand its hydrosocial cycle and to identify why water consumption per capita is decreasing in the region. Overall, this decrease is not related to a single factor. Instead, many factors, including the incorporation of technological and institutional innovations in water management, increasing levels of social awareness related to saving water, the introduction of alternative water resources, and increasing water prices, must be considered together.     

Influence of Copper Layer Content in the Elastic and Damping Behavior of Glass-Fiber/Epoxy-Resin Composites

The impact in the elastic behavior and internal friction, caused by the introduction of Copper layers in Glass-Fiber/Epoxy Resin composites and temperature effects, were studied and evaluated recurring to Dynamic Mechanical Analysis. It is shown that the introduction of Copper layers increases the storage modulus of the composites and delays their glass transition temperature, however, it allows a faster transformation. Additionally, it is concluded that the introduction of Copper layers elevates the internal friction during the glass transition phase by the inversion of the deformation mechanism due to thermal expansion and increase in the Poisson’s ratio of the epoxy resin to a value near 0.5 where its deformation is approximately isochoric. This increase in damping capacity is relevant in application with cyclic fatigue and mechanical vibration.     

A new multi-objective optimization method for master production scheduling problems using simulated annealing

Tactic planning or master production scheduling focuses on time and spatial decomposition of the aggregate planning targets and forecasts, as well as, forecast and provision of needed resources. This process becomes extremely hard and time consuming with the increase of number of products, resources and periods considered. In face of such obstacles, this work shows a study of an Artificial Intelligence technique called Simulated Annealing applied to the optimization of production planning problem, more specifically, Master Production Scheduling. This work reviews some of the fundamental theory of simulated annealing, the methodology for master production scheduling calculation, the applicability of simulating annealing to planning problems, most important results and suggestions for further studies.     

Effect of fermentation temperature on microbial population evolution using culture-independent and dependent techniques

The population dynamics of micro-organisms during grape-must fermentation has been thoroughly studied. However, the main approach has relied on microbiological methods based on plating. This approach may overlook micro-organisms that (i) grow slowly or do not grow well on artificial media or (ii) whose population size is small enough to be detected by regular sampling. Culture-independent methods have been used and compared with the traditional plating method during wine fermentations performed at two different temperatures (13 °C and 25 °C). These methods include a qualitative technique, the DGGE; a semi-quantitative technique, the direct cloning of amplified DNA; and a quantitative technique, the QPCR. The biodiversity observed in the must and at the beginning of fermentation was much higher when DGGE or direct cloning were used. Quantification of the most frequent non-Saccharomyces yeast, Hanseniaspora uvarum and Candida zemplinina, showed that they survived throughout the fermentation process and, specifically, it revealed the quantitatively relevant presence of C. zemplinina until the end of fermentation.     

Evaluation of high-frequency sinusoidal waveform superposed with third harmonic for stable operation of metal halide lamps

In this paper, a novel topology to supply metal halide (MH) lamps using sinusoidal waveform with superposed third harmonic is proposed. By employing this technique, the lamp is supplied with an approximated square waveform, but it reduces the harmonic content and, therefore, electromagnetic interference and radio-frequency interference. The proposed topology is analyzed and designed for a 35-W MH lamp with ceramic discharge tube. Experimental results prove that lamp operation is stable at operating frequencies where acoustic resonances were previously observed when supplied with purely sinusoidal waveforms. In conclusion, the proposed technique could be a feasible solution for stable operation of MH lamps.     

Feasibility of LC/TOFMS and elemental database searching as a spectral library for pesticides in food

Traditionally, the screening of unknown pesticides in food has been accomplished by GC/MS methods using conventional library-searching routines. However, many of the new polar and thermally labile pesticides are more readily and easily analysed by LC/MS methods and no searchable libraries currently exist (with the exception of some user libraries, which are limited). Therefore, there is a need for LC/MS libraries that can detect pesticides and their degradation products. This paper reports an identification scheme using a combination of LC/MS time-of-flight (accurate mass) and an Access database of 350 pesticides that are amenable to positive ion electrospray. The approach differs from conventional library searching of fragment ions. The concept consists of three parts: (1) initial screening of possible pesticides in actual market-place fruit extracts (apple and orange) using accurate mass and generating an accurate mass via an automatic ion-extraction routine, (2) searching the Access database manually for screening identification of a pesticide, and (3) identification of the suspected compound by accurate mass of at least one fragment ion and comparison of retention time with an actual standard. Imazalil and iprodione were identified in apples and thiabendazole in oranges using this database approach.