A new Pd-oxide-Al/sub 0.3/Ga/sub 0.7/As MOS hydrogen sensor

A new and interesting Pd-oxide-Al/sub 0.3/Ga/sub 0.7/As MOS hydrogen sensor has been fabricated and studied. The steady-state and transient responses with different hydrogen concentrations has been measured at various temperatures. Based on the large Schottky barrier height and presence of oxide layer, the studied device exhibits a high hydrogen detection sensitivity and wide temperature operating regime. The studied device exhibits the low-leakage current and obvious current changes when exposed to hydrogen-contained gas. Even at room temperature, a very high hydrogen detection sensitivity of 155.9 is obtained when a 9090 ppm H/sub 2//air gas is introduced. Furthermore, when exposed to hydrogen-contained gas at 95/spl deg/C, both the forward and reverse currents are substantially increased with increased hydrogen concentration. In other words, the studied device can be used as a hydrogen sensor under the applied bidirectional bias. Under the applied voltage of 0.35 V and 9090 ppm H/sub 2//air hydrogen ambient, a fast adsorption response time about 10 s is found. The transient and steady-state characteristics of hydrogen adsorption are also investigated.     

A novel InP/InGaAs TEBT for ultralow current operations

A novel InP/InGaAs tunneling emitter bipolar transistor (TEBT) is fabricated and demonstrated. The studied device exhibits a very small collector-emitter offset voltage of 40 mV and an extremely wide operation regime. The operation region is larger than 11 decades in magnitude of collector current (10/sup -12/ to 10/sup -1/A). A current gain of 3 is obtained even if the device is operated at an ultralow collector current of 3.9 /spl times/ 10/sup -12/A (1.56 /spl times/ 10/sup -7/A/cm/sup 2/). Furthermore, the common-emitter breakdown voltage of the studied device is higher than 2 V. Consequently, the studied device shows a promise for low supply voltage, and low-power consumption circuit applications.     

为国家重点建设项目服务打造有公信力的名牌监理公司

中咨工程建设监理公司是中国国际工程咨询公司的全资子公司。而其母公司早在80年代即承担起多个工程项目的施工监理。进入90年代，中咨监理业务得到迅速发展，成为中国监理行业的一支重要力量。2001年起经过整合重组而成中咨工程建设监理公司后，以集中和优化资源配置，努力打造有公信力的名牌监理公司。经过多年的探索和积累，该公司形成了一套既符合国家规范，又具有自身特色的管理模式。本文介绍该公司在承担国家重点建设项目工程监理方面的一些经验和做法。     

Hidden-Action in Network Routing

In communication networks, such as the Internet or mobile ad-hoc networks, the actions taken by intermediate nodes or links are typically hidden from the communicating endpoints; all the endpoints can observe is whether or not the end-to-end transmission was successful. Therefore, in the absence of incentives to the contrary, rational (i.e., selfish) intermediaries may choose to forward messages at a low priority or simply not forward messages at all. Using a principal-agent model, we show how the hidden-action problem can be overcome through appropriate design of contracts in both the direct (the endpoints contract with each individual router directly) and the recursive (each router contracts with the next downstream router) cases. We further show that, depending on the network topology, per-hop or per-path monitoring may not necessarily improve the utility of the principal or the social welfare of the system.     

A geometry-based error estimation for cross-ratios

For choosing specific cross-ratios as 2D projective coordinates in various computer vision applications, a reasonable error analysis model is usually required. This investigation adopts the assumption of normal distribution for positioning errors of point features in an image to formulate the error variances of cross-ratios. Based on a geometry-based error analysis, a straightforward way of identifying the cross-ratios with minimum error variances is proposed. Simulation results show that the proposed approach, as well as a further simplified alternative, yield much better estimations of minimum error variances in terms of accuracy, cost, and stability compared with some other methods, e.g., the one based on the rule given by Georis et al. (IEEE Trans. Pattern Anal. Mach. Intell. 20 (4) (1998) 366). Some causes of the performance differences in the estimations are explained using a special configuration of point features.     

Colloidal silica removal in coagulation processes for wastewater reuse in a high-tech industrial park.

Four experiments of coagulation and flocculation were conducted to investigate the characteristics of colloidal silica removal in a high-tech industrial wastewater treatment plant for reclamation and reuse of the effluent. Experimental results illustrated that poly-aluminium chloride (PACl) showed higher performances on colloidal silica removal than alum. Interestingly, the two coagulants demonstrated the same capacity on silica removal. The specific silica removal capacity was approximately 0.135 mg SiO2/mg Al2O3 when the dosage of coagulants was in the range 30-150 mg/L Al2O3. In addition, the silica was reduced significantly at the condition of pH above 8. Experimental data implied that precipitation of aluminium flocs was the major mechanism for colloid silica removal in PACl and alum coagulation, besides, charge adsorption was also important for improving removal efficiency. Moreover, the addition of polyacrylic acid (PAA) as a flocculant could slightly advance silica removal in the PACl coagulation. The combined PACl/PAA/flocs coagulation was effective for the removal of colloidal silica, soluble COD, and turbidity and also suitable as a pretreatment unit in wastewater reclamation and reuse processes.     

Optical gain of strained wurtzite GaN quantum-well lasers

A theory for the electronic band structure and the free-carrier optical gain of wurtzite-strained quantum-well lasers is presented. We take into account the strain-induced band-edge shifts and the realistic band structures of the GaN wurtzite crystals. The effective-mass Hamiltonian, the basis functions, the valence band structures, the interband momentum matrix elements, and the optical gain are presented with analytical expressions and numerical results for GaN-AlGaN strained quantum-well lasers. This theoretical model provides a foundation for investigating the electronic and optical properties of wurtzite-strained quantum-well lasers.     

A thermochemical concept-based equation to estimate waste combustion enthalpy from elemental composition

Waste combustion is an interesting alternative for waste management and energy recovery. Knowledge of the waste higher heating value (HHV) is important for judging it’s worth as fuel. This work introduces a new equation, based on thermochemical concepts, to calculate HHV from elemental composition. This equation is expressed in terms of mass percentages on a dry basis of carbon (%C), hydrogen (%H), oxygen (%O), nitrogen (%N), and sulfur (%S); the HHV is computed in MJ/kg. The equation is as follows: HHV=(1−(%H₂O/100))(−0.3708(%C)−1.1124(%H)+0.1391(%O)−0.3178(%N)−0.1391(%S)). The thermochemical concept on which this expression is based involves a wide applicability. This equation neglects the inorganic carbon, hence it is not very adequate when there is a significant concentration of it. The predictions from this approach were contrasted against those proceeding from equations currently used in combustion technology, and also against bomb calorimeter data. The new equation is clearly competitive with respect to other formulations, and it can be very helpful for presenting a waste HHV value based on different derivation suppositions.