κ-Opioid Signaling in the Lateral Hypothalamic Area Modulates Nicotine-Induced Negative Energy Balance

Several studies have reported that nicotine, the main bioactive component of tobacco, exerts a marked negative energy balance. Apart from its anorectic action, nicotine also modulates energy expenditure, by regulating brown adipose tissue (BAT) thermogenesis and white adipose tissue (WAT) browning. These effects are mainly controlled at the central level by modulation of hypothalamic neuropeptide systems and energy sensors, such as AMP-activated protein kinase (AMPK). In this study, we aimed to investigate the kappa opioid receptor (κOR)/dynorphin signaling in the modulation of nicotine’s effects on energy balance. We found that body weight loss after nicotine treatment is associated with a down-regulation of the κOR endogenous ligand dynorphin precursor and with a marked reduction in κOR signaling and the p70 S6 kinase/ribosomal protein S6 (S6K/rpS6) pathway in the lateral hypothalamic area (LHA). The inhibition of these pathways by nicotine was completely blunted in κOR deficient mice, after central pharmacological blockade of κOR, and in rodents where κOR was genetically knocked down specifically in the LHA. Moreover, κOR-mediated nicotine effects on body weight do not depend on orexin. These data unravel a new central regulatory pathway modulating nicotine’s effects on energy balance.     

A phase I-II study of paclitaxel, ifosfamide, and vinorelbine with filgrastim (rhG-CSF) support in advanced non-small-cell lung cancer

PURPOSE: We designed a phase I-II trial of three active agents, paclitaxel, ifosfamide, and vinorelbine, in advanced non-small-cell lung cancer (NSCLC) to: 1) define the dose-limiting toxicities (DLT) and maximum tolerated dose (MTD) of paclitaxel with filgrastim (G-CSF) support; and 2) determine the overall response rate and median survival of patients treated on this regimen. PATIENTS AND METHODS: We treated cohorts of patients with stage IIIB or IV NSCLC with ifosfamide 1.2-1.6 g/m2/day x 3 and vinorelbine 20-25 mg/m2/day x 3 and escalating doses of paclitaxel at 100-175 mg/m2 on day 2 with G-CSF support on a 21-day cycle. One prior experimental single-agent chemotherapy regimen was allowed. RESULTS: Fifty-six patients, were enrolled on this trial: 27 on the phase I portion of the study and an additional 29 at the recommended phase II dose (RPTD). Thirteen patients had received prior chemotherapy. Paclitaxel doses of 175 mg/m2 and 150 mg/m2 produced dose-limiting myelosuppression, and the RPTD was determined to be paclitaxel 135 mg/m2 with ifosfamide 1.2 g/m2/day on days 1-3 and vinorelbine 20 mg/m2/ day on days 1-3 with G-CSF support. The overall response rate was 18%, with a median survival of 6.1 months. Six of 35 patients (17%) treated at the RPTD achieved a partial response to therapy. Grade IV neutropenia was observed in 19 of 35 patients at this dose, with eight patients suffering febrile neutropenia. CONCLUSIONS: This non-cisplatin-containing three-drug regimen has substantial toxicity and low activity in advanced NSCLC, and does not seem to improve on prior regimens. It is unclear whether the lack of efficacy relates to an antagonistic reaction between the specific drugs, administration schedule, or to subtherapeutic doses of the individual agents.     

Sacrospinous colpopexy in the management of uterovaginal prolapse

The tet(M) genes were characterized from 84 isolates of 10 different bacterial species isolated from the periodontal pockets of 16 patients with periodontal disease. A 740 bp polymerase chain reaction product from the hypervariable region of the tet(M) structural gene was cleaved with the restriction enzymes AluI and HinfI. Three different restriction patterns were identified for each of the two enzymes. By DNA sequencing, using a direct solid-phase automated sequencing method, the isolates could be grouped into 3 different clusters of tet(M) subtypes. The internal DNA homology within each subtype was 98-100%; the homology between clusters was 89-94%. Two different subtypes were identified in 9 of 10 bacterial species, and the remaining species had 3 different subtypes. One of the subtypes (M3) was seen mainly in the anaerobic isolates. This subtype was different from all earlier sequenced structural tet(M) genes present in the Genbank. Most patients had two different subtypes of tet(M), and a third subtype was seen in the 3 patients who exhibited the greatest variety of tetracycline-resistant bacterial species. It appears that the presence of one subtype of the tet(M) gene within a patient or bacterial species does not prevent the acquisition of another subtype of the same gene. This study identified a new subtype of the tet(M) gene and grouped it into 3 distinct yet highly homologous genetic subtypes.     

Fast internal dynamics in polyelectrolyte gels measured by dynamic light scattering

Summary Dynamic light scattering was used to investigate the dynamics of sodium poly(styrene sulfonate) and fully neutralized poly(acrylic acid) gels as a function of the degree of swelling and weight ratio of cross-linking agent. It was shown that the collective diffusion coefficient increases with increasing degree of swelling and that the diffusion coefficient shows stronger concentration dependence than predicted by scaling arguments. For gel samples measured at the swelling equilibrium, the diffusion coefficient increases with increasing gel concentration for both gel systems.     

Integrated Smart Sensor Calibration

In many applications electronic sensors are used toimprove performance and reliability of measurement systems. Suchsensors should provide a correct transfer from the physical signalto be measured to the electrical output signal. One importantstep to achieve this, is to calibrate each sensor by applyingdifferent reference input signals and adjusting the sensor transferaccordingly. Besides expensive reference equipment the calibrationprocess takes much time and attention per individual sensor,which means a considerable increase in sensor production costs.By including at the sensor or sensor interface chip a programmablecalibration facility the calibration of such smart sensors caneasily be automated and can be executed for a batch of sensorsat a time, thus minimizing the calibration time and costs. Thispaper presents a calibration method and options for integrationin the smart sensor concept, in hardware as well as in software.An advantage of the proposed method is that it does not needa large matrix of calibration data, which needs to be storedin a look-up table or converted into a correction formula, butinstead it uses a step-by-step approach to correct the sensortransfer at each calibration measurement until the error is sufficientlysmall.     

Concordant but different: Cognitive function, cerebral anatomy, and metabolism in monozygotic twins with Alzheimer's disease.

To illustrate the utility of the twin method in Alzheimer's disease (AD) research, a pair of monozygotic twins, concordant for the disease but markedly different in their clinical presentations, was studied in detail. Neuropsychological evaluation, magnetic resonance imaging (MRI), and cerebral glucose metabolic studies revealed a typical behavioral presentation for AD in Twin A. In contrast, Twin B showed prominent visuospatial impairments. Although there was no identified cause for the disparate presentations, a close correspondence was observed between the neuropsychological findings and the regional brain measures. The results suggest that the trajectory of AD may vary widely even in genetically identical individuals. Factors accounting for the variability include potential intrauterine, early developmental, and environmental differences. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Process development and adhesion behavior of electroless copper on liquid crystal polymer (LCP) for electronic packaging application

Liquid crystal polymer (LCP) has potentially a very wide application as substrate material in electronic packaging applications because of its unique advantages. The work in this paper was performed to realize the metallization of LCP for the purpose of board fabrication, and to study the adhesion between deposited copper and LCP. A homogenous electroless plated copper layer on LCP with 4 to 5 /spl mu/m thickness was achieved, while it increased up to 40 /spl mu/m with the subsequent electroplating. The timescale of etching, deposit ion rate, and pH value were gradually changing during the plating process and the influences on copper layer quality were investigated. The adhesion force of the copper-LCP layer system was measured by a shear-off-method. Scanning electron microscopy (SEM) was used to check the surface morphology after etching and the interface after shearing on both the backside of the copper layer and the LCP side. The relationship between the shear-off adhesion of copper and the time of chemical etching before plating was examined, and the optimal etching time is discussed. Heat treatment after plating was used, and it was shown that this significantly improved the adhesion strength.     

Granulation tissue polyposis associated with carcinoid tumours of the small intestine

We report two patients with ileal carcinoid tumours which were associated with polyps due to mucosal granulation tissue proliferation. In both cases the tumours had extensively infiltrated the small bowel wall and mesentery, and one had hepatic metastases. The mucosal surface of each specimen showed numerous, pale brown, sessile polyps which were restricted to the intestinal segment involved by carcinoid tumour, although not always closely related to neoplastic cells. The polyps were formed by the proliferation of capillaries, smooth muscle cells and myofibroblasts as demonstrated by immunohistochemistry and electronmicroscopy.