EFFECT OF DEVELOPER PROPERTIES ON PRINT QUALITY

We investigated the dependence of the toner charge-to-mass ratio (q/m) in a two-component electrophotographic developer on the shaking time, toner concentration (T/C), carrier sizes, and the carrier core and the coating materials, as well as the resulting print qualities in terms of print density, background density, tone reproduction, resolution, and dot gain. Four different sizes of spherical ferrite carriers, four different carrier coating materials, and an irregular iron carrier were used with two types of toner: 14 um red toner (NP-4080) and 8 um cyan toner (CLC-500). The q/m measurement by the blow-off method showed that the red toner charge was positive while the cyan toner charge was negative with these carriers. The toner q/m values, which depended on the shaking time and decreased with the increasing T/C were much more affected by the larger carrier and the smaller toner. The carriers which yielded charges in the proper range produced better print qualities than did the other carriers that yielded a toner q/m     

Photocatalytic Property and Electronic Structure of Lanthanide-based Oxysulfides

Lanthanide-based oxysulfides and sulfide, LnTaO_3.5S_0.5, Ln₁₀OS₁₄ (Ln = La, Pr, Nd, Sm) and La₄In₅S₁₃, were successively synthesized by sulfurization in a flowing H₂S. The sulfurization decreased the band-gap energies from >4 eV to <3eV, because of the formation of occupied S3p orbitals on the top of valence band. In accordance with the small band gap, the H₂ evolution from a 0.01 M Na₂S and 0.01 M Na₂SO₃ solution system was observed under irradiation of light up to >500 nm. The rate of H₂ evolution under light irradiation of >500 nm increased in the order of Ni/LaTaO_3.5S_0.5 < Ru/La₁₀OS₁₄ < Pt/La₄In₅S₁₃.     

Staurosporine and its derivatives enhance f-Met-Leu-Phe-induced superoxide production via phospholipase D activation in human polymorphonuclear leukocytes

Staurosporine (STAR) is one of the most potent inhibitors of protein kinase C (PKC). It is known that in human polymorphonuclear leukocytes (PMNs), the phorbol ester-induced generation of superoxide anion (respiratory burst) is effectively inhibited by STAR in a dose-dependent manner, whereas superoxide generation induced by chemoattractants, e.g. n-formyl-methionyl-leucyl-phenylalanine (FMLP) or PAF, is regulated biphasically by STAR. We compared the effects of STAR and K252a on FMLP-induced superoxide production from PMNs and examined the effects of propranolol, a inhibitor of phosphatidic acid (PA) phosphohydrolase, on the potentiation of the production by STAR. We also examined the effects of some derivatives of STAR and K252a on the production and the alteration of the effects induced by propranolol pretreatment. When PMNs were stimulated with FMLP, STAR potentiated superoxide production by 240.5 +/- 30.9% at a low concentration (100 nmol/l). Propranolol pretreatment specifically inhibited the potentiation. When phorbol-12-myristate-13-acetate (PMA) was used as a stimulant, STAR inhibited superoxide production dose-dependently and did not enhance the production. K252a inhibited PMA or FMLP-induced superoxide production dose-dependently and did not enhance FMLP-induced superoxide production. STAR derivatives showed potentiation of FMLP-induced superoxide production similar to that of STAR at concentrations ranging from 10-100 nmol/l, and propranolol (200 mumol/l) effectively inhibited it. K252a derivative NA332 did not show any potentiative effect on the production. PMA-induced superoxide production was inhibited by all compounds dose-dependently.(ABSTRACT TRUNCATED AT 250 WORDS)     

Fault section detection system for 66 kV underground branchtransmission lines using optical magnetic field sensors

A fault section detection system that uses optical magnetic field sensors and instantly detects the section in which a ground fault occurred was developed for 66 kV underground multiterminal systems having Y-branch joint boxes. The optical magnetic field sensor, which is based on the Faraday effect in Bi-doped YIG ((BiYbGd)₃Fe₅O₁₂) having a large Verdet constant, detects cable conductor currents of 0 to 2000 A with high precision with the use of a laminated magnetic ring core of silicon steel plates. Sensors and a fault section detector/indicator of a system are connected with optical fibers capable of nonrepeated transmission of over 6 km     

New balance ground relay for parallel four-circuit transmission lines

A 66-kV network generally is grounded through a neutral grounding resistor. In this network a single-phase ground-fault current is limited to as small as 100 to 400 A. There are parallel four-circuit transmission lines mounted on the same tower in the 66-kV network. In such transmission lines, the load and the fault currents could induce circulating current that flows through the lines. Since the circulating current has zero-phase-sequence and negative-phase-sequence components, it could cause unwanted operation of a balance ground relay using zero-phase-sequence current. However, it is difficult to compensate for the circulating current by the conventional vector compensation scheme. This paper presents a new balance ground relay to deal with the circulating current. In the relay from the ground-fault inception until first tripping, the difference current Δ3I_2d of negative-phase-sequence current 3I_2d of the differential current between two protected lines is used as an input current. The Δ3I_2d is the difference current of 3I_2d between, before and during faults. After the first tripping, the difference current of positive-phase-sequence load current and zero-phase-sequence current of the forementioned differential current are used as an input current. Consequently, a higher sensitivity of the ground-fault protection for these lines has been achieved. The correct operation of the new balance ground relay was confirmed when a single-phase-ground-fault occurred in the parallel four-circuit transmission lines, to which the relay is applied.     

Isothermal interphase diffusion with consecutive reactions

For multi-step heterogeneous consecutive reactions affected entirely by interphase diffusion under isothermal condition, the equations for the effectiveness factors, the surface concentrations and the point yields were derived in terms of the Damkoehler numbers or the measurables from the mass balances set up on the assumption that the mass-transfer rate balances the surface-reaction rate at steady state. From the analyses of the equations derived, the effectiveness factors for the intermediate steps and the surface concentrations of intermediates were understood to be enhanced by the measurables inclusive of the concentrations and the mass-transfer coefficients. Then the effect of the concentrations was concluded to be most significant. The effects of these measurables to the effectiveness factors and the surface concentrations were qualitatively discussed for simple consecutive reactions and also for additive consecutive reactions. Especially, as for two-step additive consecutive reactions, the effects of measurables η Da and the concentrations to the effectiveness factors were examined with graphical presentations. Finally, the brief discussion of the dependency of the Damkoehler number upon reaction time and the effect of the Renolds number and diffusivity to the extent of the mass-transfer resistance were presented.     

Magnetic Fluids and Their Use in Transducers

Magnetic fluids are now widely used to implement transducer architectures. These fluids have valuable properties compared to traditional materials. In this column, a brief overview of magnetic fluids and their traditional uses in the field of transducers are given and some applications developed at the DIEES laboratory at the University of Catania, Italy are presented     

Vortices and strings in a model ecosystem

The observation of murine retrovirus infection of microglial cells in brain regions expressing spongiform neurodegenerative changes suggests that these cells may play an important role in pathogenesis. To evaluate this potential in vitro, murine microglial cells were infected in mixed glial cultures with the highly neurovirulent murine retrovirus, FrCasE. The microglia were then isolated from the mixed cultures on the basis of their differential adherence and shown to be approximately 98% pure. The infected microglia expressed viral envelope protein at the plasma membrane, while viral budding was primarily intracellular. Evaluation of the viral envelope protein by immunoblotting indicated that the immunoreactive species produced was exclusively a 90-kDa precursor protein. Very little of the envelope protein was associated with particles released from these cells, and viral titers in the culture supernatant were low. Interestingly, these cells were still capable of infecting permissive target cells when seeded as infectious centers. This partially defective infection of microglial cells suggests a potential cellular means by which a neurovirulent retrovirus could disrupt normal microglia and in turn central nervous system motor system functioning.     

Tocopherol levels in the plasma lipoproteins from Japanese eel Anguilla japonica

The alpha- and gamma-tocopherol levels in the plasma of Japanese eel (Anguilla japonica) were 53.9 micrograms and 1.3 micrograms/ml of plasma, respectively. The alpha-tocopherol in the plasma was mainly distributed as very-low-density lipoprotein and low-density lipoprotein (LDL), while LDL and high-density lipoprotein constituted most of the gamma-tocopherol. A highly positive coefficient of correlation was observed between the alpha-tocopherol and lipoprotein contents in Japanese eel plasma.     

Design optimization of tall tubular lead/acid cells based on an analysis of the reaction distribution

In order to estimate the discharge performance of tall lead/acid cells (with tubular positives), changes in current and potential distributions with discharge progress were calculated with a computer on the basis of plate resistance and the current—potential—time relationship between small facing parts of positive and negative plates. The taller the cell, the larger the voltage drop along the plates. Thus, the discharge time became shorter despite a large amount of available active mass remaining in the bottom part of the plates.Various current-collector designs were evaluated, e.g., one with varying resistance at each height; a side conductor placed along the plates and connected to them at the top, centre and bottom, etc. Results revealed an optimum collector design with which the maximum discharge capacity could be obtained. Furthermore, it was shown that the side conductor markedly improved the discharge performance because the active mass near the connecting parts was appreciably used.