Multidisciplinary approach to defining public e-procurement and evaluating its impact on procurement efficiency

Utilising the methodology of content analysis, this study uses a multidisciplinary approach to define public e-procurement. Various aspects of e-procurement have been discussed from information systems, supply chain management, electronic commerce/electronic government, and public procurement to come up with an integrated definition of public e-procurement. Following this, e-procurement assimilation has been defined and its impact on procurement efficiency has been evaluated. Following the confirmatory factor analysis in structural equation modelling, dimensional level analysis in ANOVA has been undertaken for the three forms of e-procurement technologies namely e-tendering, e-catalogue management systems, and e-marketplace. The results show the positive and significant impact of the assimilation process on procurement efficiency.     

Experimental investigation of impact of diesel particulate filter on smoke and NO<Subscript>x</Subscript> emissions of a Euro-I compression ignition engine with active and off-board regeneration

Old engines (Euro III or earlier) produce more emissions, and it will be difficult to entirely stop their usage especially in developing and under-developed nations; hence, it is desired that appropriate emission reduction technologies are tested on such engines to analyze their feasibility and economical acceptability. While most such studies have been conducted on constant speed stationary engines and modern engines, this study tried to analyze the effectiveness of an uncoated wall-flow type ceramic diesel particulate filter on a Euro-I, water-cooled, direct injection, variable speed, compression ignition engine in a laboratory set-up in India. Also, this study focused on diesel particulate filter regeneration by two methods: active regeneration by diesel injection in the particulate filter using an electronic control unit and off-board regeneration by taking out and heating the diesel particulate filter in an electrical resistance furnace at 650 °C for 10 h. The results, in the form of smoke emission, NO_x emission and engine performance, obtained using both the regeneration methods were analyzed, and conclusions were drawn. It was found that using diesel particulate filter, particulate matter emissions (smoke) were almost entirely eliminated. It was also found that off-board regeneration had numerous advantages compared to active regeneration. Since a furnace would be needed for off-board regeneration, an exchange process for diesel particulate filter is suggested.     

A Chaucer microstrip fractal antenna for mobile applications

In this paper a Chaucer fractal patch antenna integrated with split ring structure is simulated using Ansoft’s (HFSS), as well as fabricated and tested using VNA. The obtained results indicate that the proposed antenna resonates at 2.4 GHz in the ISM band. In addition, the structure offers multi-band operation with the fair value of return loss, gain, and bandwidth, impedance and directivity in the entire range of frequency operation.     

Polyacrylonitrile solution homogeneity study by dynamic shear rheology and the effect on the carbon fiber tensile strength

Poly(acrylonitrile‐co‐methacrylic acid) (PAN‐co‐MAA)/N,N‐dimethylformamide (DMF) solutions were prepared and dynamic shear rheology of these solutions were investigated. With increasing stirring time up to 72 h at 70°C, the polymer solution became less elastic (more liquid‐like) with a ～60% reduction in the zero‐shear viscosity. Relaxation spectra of the PAN‐co‐MAA/DMF solutions yield a decrease in relaxation time (disentanglement time, τ_d), corresponding to an about 8% decrease in viscosity average molecular weight. The log‐log plot of G′ (storage modulus) versus G″ (loss modulus) exhibited an increase in slope as a function of stirring time, suggesting that the molecular level solution homogeneity increased. In order to study the effect of solution homogeneity on the resulting carbon fiber tensile strength, multiple PAN‐co‐MAA/DMF solutions were prepared, and the precursor fibers were processed using gel‐spinning, followed by continuous stabilization and carbonization. The rheological properties of each solution were also measured and correlated with the tensile strength values of the carbon fibers. It was observed that with increasing the slope of the G′ versus G″ log‐log plot from 1.471 to 1.552, and reducing interfilament fiber friction during precursor fiber drawing through the addition of a fiber washing step prior to fiber drawing, the carbon fiber strength was improved (from 3.7 to 5.8 GPa). This suggests that along with precursor fiber manufacturing and carbonization, the solution homogeneity is also very important to obtain high strength carbon fiber. POLYM. ENG. SCI., 56:361–370, 2016. © 2016 Society of Plastics Engineers     

Graphene oxide reinforced polyvinyl alcohol/polyethylene glycol blend composites as high-performance dielectric material

Novel flexible dielectric composites composed of polyvinyl alcohol (PVA), polyethylene glycol (PEG), and graphene oxide (GO) with high dielectric constant and low dielectric loss have been developed using facile and eco-friendly colloidal processing technique. The structure and morphology of the PVA/PEG/GO composites were evaluated using Fourier transform infrared spectroscopy (FTIR), Raman spectroscopy, UV-vis spectroscopy (UV-vis), X-ray diffraction (XRD), scanning electron microscopy (SEM), and atomic force microscopy (AFM). The dielectric behavior of PVA/PEG/GO composites was investigated in the wide range of frequencies from 50 Hz to 20 MHz and temperature in the range 40 to 150 °C using impedance spectroscopy. The dielectric constant for PVA and PVA/PEG (50/50) blend film was found to be 10.71 (50 Hz, 150 °C) and 31.22 (50 Hz, 150 °C), respectively. The dielectric constant for PVA/PEG/GO composite with 3 wt% GO was found to be 644.39 (50 Hz, 150 °C) which is 60 times greater than the dielectric constant of PVA and 20 times greater than the dielectric constant of PVA/PEG (50/50) blend film. The PVA/PEG/GO composites not only show high dielectric constant but also show low dielectric loss which is highly attractive for practical applications. These findings underline the possibilities of using PVA/PEG/GO composites as a flexible dielectric material for high-performance energy storage applications such as embedded capacitors.     

Solid‐state NMR study of spin finish of thermally treated PAN and PAN/CNT precursor fibers

Dry‐jet wet‐spun polyacrylonitrile (PAN) and PAN/carbon nanotubes (CNTs) precursor fibers coated by spin finishes were characterized using the solid‐state ¹H nuclear magnetic resonance technique. Series of fiber samples were prepared upon thermal treatment at different temperatures (room temperature to 180°C). Using the Hahn echo sequence, relatively mobile components were identified and the effect of the heat treatment on those components was studied. It was observed that the mobile components are mainly the spin finishes. Heat treatment caused loss of one of the spin finishes (Type B) to a great extent (～80%), whereas the other two spin finishes (Type A and Type C) were more stable. Additional information regarding the change in molecular mobility due to heat treatment was obtained by the spin‐lattice relaxation time ( T₁ ) analysis. It was found that the presence of CNT affects the T₁ relaxation time of the polymer in the composite fiber, however, that of relatively mobile components remains unaffected. © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2014 , 131, 40734.     

Dynamic mechanical analysis and broadband electromagnetic interference shielding characteristics of poly (vinyl alcohol)-poly (4-styrenesulfonic acid)-titanium dioxide nanoparticles based tertiary nanocomposites

ABSTRACT

Novel tertiary nanocomposite films comprising of poly (vinyl alcohol) (PVA), poly (4-styrenesulfonic acid) (PSSA) and titanium dioxide (TiO₂) nanoparticles (NP_S) were prepared using simple solvent casting method. The structural, thermal, morphological, thermo-mechanical and electromagnetic interference (EMI) shielding properties of PVA/PSSA/TiO₂ nanocomposite films were investigated. The EMI shielding effectiveness (SE) of PVA/PSSA/TiO₂ nanocomposite films in the X and Ku band was found to be 12 dB and 13 dB respectively at 25 wt% TiO₂ NPs loading. These results demonstrate the possible applications of PVA/PSSA/TiO₂ nanocomposite films as low cost, lightweight and flexible material for EMI shielding.     

Effect of lipid excipients on in vitro pancreatic lipase activity

PURPOSE: To study the effects of two lipid excipients, Peceol and Gelucire 44/14 on the in vitro pancreatic lipase activity. METHODS: A 50 microL reaction mixture, consisting of 45 microL (3H) triolein as the radiolabeled substrate, 2.5 microL Peceol or Gelucire 44/14 (0.05-0.5%), either alone or in combination, 2.5 microL colipase (100 microg/mL), and 2.5 microL pancreatic lipase (1 mg/mL), was incubated for 10 min at room temperature. At the end of incubation, the reaction was stopped by the addition of an extraction solvent containing chloroform, methanol, and n-heptane (12.5:14:10), and the mixture vortexed briefly. Subsequently, 250 microL of 50 mM sodium carbonate was added and the aqueous and organic phase separated by centrifugation for 5 min at 1000 g. One hundred microliters of the supernatant was transferred to a scintillation counter and then radioactivity measured after the addition of 3.6 mL of scintillation fluid. Pancreatic lipase activity was determined by measuring the amount of free fatty acid released into the incubation medium and expressed as micromol free fatty acid released/min. RESULTS: When used alone, Peceol inhibited the pancreatic lipase activity significantly in a concentration-dependent manner, with a maximum inhibition of 57% at 0.4% of the excipient [p < 0.05, one-way analysis of variance (ANOVA)]. Similarly, Gelucire 44/14 alone caused inhibition of lipase activity in a concentration-dependent manner. However, the maximum inhibition (30%) was smaller in magnitude compared with the former agent. When the two excipients were used in combination, the inhibitory effects on the enzyme activity were similar to those observed with the individual agents (p < 0.05, one-way ANOVA). However, the maximum inhibition of 30% was lower than that observed with Peceol alone. CONCLUSIONS: The results from this study suggest that these lipid excipients inhibit in vitro pancreatic lipase activity and should be taken into consideration when developing oral formulations using these agents.