Development of 170 GHz/500 kW gyrotron

A development of 170GHz/500kW level gyrotron was carried out as R&D work of ITER. The oscillation mode is TE_31,8. In a short pulse experiment, the maximum power of 750kW was achieved at 85kV/40A. The efficiency was 22%. In the depressed collector operation, 500kW/36%/50ms was obtained. The maximum efficiency of 40% was obtained at P_RF=470kW whereas the power decrease by the electron trapping was observed. Pulse extension was done up to 10s at P_RF=170kW with the depressed collector operation. The power was limited by the temperature increase of the output window.     

Behavior of a mechanically anchored waterproofing membrane system under wind suction and uniform Pressure

A pressure and wind tunnel test was conducted to obtain the basic data for wind resistance design of a mechanically anchored waterproofing membrane system. The test specimen was a flat roof with the following dimensions: 2.4 m in width, 3 m in length and 0.29 m in height. The waterproofing material was polyvinyl chloride sheet reinforced with polyester fiber (PVC sheets). In the pressure test, because the applied pressure was equivalent to the pressure on the entire surface area of the roof, the billowing heights of the PVC sheet around the fastener had almost the same maximum values; therefore, the axial force at the fastener was also similar to the pressure induced by a compressor, and no lateral forces were measured. On the other hand, in the wind tunnel test, the strain of the PVC sheet around the fastener at windward side was larger than that of the leeward side. The lateral force was 70% of the axial force at a mean wind speed of 38.6 m/s. Therefore, it was clear that the characteristics of the mechanically anchored waterproofing membrane system in the pressure test and the wind tunnel test were different.     

Analog CMOS circuit design and characterization for optical coherence tomography signal processing

We have developed a custom analog CMOS circuit to perform the signal processing for an optical coherence tomography imaging system. The circuit is realized in a 1.5 /spl mu/m low-noise analog CMOS technology. The circuitry extracts the Doppler frequency from the signal and electrically mixes this with the original signal to provide a filtered A-scan. The circuitry was used to produce a two-dimensional image of an onion.     

Microassembly of semiconductor three-dimensional photonic crystals

Electronic devices and their highly integrated components formed from semiconductor crystals contain complex three-dimensional (3D) arrangements of elements and wiring. Photonic crystals, being analogous to semiconductor crystals, are expected to require a 3D structure to form successful optoelectronic devices. Here, we report a novel fabrication technology for a semiconductor 3D photonic crystal by uniting integrated circuit processing technology with micromanipulation. Four- to twenty-layered (five periods) crystals, including one with a controlled defect, for infrared wavelengths of 3-4.5 microm, were integrated at predetermined positions on a chip (structural error <50 nm). Numerical calculations revealed that a transmission peak observed at the upper frequency edge of the bandgap originated from the excitation of a resonant guided mode in the defective layers. Despite their importance, detailed discussions on the defective modes of 3D photonic crystals for such short wavelengths have not been reported before. This technology offers great potential for the production of optical wavelength photonic crystal devices.     

Experimental study of the flow in helical circular pipes: Torsion effect on the flow velocity and turbulence

An objective of the present paper is to experimentally clarify the torsion effect on the flow in helical circular pipes. We have made six helical circular pipes having different pitches and common non-dimensional curvature δ of about 0.1. The torsion parameter β0, which is defined by β0 = τ/（2δ）1/2 with non-dimensional torsion r, are taken to be 0.02, 0.45, 0.69, 1.01, 1.38 and 1.89 covering from small to very large pitch. The velocity distributions and the turbulence of the flow are measured using an X-type hot-wire anemometer in the range of the Reynolds number from 200 to 20000. The results obtained are summarized as follows： The mean secondary flow pattern in a cross section of the pipe changes from an ordinary twin-vortex type as is seen in a curved pipe without torsion （toroidal pipe） to a single vortex type after one of the twin-vortex gradually disappears as β0 increases. The circulation direction of the single vortex is the same as the direction of torsion of the pipe. The mean velocity distribution of the axial flow is similar to that of the toroidal pipe at small β0, but changes its shape as β0 increases, and attains the shape similar to that in a straight circular pipe when ,β0 = 1.89. It is also found that the critical Reynolds number, at which the flow shows a marginal behavior to turbulence, decreases as ,β0 increases for small ,β0, and then increases after taking a minimum at ,β0 ≈ 1.4 as ,β0 increases. The minimum of the critical Reynolds number experimentally obtained is about 400 at ,β0 ≈ 1.4.     

ALIS method for high‐resolution color PDPs

This paper describes the Alternate Lighting of Surfaces (ALIS) method as a promising drive technology which can lead to high‐resolution plasma‐display panels (PDPs). This technology provides a resolution of more than 1000 scanning lines without lowering luminance, thus enabling the essential requirements of HDTV. Moreover, it allows the number of scanning electrodes to be halved in comparison with the conventional method, as well as the circuit scale to be minimized due to the use of the single scanning drive. The ALIS method is expected to be a key technology that will help PDPs penetrate the TV market.     

Development of a high‐definition 32‐in. PDP

We developed the world's smallest‐profile 32‐in. HDTV PDP. By improving the luminous efficiency, a luminance of 650 cd/m² and power consumption (discharge and driving circuit) of 200 W or less was achieved. Moreover, incorporating an advanced color compensating (ACC) filter improved the PDP's color‐reproduction capability, better than that of CRTs.     

Effect of silver content on thermal fatigue life of Sn-xAg-0.5Cu flip-chip interconnects

The thermal fatigue properties of Sn-xAg-0.5Cu (x=1, 2, 3, and 4 in mass%) flip-chip interconnects were investigated to study the effect of silver content on thermal fatigue endurance. The solder joints with lower silver context (x=1 and 2) had a greater failure rate compared to those with higher silver content (x=3 and 4) in thermal fatigue testing. Cracks developed in the solders near the solder/chip interface for all joints tested. This crack propagation may be mainly governed by the nature of the solders themselves because the strain-concentrated area was similar for tested alloys independent of the silver content. From the microstructural observation, the fracture was a mixed mode, transgranular and intergranular, independent of the silver content. Higher silver content alloys (x=3 and 4) had finer Sn grains before thermal cycling according to the dispersion of the Ag₃Sn intermetallic compound, and even after the cycling, they suppressed microstructural coarsening, which degrades the fatigue resistance. The fatigue endurance of the solder joints was strongly correlated to the silver content, and solder joints with higher silver content had better fatigue resistance.     

Effects of the method of preparing iron orthophosphate catalyst on the structure and the catalytic activity

Catalytic activity of iron orthophosphate [FePO₄] was studied using oxidative dehydrogenation of lactic acid to pyruvic acid as a reaction probe. The structure and surface area are different depending on the differences in the source of starting materials as well as in the preparing methods. However, the specific activity, activity per unit surface area, is little affected with the variation in the structure. By the reduction and reoxidation, the catalytic activity clearly increases.