Prediction of Chameleonic Efficiency

Chameleonic properties, i. e., the capacity of a molecule to hide polarity in non-polar environments and expose it in water, help achieving sufficient permeability and solubility for drug molecules with high MW. We present models of experimental measures of polarity for a set of 24 FDA approved drugs (MW 405-1113) and one PROTAC (MW 1034). Conformational ensembles in aqueous and non-polar environments were generated using molecular dynamics. A linear regression model that predicts chromatographic apparent polarity (EPSA) with a mean unsigned error of 10 Ų was derived based on separate terms for donor, acceptor, and total molecular SASA. A good correlation (R²=0.92) with an experimental measure of hydrogen bond donor potential, Δlog P_oct-tol, was found for the mean hydrogen bond donor SASA of the conformational ensemble scaled with Abraham's A hydrogen bond acidity. Two quantitative measures of chameleonic behaviour, the chameleonic efficiency indices, are introduced. We envision that the methods presented herein will be useful to triage designed molecules and prioritize those with the best chance of achieving acceptable permeability and solubility.     

Comparative analysis of formaldehyde and toluene sorption on indoor floorings and consequence on Indoor Air Quality

Indoor surfaces may be adsorptive sinks with the potential to change Indoor Air Quality. To estimate this effect, the sorption parameters of formaldehyde and toluene were assessed on five floorings by an experimental method using solid-phase microextraction in an airtight emission cell. Adsorption rate constants ranged from 0.003 to 0.075 m·h⁻¹, desorption rate constants from 0.019 to 0.51 h⁻¹, and the partition coefficient from 0.005 to 3.9 m, and these parameters vary greatly from one volatile organic compound/material couple to another indicating contrasted sorption behaviors. A rubber was identified as a sink of formaldehyde characterized by a very low desorption constant close to 0. For these sorbent floorings identified, the adsorption rates of formaldehyde are from 2 to 4 times higher than those of toluene. Two models were used to evaluate the sink effects of floorings on indoor pollutant concentrations in one room from different realistic conditions. The scenarios tested came to the conclusion that the formaldehyde sorption on one rubber (identified as a sink) has a maximum contribution from 15% to 21% for the conditions of low air exchange rate. For other floorings, the sorption has a minor contribution less than or equal to 5%, regardless of the air exchange rate.     

Macroscopic and Microscopic Structures of Cesium Lead Iodide Perovskite from Atomistic Simulations

A first‐principles‐based effective Hamiltonian is developed and employed to investigate finite‐temperature structural properties of a prototype of perovskite halides, that is CsPbI₃. Such simulations, when using first‐principles‐extracted coefficients, successfully reproduce the existence of an orthorhombic Pnma state and its iodine octahedral tilting angles around room temperature. However, they also yield a direct transformation from Pnma to cubic $Pm\overline{3}m$ upon heating, unlike measurements that reported the occurrence of an intermediate long‐range‐tilted tetragonal P4/mbm phase in‐between the orthorhombic and cubic phases. Such disagreement, which may cast some doubts about the extent to which first‐principle methods can be trusted to mimic hybrid perovskites, can be resolved by “only” changing one short‐range tilting parameter in the whole set of effective Hamiltonian coefficients. In such a case, some reasonable values of this specific parameter result in the predictions that i) the intermediate P4/mbm state originates from fluctuations over many different tilted states; and ii) the cubic $Pm\overline{3}m$ phase is highly locally distorted and develops strong transverse antiphase correlation between first‐nearest neighbor iodine octahedral tiltings, before undergoing a phase transition to P4/mbm under cooling.     

Synthesis of Long-Chain β-Lactones and Their Antibacterial Activities against Pathogenic Mycobacteria

In the quest for new antibacterial agents, a series of novel long- and medium-chain mono- and disubstituted β-lactones was developed. Their activity against three pathogenic mycobacteria—M. abscessus, M. marinum, and M. tuberculosis—was assessed by the resazurin microtiter assay (REMA). Among the 16 β-lactones synthesized, only 3-hexadecyloxetan-2-one (VM005) exhibited promising activity against M. abscessus, whereas most of the β-lactones showed interesting activities against M. marinum, similar to that of the classical antibiotic, isoniazid. Regarding M. tuberculosis, six compounds were found to be active against this mycobacterium, with β-lactone VM008 [trans-(Z)-3-(hexadec-7-en-1-yl)-4-propyloxetan-2-one] being the best growth inhibitor. The promising antibacterial activities of the best compounds in this series suggest that these molecules may serve as leads for the development of much more efficient antimycobacterial agents.     

Impact of the anode operating conditions on the liquid water distribution in the cathode gas diffusion layer

Previous experimental results indicate that the humidification conditions at the anode have an impact on the liquid water distribution in the cathode gas diffusion layer. Numerical simulations are developed to reproduce and analyze this effect. Results consistent with the experimental results are first obtained by playing with the partition coefficients of an advanced pore network model computing the liquid water formation and transfer in the cathode gas diffusion layer (GDL) for a large range of operating conditions. Then, a model for the full anode – cathode assembly is developed by combining the pore network model of the cathode GDL and a 1D model describing the heat and water transfer in the various components of the anode-cathode assembly. This enables one to generalize the dry – wet regime diagram introduced in a previous work by incorporating the effect of the humidity condition at the anode.     

Spatio-temporal evolution of the deformation around the Rio-Patras fault (Greece) observed by synthetic aperture radar interferometry from 1993 to 2017

We analysed the ground deformation across two blocks defined by the Rio-Patras fault from 1993 to 2017 using multi-temporal Synthetic Aperture Radar Interferometry (InSAR) techniques. Our main objective was to contribute to the assessment of seismic hazard near the large city of Patras. Multiple data-sets were used, each one covering different temporal periods. Descending and ascending acquisitions, providing different viewing geometries contribute to fully determine the ground displacement in 3D. The data-sets used are from the European Space Agency’s (ESA) European Remote Sensing (ERS), Environmental Satellite (ENVISAT) and SENTINEL-1 as well as German Aerospace Center (DLR) ’s TERRASAR-X missions. Considering ESA’s missions covering both acquisition geometries and long periods, the southern block, showing lack of a sufficient number of scatterers does not allow the displacement characterization. In contrary, the northern block is characterized by a high number of scatterers having values of maximum likehood ranging from ?3.5 to ?4.3 mm year^?1 for ascending geometry and from ?1.6 to ?2.7 mm year^?1 for the descending one. The fact that both geometries show negative values of displacements are consistent with downlift movement and at the same time the quantitative differentiation probably indicates an horizontal component as well.     

High density polyethylene-wood flour composite lumber: efficacy of two proprietary biocides in the control of fungal colonization and discoloration

Two proprietary biocides were compounded and extruded at three concentrations, respectively, into high density polyethylene-maple wood flour lumber (HDPE-MWL) and evaluated for their efficacy to control fungal colonization and discoloration using the ASTM Standard G 21-96. Although the silver biocide used in this study did not control fungal colonization and discoloration of HDPE-MWL, statistically significant difference was observed between the highest silver biocide concentration and those of the two lower silver biocide concentrations. The latter exhibited no significant difference with the controls. In contrast, the three levels of zinc biocides showed significant difference from each other with respect to their efficacy against fungal colonization and discoloration of HDPE-MWL. Overall, only the zinc biocide was efficacious against fungal colonization and discoloration. The biocide containing zinc as an active biocidal agent was most efficacious at 1% (by weight) concentration.     

洞穴——从微中子研究到地下空间规划

微中子研究需要很大很深的洞穴，以便在没有太多宇宙射线噪音的情况下捕获重要事件。大型的自然洞穴往往出现在喀斯特石灰岩地区，少数大型洞穴也会出现在矿区，而民用洞穴则被广泛用作发电站、火车站、仓库及其他用途。应力控制被认为是在洞穴深挖中消除巨大应力的普遍方法。如果能够在大型洞穴使用应力控制方法，我们就可以建造安全的洞室来进行微中子研究；从另一方面来讲，大而浅的洞穴也能解决城市规划的很多问题。     

Predicting Acute Renal Failure after Cardiac Surgery: Validation and Re‐definition of a Risk‐Stratification Algorithm

Background:  Acute renal failure (ARF) after cardiac surgery is associated with significant morbidity and mortality, irrespective of the need for dialysis. Previous studies have attempted to identify predictors of ARF and develop risk stratification algorithms. This study aims to validate the algorithm in an independent cohort of patients that includes a significant proportion of female and black patients and compares two different definitions of renal outcome.
Methods:  A large single center cardiac surgery database was examined (n, 24,660; 1993–2000) which included 29.9% females and 3.7% black patients. Post‐operative ARF was defined as: a) ARF requiring dialysis, b) > 50% reduction in creatinine clearance relative to baseline or requiring dialysis. Clinical variables related to baseline renal function and cardiovascular disease were used in recursive partitioning analysis for both outcome definitions. Chi‐square goodness of fit analysis was performed to validate the algorithm.
Results:  The frequency of post‐operative ARF requiring dialysis ranged between 0.5 and 15.5% based on the risk categories with the area under the receiver operating characteristic (ROC) curve of 0.78. Using the more inclusive definition of ARF, the frequency was significantly higher ranging from 2.6 to 25%(P < 0.001) with an area under ROC curve of 0.65.
Conclusions:  The renal risk stratification algorithm is valid in predicting post‐operative ARF in an independent cohort of patients, well represented by differences in gender and race. Since the need for dialysis remains subjective, a more objective and inclusive definition of ARF may help in identifying a larger number of patients 'at‐risk'.