Nanolayer CrAlN/TiSiN coating designed for tribological applications

With the goal to produce a hard and tough coating intended for tribological applications, CrAlN/TiSiN nanolayer coating was prepared by alternative deposition of CrAlN and TiSiN layers. In the first part of the article, a detailed study of phase composition, microstructure, and layer structure of CrAlN/TiSiN coating is presented. In the second part, its mechanical properties, fracture and tribological behavior are compared to the nanocomposite TiSiN coating. An industrial magnetron sputtering unit was used for coating deposition. X-ray photoelectron spectroscopy, energy dispersive X-ray spectroscopy, X-ray diffraction, scanning electron microscopy, and transmission electron microscopy were used for compositional and microstructural analysis. Mechanical properties and fracture behavior were studied by instrumented indentation and focused ion beam techniques. Tribological properties were evaluated by ball-on-disk test in a linear reciprocal mode. A complex layer structure was found in the nanolayer coating. The TiSiN layers were epitaxially stabilized inside the coating which led to formation of dislocations at interfaces, to introduction of disturbances in the coating growth, and as a result, to development of fine-grained columnar microstructure. Indentation load required for the onset of fracture was twice lower for the nanolayer CrAlN/TiSiN, compared to the nanocomposite TiSiN coating. This agrees very well with their mechanical properties, with H³/E² being twice higher for the TiSiN coating. However, the nanolayer coating experienced less severe damage, which had a strong impact on tribological behavior. A magnitude of order lower wear rate and four times lower steady state friction coefficient were found for the nanolayer coating.     

Graft copolymerization onto rubber. VII. Graft copolymerization of methyl methacrylate onto rubber using potassium peroxydisulfate catalyzed by silver ion

The graft copolymerization of methyl methacrylate onto natural rubber (NR) was carried out varying the concentration of monomer, initiator, thiourea, and silver nitrate over a wide range. The grafting reaction was temperature-dependent. From the Arrhenius plot, the overall energy of activation was computed. A suitable reaction scheme and rate expression for the rate of polymerization was suggested.     

Synthetic resins: XV. Chelation ion exchange properties of 2,4- dinitrophenylhydrazone of resacetophenone-formaldehyde resin

A number of copolymers were synthesised by condensing the 2,4-dinitrophenylhydrazone of resacetophenone with substituted benzoic acids/ phenols and formaldehyde in the presence of sodium hydroxide or hydrochloric acid. The decomposition temperature, solubility and viscosity of the polymers have been determined. The ion-exchange properties have been studied by using a batch equilibrium method. The distribution of a number of metal ions between an aqueous solution and the resin have been measured. A wide range of pH and variable ionic strengths have been investigated.     

AI paradigms

The aim of this paper is comparative analysis of most important AI paradigms. An AI paradigm is defined as the pair composed by a concept of intelligence and a methodology in which intelligent computer systems are developed and operated. Three paradigms, the behaviourist paradigm, the agent paradigm, and the artificial life paradigm are discussed.     

Antioxidant vs. Prooxidant Properties of the Flavonoid,Kaempferol, in the Presence of Cu(II) Ions: A ROS-Scavenging Activity,Fenton Reaction and DNA Damage Study

Kaempferol is a flavonoid that occurs in tea and in many vegetables and fruits, including broccoli, cabbage, beans, grapes, apples, and strawberries. The efficacy of Kaempferol has been demonstrated in the treatment of breast, esophageal, cervical, ovarian, and liver cancers and leukemia, which very likely arises from its prooxidant properties and the activation of pro-apoptotic pathways. Indeed, this matter has already been the focus of a number of published studies and reviews. The aim of the present study was to elucidate the antioxidant vs. prooxidant properties of flavonoids in the presence of the redox-active metal, copper (II) ion, by means of the Fenton reaction. The specific motivation of this work is that, since an increased level of Cu(II) ions is known to be associated with many disease states such as neurological conditions (Alzheimer’s disease) and cancer, any interaction between these ions and flavonoids might affect the outcome of therapeutic uses of the latter. The structure of the Cu-kaempferol complex in DMSO was investigated by means of low temperature EPR spectroscopy, which confirmed the existence of at least two distinct coordination environments around the copper (II) ion. UV vis-spectra of kaempferol and its Cu(II) complex in DMSO revealed an interaction between the 5-OH (A ring) group and the 4-CO (C ring) group of kaempferol with Cu(II) ions. An ABTS assay confirmed that kaempferol acted as an effective radical scavenger, and that this effect was further enhanced in the form of the Cu(II)-kaempferol complex. Quantitative EPR spin trapping experiments, using DMPO as the spin trap, confirmed suppression of the formation of a mixture of hydroxyl, superoxide, and methyl radicals, in a Fenton reaction system, upon coordination of kaempferol to the redox-active Cu(II) ions, by 80% with respect to the free Cu(II) ions. A viscometric study revealed a better DNA-intercalating ability of the Cu-kaempferol complex than for free kaempferol, essential for conferring anticancer activity of these substances. The results of the viscometric measurements were compared with those from a DNA damage study of Cu-kaempferol complexes in a Fenton reaction system, using gel electrophoresis. At low concentrations of kaempferol (Cu–kaempferol ratios of 1:1 and 1:2), a very weak protective effect on DNA was noted, whereas when kaempferol was present in excess, a significant DNA-protective effect was found. This can be explained if the weakly intercalated kaempferol molecules present at the surface of DNA provide protection against attack by ROS that originate from the Fenton reaction involving intercalated Cu(II)-kaempferol complexes. Following the application of ROS scavengers, L-histidine, DMSO, and SOD, gel electrophoresis confirmed the formation of singlet oxygen, hydroxyl radicals, and superoxide radical anions, respectively. We propose that the prooxidant properties of Cu-kaempferol complexes may provide anticancer activity of these substances. When present in excess, kaempferol displays antioxidant properties under Cu-Fenton conditions. This suggests that kaempferol might prove a suitable candidate for the prevention or treatment of oxidative stress related medical conditions that involve a disturbed metabolism of redox metals such as copper, for example, Menkes disease, and neurological disorders, including Alzheimer’s disease. For the potential use of kaempferol in clinical practice, it will be necessary to optimize the dose size and critical age of the patient so that this flavonoid may be beneficial as a preventive drug against cancer and neurological disorders.     

Polymers from renewable resources. I. Castor oil-based interpenetrating polymer networks: Thermal and mechanical properties

A number of polyurethanes (PUs) were synthesized by reacting castor oil with toluene-2,4-diisocyanate and hexamethylene diisocyanate and varying the NCO/OH ratio. All these polyurethanes were reacted with some acrylic monomers like ethyl acrylate, n-butyl acrylate, ethyl methacrylate, and butyl methacrylate using a crosslinker ethylene glycol dimethyl-acrylate and benzoyl peroxide as the initiator. The physicochemical properties of interpenetrating polymer networks (IPNs) are reported. Thermogravimetric analysis was used to study the thermal behavior of IPNs and the evaluation of kinetic parameters. Degradation mechanism has also been investigated. Some of the mechanical properties viz. tensile strength, shore-A hardness, elongation at break, etc. are also reported. © 1993 John Wiley & Sons, Inc.     

Grafting vinyl monomers onto silk fibers. II. Graft copolymerization of methyl methacrylate onto silk by hexavalent chromium ion

The feasibility of chromium(VI) to induce graft polymerization of methyl methacrylate onto silk was investigated. The rate of grafting was determined by varying monomer concentration, chromium(VI) concentration, temperature, acidity of the medium, nature of the silk, reaction medium, and redox system. The graft yield increased with increasing monomer concentration up to 0.65M, and with further increase of monomer the graft yield decreased. The graft yield increased with increasing chromium(VI) concentration. The grafting is considerably influenced by chemical modification of silk prior to grafting. The graft yield is influenced by thiourea concentration, decreasing with increasing thiourea concentration. The effect of certain inorganic salts and anionic surfactants on the rate of grafting was investigated.