Static energy reduction techniques for microprocessor caches

Microprocessor performance has been improved by increasing the capacity of on-chip caches. However, the performance gain comes at the price of static energy consumption due to subthreshold leakage current in cache memory arrays. This paper compares three techniques for reducing static energy consumption in on-chip level-1 and level-2 caches. One technique employs low-leakage transistors in the memory cell. Another technique, power supply switching, can be used to turn off memory cells and discard their contents. A third alternative is dynamic threshold modulation, which places memory cells in a standby state that preserves cell contents. In our experiments, we explore the energy and performance tradeoffs of these techniques. We also investigate the sensitivity of microprocessor performance and energy consumption to additional cache latency caused by leakage-reduction techniques.     

Miniaturized coplanar waveguide stop band filters based on multiple tuned split ring resonators

A novel compact stop band filter consisting of a 50 /spl Omega/ coplanar waveguide (CPW) with split ring resonators (SRRs) etched in the back side of the substrate is presented. By aligning SRRs with the slots, a high inductive coupling between line and rings is achieved, with the result of a sharp and narrow rejection band in the vicinity of the resonant frequency of the rings. In order to widen the stop band of the filter, several ring pairs tuned at equally spaced frequencies within the desired gap are cascaded. The frequency response measured in the fabricated prototype device exhibits pronounced slopes at either side of the stop band and near 0 dBs insertion loss outside that band. Since SRR dimensions are much smaller than signal wavelength, the proposed filters are extremely compact and can be used to reject frequency parasitics in CPW structures by simply patterning properly tuned SRRs in the back side metal. Additional advantages are easy fabrication and compatibility with MMIC or PCB technology.     

Techniques for microstructural characterization of powder-processed nickel-based superalloys

Methods are described for sample preparation of polycrystalline Ni-based superalloys in order to perform a detailed microstructural characterization. Specific techniques for the precise definition of the various phases present are outlined and these are shown to be useful for the measurement of size, volume fractions and distribution. A number of optical, scanning and transmission microscopy techniques are used to provide the necessary information.     

Implicit Leadership Theories in Applied Settings: Factor Structure, Generalizability, and Stability Over Time.

The present empirical investigation had a 3-fold purpose: (a) to cross-validate L. R. Offermann, J. K. Kennedy, and P. W. Wirtz's (1994) scale of Implicit Leadership Theories (ILTs) in several organizational settings and to further provide a shorter scale of ILTs in organizations; (b) to assess the generalizability of ILTs across different employee groups, and (c) to evaluate ILTs' change over time. Two independent samples were used for the scale validation (N1 = 500 and N2 = 439). A 6-factor structure (Sensitivity, Intelligence, Dedication, Dynamism, Tyranny, and Masculinity) was found to most accurately represent ELTs in organizational settings. Regarding the generalizability of ILTs, although the 6-factor structure was consistent across different employee groups, there was only partial support for total factorial invariance. Finally, evaluation of gamma, beta, and alpha change provided support for ILTs' stability over time. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Reaction of cytochrome P450 with cumene hydroperoxide: ESR spin-trapping evidence for the homolytic scission of the peroxide O-O bond by ferric cytochrome P450 1A2

ESR spin trapping was used to investigate the reaction of rabbit cytochrome P450 (P450) 1A2 with cumene hydroperoxide. Cumene hydroperoxide-derived peroxyl, alkoxyl, and carbon-centered radicals were formed and trapped during the reaction. The relative contributions of each radical adduct to the composite ESR spectrum were influenced by the concentration of the spin trap. Computer simulation of the experimental data obtained at various 5,5-dimethyl-1-pyrroline N-oxide (DMPO) concentrations was used to quantitate the contributions of each radical adduct to the composite ESR spectrum. The alkoxyl radical was the initial radical produced during the reaction. Experiments with 2-methyl-2-nitrosopropane identified the carbon-centered adducts as those of the methyl radical, hydroxymethyl radical, and a secondary carbon-centered radical. The reaction did not require NADPH-cytochrome P450 reductase or NADPH. It is concluded that the reaction involves the initial homolytic scission of the peroxide O-O bond to produce the cumoxyl radical. Methyl radicals were produced from the beta-scission of the cumoxyl radical. The peroxyl adduct was not observed in the absence of molecular oxygen. We conclude that the DMPO peroxyl radical adduct detected in the presence of oxygen was due to the methylperoxyl radical formed by the reaction of the methyl radical with oxygen. At a higher P450 concentration, a protein-derived radical adduct was also detected.     

Fitting Square Pegs into Round Holes

By nature, cryptographers tend to be extremely cautious and conservative. From their perspective, spending time getting people to use a new cryptographic algorithm is roughly on par with getting involved in a land war in Asia. In some cases, however, the difficulty involved in developing a new algorithm is worth the effort. This is the case with identity-based encryption (IBE), a new type of public-key algorithm     

On the Automatic Recovery of Style-Specific Architectural Relations in Software Systems

The cost of maintaining a software system over a long period of time far exceeds its initial development cost. Much of the maintenance cost is attributed to the time required by new developers to understand legacy systems. High-level structural information helps maintainers navigate through the numerous low-level components and relations present in the source code. Modularization tools can be used to produce subsystem decompositions from the source code but do not typically produce high-level architectural relations between the newly found subsystems. Controlling subsystem interactions is one important way in which the overall complexity of software maintenance can be reduced.We have developed a tool, called ARIS (Architecture Relation Inference System), that enables software engineers to define rules and relations for regulating subsystem interactions. These rules and relations are called Interconnection Styles and are definedusing a visual notation. The style definition is used by our tool to infer subsystem-level relations in designs being reverse engineered from source code.In this paper we describe our tool and its underlying techniques and algorithms. Using a case study, we describe how ARIS is used to reverse engineer high-level structural information from a real application.     

Anfangsvorgänge bei Lichtenbergschen Figuren

Zusammenfassung Aufnahmen von Lichtenbergschen Figuren mit kurzen Spannungsstößen zeigen, daß bisher bekanntgewordene Bilder solcher Entladungsfiguren bereits ein verhältnismäßig weit vorgeschrittenes Stadium darstellen. Es gelingt mittels kurzer Stöße erste lawinenartige Anfänge der Figuren festzuhalten und einiges über Vorgänge im Anfangsstadium herauszulesen. Die negative Figur beginnt lawinenförmig an bevorzugten Stellen der Kathode. Bei nebeneinander entstandenen Lawinen ist sehr gut die gegenseitige Abstoßung infolge gleicher Ladung zu beobachten. Die Entladung hat einen geschichteten Aufbau. Die positiven Figuren bilden sich später aus. Es sprechen jedoch bisher keinerlei Anzeichen für ein Hinwachsen der Fäden zur Anode. Die Kanäle verjüngen sich zur Anode hin und selbst bei kurzen Stoßzeiten endet kein einziger vor der Anode. Auch die Art der gegenseitigen Abstoßung der positiven Fäden spricht mehr für ein Vorwachsen von der Anode aus. Aus den Farbaufnahmen ergibt sich für die filmschwärzende Strahlung eine Wellenlänge unter 450 m.