Effects of SO2 on selective catalytic reduction of NO with NH3 over a TiO2 photocatalyst

The effect of SO₂ gas was investigated on the activity of the photo-assisted selective catalytic reduction of nitrogen monoxide (NO) with ammonia (NH₃) over a TiO₂ photocatalyst in the presence of excess oxygen (photo-SCR). The introduction of SO₂ (300 ppm) greatly decreased the activity of the photo-SCR at 373 K. The increment of the reaction temperature enhanced the resistance to SO₂ gas, and at 553 K the conversion of NO was stable for at least 300 min of the reaction. X-ray diffraction, FTIR spectroscopy, thermogravimetry and differential thermal analysis, x-ray photoelectron spectroscopy (XPS), elemental analysis and N₂ adsorption measurement revealed that the ammonium sulfate species were generated after the reaction. There was a strong negative correlation between the deposition amount of the ammonium sulfate species and the specific surface area. Based on the above relationship, we concluded that the deposition of the ammonium sulfate species decreased the specific surface area by plugging the pore structure of the catalyst, and the decrease of the specific surface area resulted in the deactivation of the catalyst.     

Contribution of metal vapor mass at periphery part of pulsed arc to electromagnetic force in weld pool

The arc welding has been used in various welding methods because it is inexpensive and high in strength after welding. However, it is a problem that accidents such as collapse of the bridge occur because of the welding defects. The welding of low cost and high productivity is required without the welding defects. The pulsed TIG welding is inexpensive and capable of high‐quality welding. The electromagnetic force contributing to penetration changes because the transient response of arc temperature and iron vapor generated from anode occurs. However, the analysis of pulsed TIG welding with metal vapor has been elucidated only metal vapor concentration near anode with transient phenomenon and heat flux. Thus, the theoretical elucidation of penetration depth with control factor has not been researched. In this paper, the contribution of metal vapor mass at the periphery part of pulsed arc to the electromagnetic force in the weld pool is elucidated. As a result, the iron vapor mass at periphery part decreased with increasing the frequency. The iron vapor was stagnated at axial center within one cycle. The electromagnetic force to the penetration depth direction in weld pool increased at axial center. Therefore, the metal vapor mass at periphery part plays an important role for the electromagnetic force increment at axial center.     

Effects of 17 beta-estradiol on nitric oxide and ventricular myocardium metabolism

BACKGROUND: Arrhythmias are frequent pathology in patients with chronic hemodialysis. We evaluated whether a relatively new technique, signal averaging, could be useful in predicting the development of complex arrhythmias in these patients. METHODS: Thirty-three patients, 18 male and 15 female, subjected to thrice weekly chronic hemodialytic treatment with various dialysis techniques, were studied. Exclusion criteria were the presence of antiarrhythmic and inotropic treatment. The following examinations were carried out in all patients: a Holter dynamic electrocardiography for a duration of 24 hours, begun on the day of dialysis, high resolution ECG pre- and post-dialysis to find out if there were any ventricular late potential (VLP). Four hundred beats were examined in order to obtain a background noise of less than 0.7 microV and a better definition of the signal. The following parameters were considered significant for the presence of VLP: a) filtered QRS duration > 120 msec; b) the root mean square of the signal expressed in the terminal portion of QRS (RMS) < 25 microV) high frequency low amplitude signals duration (HFLA) > 40 msec. A positive value in two of these parameters was considered indicative of the presence of VLP. In addition various pre and post-dialysis indices of dialytic efficiency and a mono and two-dimensional echocardiogram with pulsed and color Doppler were carried out. Of the 33 patients studied, ten were excluded because they presented too high a background noise at the high resolution ECG. Of the remaining 23 patients, 13 (56%) presented VLP and nine of these (69%) presented complex arrhythmias. Of the ten patients without VLP, 5 (50%) presented complex arrhythmias. The incidence of arrhythmias was highest during the last two hours of dialysis and in the two hours following it. The patients were then divided into two groups (A and B) according to the ejection fraction (EF) found at the echocardiogram. Group A was composed of 17 patients of whom 8 (47%) presented complex arrhythmias; group B (EF < 45%) was composed of the remaining six patients, who all presented complex arrhythmias. In group A nine patients (53%) out of 17 had LVP, in group B four out of six (66%) had it. All the patients except one presented an increase in the thickness of the ventricular wall and alterations of Doppler transmitral filling rate. Left ventricular hypertrophy was diagnosed in 22 out of the 23 patients. Four patients also had chronic ischaemic heart disease; of these three had LVP. There was no correlation between the presence of LVP and the hemodialytic indices and between the latter and complex arrhythmias. CONCLUSIONS: Our study showed that arrhythmias are more frequent in patients with LVP before dialysis than in those without. The difference was statistically significant (p < 0.006); the incidence of arrhythmias was higher in patients with FE < 45% (p < 0.001). The majority of patients (95%) had left ventricular hypertrophy; only four (17%) had ischaemic heart disease too. It is highly probable that the presence of LVP in our patients can be attributed to hypertension and subsequent left ventricular hypertrophy. As patients with LVP at the end of dialysis had a greater incidence of arrhythmias than those without LVP, we suggest that this method could be useful as a first screening in dialysed patients.     

OTDM transmitter using WDM-TDM conversion with an electroabsorptionwavelength converter

An all-optical multiplexing technique using wavelength division multiplexing (WDM)-time division multiplexing (TDM) conversion with an electroabsorption wavelength converter has been proposed and demonstrated. The effectiveness of this WDM-TDM conversion technique for various pulsewidth settings was experimentally investigated. The fluctuation of the signal performance, which was inevitably caused by the coherent crosstalk between adjacent pulses in the conventional optical time division multiplexing (OTDM) technique, were successfully suppressed, even in the case of wide pulse duration. High Q-factor performance has been maintained for a wide range of duty ration from 36% to 74%. By introducing this technique to the optical time division multiplexer, a highly stable and high-quality 40-Gb/s optical signal can be effectively produced without generating the short pulse or setting two tributaries at orthogonal polarization states, and without introducing high-speed electronics for signal multiplexing. The WDM-TDM conversion with an electroabsorption wavelength converter was extended to 60-Gb/s operation by using three 20-Gb/s tributaries. A clear eye opening was confirmed for a waveform after the WDM-TDM conversion of the 60-Gb/s signal     

Synthesis, Characterization, and Formation Process of Na-X Zeolite from Coal Fly Ash

Using the SiO₂ and Al₂O₃ components of the amorphous phase in coal fly ash (Fa), Fa was converted to Na-X zeolites in NaOH-NaAlO₂ solutions by stirring at 35°C for 72 hr and then aging at 85°C for a given period. The molar ratio SiO₂/Al₂O₃ of the starting materials was controlled from 2.0 to 13.2. The resulting materials were characterized by various means. Increasing the SiO₂/Al₂O₃ ratio of the starting material increased the degree of crystallinity of faujasite, exhibiting a maximum at SiO₂/Al₂O₃ = 8.0. The faujasite formed was identified as Na-X zeolite with Si/Al = 1.20. The amorphous phase in Fa was dissolved during the stirring to form a precursor of zeolite, such as amorphous aluminosilicate. The Na-X zeolite was formed by aging for 24 hr, and the degree of crystallinity of this material was increased with the increasing aging period. The cation exchange capacity and specific surface area were increased with the increasing degree of crystallinity of the Na-X zeolites.     

Wideband and compact folded loop antenna

A simple and successful design method that yields a wideband and compact antenna without a ground plane is proposed. The antenna, referred to as the folded loop antenna, can, with the right parameters, achieve wideband characteristics. Calculated and measured results agree well and more than 50% bandwidth (return loss /spl les/-10 dB) is obtained.