On the origin of strain hardening in glassy polymers

The influence of network density on the strain hardening behaviour of amorphous polymers is studied. The network density of polystyrene is altered by blending with poly(2,6-dimethyl-1,4-phenylene-oxide) and by cross-linking during polymerisation. The network density is derived from the rubber-plateau modulus determined by dynamic mechanical thermal analysis. Subsequently uniaxial compression tests are performed to obtain the intrinsic deformation behaviour and, in particular, the strain hardening modulus. At room temperature, the strain hardening modulus proves to be proportional to the network density, irrespective of the nature of the network, i.e. physical entanglements or chemical cross-links. With increasing temperature, the strain hardening modulus is observed to decrease. This decrease appears to be related to the influence of thermal mobility of the chains, determined by the distance to the glass-transition temperature (T−T_g).     

Prediction of brittle-to-ductile transitions in polystyrene

In this study it is attempted to predict brittle-to-ductile transitions (BDTs) in polystyrene blends, induced either by an increase in temperature or by a decrease in inter-particle distance. A representative, two-dimensional volume element (RVE) of a polystyrene matrix with 20% circular voids, is deformed in tension. During deformation a hydrostatic-stress based craze-nucleation criterion [1] is evaluated. The simulations demonstrate that crazes initiate at low temperatures while a transition from crazing to shear yielding (BDT) is found around 75 °C. The numerical results correlate well with tensile tests on similar heterogeneous polystyrene. The presence of an absolute length, as experimentally found, is more difficult to explain. Near a free surface a T_g-depression is measured for polystyrene and also the resistance to indentation in polystyrene is lower than expected from bulk properties. Both observations are rationalised by an enhanced segmental mobility of chains near a free surface. As a consequence of these findings, an absolute length-scale could be incorporated in the numerical simulations. For simplicity, the length-scale is modelled by taking a temperature gradient over a thin layer near the internal free surfaces of the RVE. Deformation of the RVE with different absolute length-scales shows that indeed also the experimentally found brittle-to-ductile transition can be predicted if the ligament thickness between the inclusions (‘voids’) in polystyrene is below a critical value of ca. 15 nm.     

Occupational injuries among working adolescents in New York State

OBJECTIVE: To determine the number, distribution, determinants, and health consequences of occupational injuries among working adolescents in New York State. DESIGN: A retrospective, population-based analysis of New York State workers' compensation award data and the Annual Demographic File, a supplement to the US Bureau of the Census Current Population Survey. PARTICIPANTS: Adolescents, aged 14 through 17 years, who received workers' compensation awards for occupational injury from 1980 through 1987. MAIN OUTCOME MEASURES: (1) Numbers, types, and rates of occupational injuries in working adolescents by age, sex, industry, and occupation; (2) health consequences of injury, especially disability and death; and (3) secular trends in injury award rates. RESULTS: A total of 9656 adolescents were compensated for occupational injuries; 4201 compensated adolescents (43.5%) suffered permanent disability; 31 working adolescents died. The annual mean rate of compensated occupational injury was 28.2 per 10,000 adolescent workers. Rates were higher in males than in females and ranged from 8.2 per 10,000 in 14-year-old male workers to 46.8 per 10,000 in 17-year-old male workers. Highest rates by industry were seen in manufacturing (49.0/10,000 adolescent workers) and agriculture (46.2/10,000). Unskilled labor was the most dangerous occupation (52.3/10,000). CONCLUSION: Occupational injuries are a substantial and underrecognized contributor to the continuing epidemic of injury among adolescents.     

Sacrospinous colpopexy in the management of uterovaginal prolapse

The tet(M) genes were characterized from 84 isolates of 10 different bacterial species isolated from the periodontal pockets of 16 patients with periodontal disease. A 740 bp polymerase chain reaction product from the hypervariable region of the tet(M) structural gene was cleaved with the restriction enzymes AluI and HinfI. Three different restriction patterns were identified for each of the two enzymes. By DNA sequencing, using a direct solid-phase automated sequencing method, the isolates could be grouped into 3 different clusters of tet(M) subtypes. The internal DNA homology within each subtype was 98-100%; the homology between clusters was 89-94%. Two different subtypes were identified in 9 of 10 bacterial species, and the remaining species had 3 different subtypes. One of the subtypes (M3) was seen mainly in the anaerobic isolates. This subtype was different from all earlier sequenced structural tet(M) genes present in the Genbank. Most patients had two different subtypes of tet(M), and a third subtype was seen in the 3 patients who exhibited the greatest variety of tetracycline-resistant bacterial species. It appears that the presence of one subtype of the tet(M) gene within a patient or bacterial species does not prevent the acquisition of another subtype of the same gene. This study identified a new subtype of the tet(M) gene and grouped it into 3 distinct yet highly homologous genetic subtypes.     

Efficient random subcloning of DNA sheared in a recirculating point-sink flow system

Based on a high-performance liquid chromatographic pump, we have built a device that allows recirculation of DNA through a 63-microm orifice with ensuing fractionation to a minimum fragment size of approximately 300 base pairs. Residence time of the DNA fragments in the converging flow created by a sudden contraction was found to be sufficiently long to allow extension of the DNA molecules into a highly extended conformation and, hence, breakage to occur at midpoint. In most instances, 30 passages sufficed to obtain a narrow size distribution, with >90% of the fragments lying within a 2-fold size distribution. The shear rate required to achieve breakage was found to be inversely proportional to the 1.0 power of the molecular weight. Compared with a restriction digest, up to 40% of all fragments could be cloned directly, with only marginal improvements in cloning efficiency having been observed upon prior end repair with Klenow, T4 polymerase or T4 polynucleotide kinase. Sequencing revealed a fairly random distribution of the fragments.     

An extended pharmacokinetic/pharmacodynamic model describing quantitatively the influence of plasma protein binding, tissue binding, and receptor binding on the potency and time course of action of drugs

An extended pharmacokinetic/pharmacodynamic (PK/PD) model is presented, in which the effect of binding of the drug to plasma proteins and to tissue binding sites in a peripheral compartment, and nonspecific and receptor binding in the effect compartment are taken into account. It represents an extension of the classical Sheiner model, and the model proposed by Donati and Meistelman. The present model is characterized by the following parameters: Kue (exit rate constant of unbound drug from the effect compartment), Pue (ratio of the unbound clearances to and from the effect compartment), fue (fraction of drug in effect compartment that is not bound to nonspecific binding sites), Kd (equilibrium dissociation constant of drug-receptor binding), and Rtot (concentration of receptor binding sites in effect compartment). The rate of association and dissociation of the drug-receptor complex can be incorporated in the model. The influence of the pharmacokinetic parameters (V1, V2, fu, fu2, CLu10, CLu20, CLu12, CLu21) and the PK/PD model parameters (kue, Pue, fue, Kd, Rtot) on various dynamic parameters is analyzed. These include potency (single dose needed to produce 90% effect, ED90), constant infusion dosing rate needed to maintain a constant effect of 90%, time to maximum effect (onset time), and duration to 90% recovery. The neuromuscular blocking agent vecuronium is used as an example. It is shown that both potency and time course of action are strongly dependent on the ratio V1/fu, CLu10, kue, Pue (at equipotent doses the time course is not affected by Pue), fue, Kd, and Rtot (only if Rtot is high), whereas they are less affected by the ratio V2/fu2, CLu20, CLu12, and CLu21. In general, the model parameters affect the ED90 and the time course of action in the same direction, e.g., an increase of V1 results in an increase of ED90 and an increase of onset time and duration. However, the unbound clearance CLu10, the intercompartmental unbound clearance CLu12 and the receptor affinity Kd have an opposite effect on ED90 and the time course parameters, e.g., an increase of CLu10 results in an increase of ED90 and a decrease of onset time and duration. This effect may be responsible for the inverse relationship between onset time and potency of neuromuscular blocking drugs observed in animal experiments and clinical studies. We demonstrate that PK/PD analysis using the traditional effect compartment model (Sheiner model) results in an apparent value of keo, which is a function of kue, fue, Kd, Rtot, as well as the unbound drug concentration in the effect compartment Cue. On the other hand, the model proposed by Donati and Meistelman gives correct values of keo (equal to the product fue.kue), but the receptor affinity Kd and the receptor density Rtot obtained by this method are apparent values, which depend on fu, fue, and Pue.     

Effect of preoperative supplementation with alpha-tocopherol and ascorbic acid on myocardial injury in patients undergoing cardiac operations

Augmentation of antioxidant defenses may help protect tissues against ischemia-reperfusion injury associated with operations involving cardiopulmonary bypass. In this study we examined the effect of pretreating patients with alpha-tocopherol (vitamin E) and ascorbic acid (vitamin C) or placebo on injury to the myocardium. Seventy-six subjects undergoing elective coronary artery bypass grafting participated in a prospective, double-blind, placebo-controlled randomized trial, receiving either placebo or both 750 IU dl-alpha-tocopherol per day for 7 to 10 days and 1 gm ascorbic acid 12 hours before the operation. Plasma alpha-tocopherol concentrations, raised fourfold by supplementation, fell by 70% after the operation in the supplemented group and to negligible levels in the placebo group. There were no significant differences between the groups with respect to release of creatine kinase MB isoenzyme over 72 hours, nor in the reduction of the myocardial perfusion defect determined by thallium 201 uptake. Electrocardiography provided no evidence of a benefit from antioxidant supplementation. Thus the supplementation regimen prevented the depletion of the primary lipid soluble antioxidant in plasma, but provided no measurable reduction in myocardial injury after the operation.     

Identification and characterization of cathepsin B as the cellular MARCKS cleaving enzyme

The importance of regulating the cellular concentrations of the myristoylated alanine-rich C kinase substrate (MARCKS), a major cellular substrate of protein kinase C, is indicated by the fact that mice lacking MARCKS exhibit gross abnormalities of central nervous system development and die shortly after birth. We previously identified a novel means of regulating cellular MARCKS concentrations that involved a specific proteolytic cleavage of the protein and implicated a cysteine protease in this process (Spizz, G., and Blackshear, P. J. (1996) J. Biol. Chem. 271, 553-562). Here we show that p40, the carboxyl-terminal fragment resulting from this cleavage of MARCKS, was associated with the mitochondrial/lysosomal pellet fraction of human diploid fibroblasts and that its generation in cells was sensitive to treatment with NH4Cl. These data suggest the involvement of lysosomes in the generation and/or stability of p40. The MARCKS-cleaving enzyme (MCE) activity was peripherally associated with a 10,000 x g pellet fraction from bovine liver, and it co-purified with the activity and immunoreactivity of a lysosomal protease, cathepsin B. Cathepsin B catalyzed the generation of p40 from MARCKS in a cell-free system and behaved similarly to the MCE with respect to mutants of MARCKS previously shown to be poor substrates for the MCE. Treatment of fibroblasts with a cell-permeable, specific inhibitor of cathepsin B, CA074-Me, resulted in parallel time- and concentration-dependent inhibition of cathepsin B and MCE activity. Incubation of a synthetic MARCKS phosphorylation site domain peptide with purified cathepsin B resulted in cleavage of the peptide at sites consistent with preferred cathepsin B substrate sites. These data provide evidence for the identity of the MCE as cathepsin B and suggest that this cleavage most likely takes place within lysosomes, perhaps as a result of specific lysosomal targeting sequences within the MARCKS primary sequence. The data also suggest a direct interaction between MARCKS and cathepsin B in cells and leave open the possibility that MARCKS may in some way regulate the protease for which it is a substrate.     

Differential divalent cation requirements uncouple the assembly and catalytic reactions of human immunodeficiency virus type 1 integrase

Previous in vitro analyses have shown that the human immunodeficiency virus type 1 (HIV-1) integrase uses either manganese or magnesium to assemble as a stable complex on the donor substrate and to catalyze strand transfer. We now demonstrate that subsequent to assembly, catalysis of both 3' end processing and strand transfer requires a divalent cation cofactor and that the divalent cation requirements for assembly and catalysis can be functionally distinguished based on the ability to utilize calcium and cobalt, respectively. The different divalent cation requirements manifest by these processes are exploited to uncouple assembly and catalysis, thus staging the reaction. Staged 3' end processing and strand transfer assays are then used in conjunction with exonuclease III protection analysis to investigate the effects of integrase inhibitors on each step in the reaction. Analysis of a series of related inhibitors demonstrates that these types of compounds affect assembly and not either catalytic process, therefore reconciling the apparent disparate results obtained for such inhibitors in assays using isolated preintegration complexes. These studies provide evidence for a distinct role of the divalent cation cofactor in assembly and catalysis and have implications for both the identification and characterization of integrase inhibitors.