Quantitative risk assessment using a Japanese hydrogen refueling station model

Although hydrogen refueling stations (HRSs) are becoming widespread across Japan and are essential for the operation of fuel cell vehicles, they present potential hazards. A large number of accidents such as explosions or fires have been reported, rendering it necessary to conduct a number of qualitative and quantitative risk assessments for HRSs. Current safety codes and technical standards related to Japanese HRSs have been established based on the results of a qualitative risk assessment and quantitative effectiveness validation of safety measures over ten years ago. In the last decade, there has been much development in the technologies of the components or facilities used in domestic HRSs and much operational experience as well as knowledge to use hydrogen in HRSs safely have been gained through years of commercial operation. The purpose of the present study is to conduct a quantitative risk assessment (QRA) of the latest HRS model representing Japanese HRSs with the most current information and to identify the most significant scenarios that pose the greatest risks to the physical surroundings in the HRS model. The results of the QRA show that the risk contours of 10^?3 and 10^?4 per year were confined within the HRS boundaries, whereas the risk contours of 10^?5 and 10^?6 per year are still present outside the HRS. Comparing the breakdown of the individual risks (IRs) at the risk ranking points, we conclude that the risk of jet fire demonstrates the highest contribution to the risks at all of the risk ranking points and outside the station. To reduce these risks and confine the risk contour of 10^?6 per year within the HRS boundaries, it is necessary to consider risk mitigation measures for jet fires.     

A wafer level monitoring method for plasma-charging damage usingantenna PMOSFET test structure

A novel monitoring method for plasma-charging damage is proposed. This method performs a quick and accurate evaluation using antenna PMOSFET. It was found that not only hot-carrier (HC) lifetime but transistor parameters such as initial gate current and substrate current were changed according to the degree of plasma-charging damage. However, the present work suggests that monitoring the shift of drain current after a few seconds of HC stress is a more accurate method to indicate plasma-charging damage. The monitoring method using the present test structure is demonstrated to be useful for realizing highly reliable devices     

Reduction of noise figure in semiconductor laser amplifiers with Ga1-xInxAs/GaInAsP/InP strained quantum wellstructures

The noise characteristics of semiconductor laser amplifiers (SLAs) in the Ga_1-xIn_xAs/GaInAsP/InP strained quantum well (QW) system are theoretically calculated and analyzed using density-matrix theory and taking into account the effects of band mixing on both the valence subbands and the transition dipole moments. The numerical results show that a reduced noise figure can be obtained in both tensile and compressively strained QW structures due to the increase in differential gain and the decrease in transparent carrier density. From a comparison among compressively strained (x=0.70), unstrained (x=0.53), and tensile strained (x=0.40) QW SLAs at a fixed carrier density and optical confinement factor, it is found that the noise figure of the tensile strained QW reaches its lowest value of 3.4 dB at average input optical power of -20 dB     

Changes in extracellular nitrite and nitrate levels after inhibition of glial metabolism with fluorocitrate

The role of glial cells in nitric oxide production in the cerebellum of conscious rats was investigated with a glial selective metabolic inhibitor, fluorocitrate. The levels of nitric oxide metabolites (nitrite plus nitrate) in the dialysate following in vivo microdialysis progressively increased to more than 2-fold the basal levels during a 2-h infusion of fluorocitrate (1 mM), and the increase persisted for more than 2 h after the treatment. Pretreatment with N(G)-nitro-L-arginine methyl ester attenuated the fluorocitrate-induced increase in nitric oxide metabolite levels. None of the glutamate receptor antagonists, including D(-)-2-amino-5-phosphonopentanoic acid, 6,7-dinitroquinoxaline-2,3-dione, and (+/-)-alpha-methyl-4-carboxyphenylglycine, inhibited the fluorocitrate-induced increase. The L-arginine-induced increase was significantly reduced by fluorocitrate treatment, while N-methyl-D-aspartate, (+)-alpha-amino-3-hydroxy-5-methylisoxazole-4-propionic acid, and trans-(+/-)-1-amino-(1S,3R)-cyclopentane-dicarboxylic acid increased nitric oxide metabolites levels in the fluorocitrate-treated rats, as much as in control animals. These results suggest that glial cells play an important role in modulating nitric oxide production in the cerebellum by regulating L-arginine availability.     

Nickel Electroplating

NICKEL ELECTROPLATING has been practicallyused for decades.There is an unknown part in theplating,although this is easy to plate.Applications ofthe plating are described from the practical viewpoint.Purpose of Nickel Electroplating(1)Decorative,and corrosion resistanceNickel electroplating is deposited on iron,cupper,zinc and aluminum substrate etc.,and chromiumplating is usually deposited on nickel plating.Hexavalent chromium plating has an important effecton the corrosion resisitan…     

Synthesis of polyoxyethylene derivatives of diesters of sucrose with long-chain fatty acids

Summary Since the long-chain fatty acid sucrose diesters inevitably produced in the synthesis of monoesters are only slightly soluble in water, no important use can be found for them at the present time except as oilsoluble emulsifying agents. In order to exploit new uses we have attempted to improve their solubility in water by introducing oxyethylene radicals into the molecule. The addition reaction of ethylene oxide with the sucrose diesters was carried out in an autoclave in the presence of alkaline catalysts. With the reaction temperature maintained between 100–130° the pressure decreased as the reaction proceeded, and one to two hours were required to consume the ethylene oxide used. The addition products are yellow or orange oily materials soluble in water. Aqueous solutions showed good surface-active properties.     

Geometrical analysis and design of a motion transmitting element for mobile vehicles

The range of speed or torque of motors is limited to some degree. Industrial vehicles working in factories are required to output a large force when they carry loads, and also to move with high velocity when they move to their destination. However, it is impossible to realize both those requirements if a conventional reduction device is used. Velocity variation devices using gears are widely used to change the velocity ratio between the input and output shafts. However, the motion transmission from the input shaft to the output shaft is interrupted during the velocity ratio variation process. In order to solve this problem, a velocity variation method that can transmit motion continuously is proposed, in which a motion transmitting element is used. In this report, a motion transmitting element using the geometrical analysis method is proposed, a method of expressing the curve using dispersed points is proposed, and a method of calculating the inclination and the distances along the curve is developed. Based on the proposed methods, the geometrical form of the transmitting element is analyzed.     

An Extension of the Receiver Operating Characteristic Curve and AUC-Optimal Classification

While most proposed methods for solving classification problems focus on minimization of the classification error rate, we are interested in the receiver operating characteristic (ROC) curve, which provides more information about classification performance than the error rate does. The area under the ROC curve (AUC) is a natural measure for overall assessment of a classifier based on the ROC curve. We discuss a class of concave functions for AUC maximization in which a boosting-type algorithm including RankBoost is considered, and the Bayesian risk consistency and the lower bound of the optimum function are discussed. A procedure derived by maximizing a specific optimum function has high robustness, based on gross error sensitivity. Additionally, we focus on the partial AUC, which is the partial area under the ROC curve. For example, in medical screening, a high true-positive rate to the fixed lower false-positive rate is preferable and thus the partial AUC corresponding to lower false-positive rates is much more important than the remaining AUC. We extend the class of concave optimum functions for partial AUC optimality with the boosting algorithm. We investigated the validity of the proposed method through several experiments with data sets in the UCI repository.     

Occurrence of 70 pharmaceutical and personal care products in Tone River basin in Japan.

The occurrence of 70 pharmaceutical and personal care products (PPCPs) was investigated in the Tone River. The river has the largest basin in Japan, and the water is utilized not only for farming, but also as a source of water supply. One day in both January and October 2006, surface waters in the river and its tributaries and effluents from sewage treatment plants (STPs) directly discharging into the Tone River were collected, the location of which ranged over 150 km along the river. The 70 PPCPs in the samples were concentrated by solid phase cartridge and were measured by LC-MS/MS using three analytical methods. Fifty-seven PPCPs were detected in one or more samples. Bezafibrate, caffeine, carbamazepine, clarithromycin, crotamiton and sulpiride were frequently detected. Mass flow profiles of some PPCPs (e.g., crotamiton) were comparable to cumulative inhabitants in the basin, suggesting that these PPCPs could be markers of population. Total load of each PPCP into the basin from upstream, the tributaries, and the STPs were calculated. The contribution of selected PPCPs from the tributaries with lower sewerage system coverage was dominant compared to those from upstream and the STPs, suggesting the installation of sewerage systems is necessary to reduce the load of PPCPs in the Tone River basin.     

Theoretical linewidth enhancement factor α ofGa1-xInxAs/GaInAsP/InP strained-quantum-wellstructures

The linewidth enhancement factor, α, in the Ga_1-xIn_xAs/GaInAsP/InP strained-quantum-well system was calculated and analyzed using density-matrix theory taking into account the effects of band-mixing on both the valence subbands and the transition dipole moments. As a result of numerical calculation, it was found that a reduced linewidth enhancement factor of 1.1 at the gain peak wavelength can be obtained in the tensile strained-quantum-well structure for TM-mode operation. This is due to the higher differential gain and a negligible free carrier plasma effect in the TM-mode compared to that of the TE-mode operating in the compressively strained-quantum-well structure. This calculation agrees with previously reported experimental results