Model Validation for Bridge-Road-Vehicle Dynamic Interaction System

The dynamic response of highway bridges subjected to moving truckloads has been observed to be dependent on (1) dynamic characteristics of the bridge; (2) truck configuration, speed, and lane position on the bridge; and (3) road surface roughness profile of the bridge and its approach. Historically, truckloads were measured to determine the load spectra for girder bridges. However, truckload measurements are either made for a short period of time [for example, weigh-in-motion (WIM) data] or are statistically biased (for example, weigh stations) and cost prohibitive. The objective of this paper is to present results of a 3D computer-based model for the simulation of multiple trucks on girder bridges. The model is based on the grillage approach and is applied to four steel girder bridges tested under normal truck traffic. Actual truckload data collected using a discrete bridge WIM system are used in the model. The data include axle loads, truck gross weight, axle configuration, and statistical data on multiple presence (side by side or following). The results are presented as a function of the static and dynamic stresses in each girder and compared with code provisions for dynamic load factor. The study provides an alternate method for the development of live-load models for bridge design and evaluation.     

Charge density dependence of elastic modulus of strong polyelectrolyte hydrogels

The mechanical behavior of a series of strong polyelectrolyte hydrogels based on acrylamide and 2-acrylamido-2-methylpropane sulfonic acid sodium salt (AMPS) was investigated. The hydrogels were prepared at a fixed crosslinker ratio and monomer concentration, but at various charge densities, i.e. AMPS contents between 0 and 100 mol%. The elastic modulus of the hydrogels after their preparation first increases with increasing charge density but then decreases continuously. Investigation of the swollen state properties of the hydrogels shows existence of a large number of ionic groups inside the gel that are ineffective in gel swelling. The results indicate two opposite effects of charged groups on the elastic modulus of the hydrogels: formation of multiplets acting as additional crosslinks in the gel increases the elastic modulus of ionic hydrogels, whereas the effect of the electrostatic interaction of charged groups on elastic free energy decreases the modulus.     

The effects of periodontal therapy on serum antibody levels to Actinobacillus actinomycetemcomitans and Porphyromonas gingivalis (part II)

Levels of IgG and IgM antibodies were estimated against Actinobacillus actinomycetemcomitans and Porphyromonas gingivalis were determined by enzyme linked immunosorbent assay (ELISA) in 17 patients with juvenile periodontitis, 15 with adult periodontitis and 24 healthy controls at the beginning of treatment and 3 to 8 months after periodontal therapy. After treatment, antibodies to A. actinomycetemcomitans and P.gingivalis had decreased in patients, but the levels were still significantly higher than in healthy controls. Whether or not an of antibody level against a specific bacteria changes after periodontal treatment is however, still debatable.     

Energy Metabolites as Biomarkers in Ischemic and Dilated Cardiomyopathy

With more than 25 million people affected, heart failure (HF) is a global threat. As energy production pathways are known to play a pivotal role in HF, we sought here to identify key metabolic changes in ischemic- and non-ischemic HF by using a multi-OMICS approach. Serum metabolites and mRNAseq and epigenetic DNA methylation profiles were analyzed from blood and left ventricular heart biopsy specimens of the same individuals. In total we collected serum from n = 82 patients with Dilated Cardiomyopathy (DCM) and n = 51 controls in the screening stage. We identified several metabolites involved in glycolysis and citric acid cycle to be elevated up to 5.7-fold in DCM (p = 1.7 × 10⁻⁶). Interestingly, cardiac mRNA and epigenetic changes of genes encoding rate-limiting enzymes of these pathways could also be found and validated in our second stage of metabolite assessment in n = 52 DCM, n = 39 ischemic HF and n = 57 controls. In conclusion, we identified a new set of metabolomic biomarkers for HF. We were able to identify underlying biological cascades that potentially represent suitable intervention targets.     

Chromatographic performance of monodisperse–macroporous particles produced by “modified seeded polymerization.” I: Effect of monomer/seed latex ratio

In this study, the monodisperse–macroporous particles produced by a relatively new polymerization protocol, the so‐called, “modified seeded polymerization,” were used as column‐packing material in the reversed phase chromatography (RPC) of proteins. The particles were synthesized in the form of styrene‐divinylbenzene copolymer approximately 7.5 μm in size. In the first stage of the synthesis, the monodisperse polystyrene particles 4.4 μm in size were obtained by dispersion polymerization and used as the “seed latex.” The seed particles were swollen by a low‐molecular‐weight organic agent and then by a monomer mixture. The monodisperse–macroporous particles were obtained by the polymerization of monomer mixture in the seed particles. In the proposed polymerization protocol, the number of successive swelling stages was reduced with respect to the present techniques by the use of sufficiently large particles with an appropriate average molecular weight as the seed latex. A series of particles with different porosity properties was obtained by varying the monomer/seed latex ratio. The separation behavior of HPLC columns including the produced particles as packing material was investigated in the RPC mode using a protein mixture including albumin, lysozyme, cytochrome c, and ribonuclease A. The chromatograms were obtained with different flow rates under an acetonitrile–water gradient. The theoretical plate number increased and chromatograms with higher resolutions were obtained with the particles produced by using a lower monomer/seed latex ratio. The separation ability of the column could be protected over a wide range of flow rates (i.e., 0.5–3 mL/min) with most of the materials tested. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 92: 607–618, 2004     

Monodisperse‐porous poly(styrene‐co‐divinylbenzene) beads providing high column efficiency in reversed phase HPLC

A multistage polymerization protocol, the so‐called “modified seeded polymerization,” was developed for the production of monodisperse‐porous poly(styrene‐co‐divinylbenzene) providing high column efficiency as a packing material in reversed phase high performance liquid chromatography (RPLC). In the first stage of the multistage production, uniform polystyrene seed particles, produced by dispersion polymerization, were swollen by an organic agent (i.e., the diluent) and then by a monomer mixture containing styrene and divinylbenzene. The final porous particles were obtained in the monodisperse form by the polymerization of monomer mixture in the seed particles. By the use of a small size seed latex with low molecular weight and by the selection of the appropriate diluent, relatively small monodisperse‐porous particles with suitable pore structure could be achieved. In the reversed phase separation of alkylbenzenes, under isocratic conditions, theoretical plate numbers up to 40,000 plates/m were achieved by using 5.2 μm porous particles, obtained by a toluene‐dibutyl phthalate mixture as the diluent. No significant decrease in the resolution power was observed by the fourfold increase in the mobile phase flow rate. The column efficiency and the resolution observed with 5.2 μm monodisperse‐porous particles were significantly higher with respect to the currently available polymer based packing materials used in the reversed phase HPLC. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 95: 1430–1438, 2005     

Unusual swelling behavior of polymer-clay nanocomposite hydrogels

The swelling behavior and the elastic properties of nanocomposite hydrogels have been investigated. The hydrogels were prepared by free-radical polymerization of the monomers acrylamide (AAm), N,N-dimethylacrylamide (DMA), and N-isopropylacrylamide (NIPA) in aqueous clay suspensions at 21 °C. Laponite with a radius of gyration in distilled water of 20 nm was used as clay particles in the hydrogel preparation. The reactions with AAm monomer were carried out in the presence of the chemical crosslinker N,N′-methylenebis(acrylamide) (BAAm). It was found that the volume of nanocomposite hydrogels immersed in water rapidly increases and attains a maximum value after about one day. Surprisingly, further increase in the swelling time results in the deswelling of the gels until they reach a limiting swelling ratio after about 5 days. This unusual swelling behavior is observable only when the clay concentration in the hydrogel is above the overlap threshold c^∗. Swelling measurements combined with the elasticity tests show that the effective crosslink density first decreases, but then increases with increasing time of swelling of the hydrogels. The results were explained in terms of the rearrangements of the highly entangled polymer chains and clay particles during the gel volume change.     

An experimental evaluation of visual similarity for HDR images

In this paper, we investigate visual similarity for high dynamic range (HDR) images. We collect crowdsourcing data through a web-based experimental interface, in which the participants are asked to choose one of the two candidate images as being more similar to the query image. Triplets forming the query-and-candidates sets are obtained by random sampling from existing HDR data sets. Experimental control factors include choice of tone mapping operator (TMO), choice of distance metric, and choice of image feature. The image features that we experiment with are chosen from the features that are commonly used in the usual low dynamic range setting including features learned via Convolutional Neural Networks. The set of image features also includes combined features where the combination coefficients are estimated using logistic regression. We compute correlations between human judgments and quantitative features to understand how much each feature contributes to visual similarity. Combined features yield nearly 84% agreement with human judgments when applied on tone mapped images. Though we observed that using common features directly on raw or linearly scaled HDR images yield subpar correlation estimates compared to using them on tone mapped HDR images, we did not observe significant effect due to the choice of TMO on the estimates. As an application, we propose an improvement to style-based tone mapping for more correctly imparting desired styles to HDR images with different characteristics.

     

Computer-based testing: An alternative for the assessment of Turkish undergraduate students

Virtually errorless high speed data processing feature has made computers popular assessment tools in education. An important concern in developing countries considering integrating computers as an educational assessment tool before making substantial investment is the effects of computer-based testing on students’ test scores as compared to paper-and-pencil tests. This study investigated whether test scores of Turkish students were different in the computer-based test and in the paper-and-pencil test, with forty-seven undergraduate students studying at a public university located in the Blacksea region of Turkey. Findings of this study showed that test scores of undergraduate students were not different in the computer-based test and in the paper-and-pencil test which led us to reach the conclusion that computer-based testing can be considered as a promising alternative technique for the undergraduate students in Turkey.     

Analysis of defects on BN nano-structures using high-resolution electron microscopy and density-functional calculations

Cubic boron nitride (c-BN) nucleation takes place on hexagonal boron nitride (h-BN) layers growing perpendicular to the substrate surface during thin film synthesis. Studies focused on the nucleation of the cubic phase suggest the possibility that transient phases and/or defects on these h-BN structures have a role in sp3-bonded cubic phase nucleation. In this study, we have investigated the nature, energetics, and structure of several possible defects on BN basal planes, including point defects, 4-, and 5-fold BN rings, that may possibly match the experimentally observed transient phase fine structure. TEM image observations are used to build approximate atomic models for the proposed structures, and DFT calculations are used to relax these structures while minimizing their respective total energies. These optimized atomic geometries are then used to simulate TEM images, which are compared to the experimentally observed structures. Data from DFT calculations and analysis of simulated images from the proposed atomic structures suggest that 4-fold BN rings are more likely to exist on the transient phase possibly leading to c-BN nucleation.