Comparative analysis of formaldehyde and toluene sorption on indoor floorings and consequence on Indoor Air Quality

Indoor surfaces may be adsorptive sinks with the potential to change Indoor Air Quality. To estimate this effect, the sorption parameters of formaldehyde and toluene were assessed on five floorings by an experimental method using solid-phase microextraction in an airtight emission cell. Adsorption rate constants ranged from 0.003 to 0.075 m·h⁻¹, desorption rate constants from 0.019 to 0.51 h⁻¹, and the partition coefficient from 0.005 to 3.9 m, and these parameters vary greatly from one volatile organic compound/material couple to another indicating contrasted sorption behaviors. A rubber was identified as a sink of formaldehyde characterized by a very low desorption constant close to 0. For these sorbent floorings identified, the adsorption rates of formaldehyde are from 2 to 4 times higher than those of toluene. Two models were used to evaluate the sink effects of floorings on indoor pollutant concentrations in one room from different realistic conditions. The scenarios tested came to the conclusion that the formaldehyde sorption on one rubber (identified as a sink) has a maximum contribution from 15% to 21% for the conditions of low air exchange rate. For other floorings, the sorption has a minor contribution less than or equal to 5%, regardless of the air exchange rate.     

Synthesis of Long-Chain β-Lactones and Their Antibacterial Activities against Pathogenic Mycobacteria

In the quest for new antibacterial agents, a series of novel long- and medium-chain mono- and disubstituted β-lactones was developed. Their activity against three pathogenic mycobacteria—M. abscessus, M. marinum, and M. tuberculosis—was assessed by the resazurin microtiter assay (REMA). Among the 16 β-lactones synthesized, only 3-hexadecyloxetan-2-one (VM005) exhibited promising activity against M. abscessus, whereas most of the β-lactones showed interesting activities against M. marinum, similar to that of the classical antibiotic, isoniazid. Regarding M. tuberculosis, six compounds were found to be active against this mycobacterium, with β-lactone VM008 [trans-(Z)-3-(hexadec-7-en-1-yl)-4-propyloxetan-2-one] being the best growth inhibitor. The promising antibacterial activities of the best compounds in this series suggest that these molecules may serve as leads for the development of much more efficient antimycobacterial agents.     

Impact of the anode operating conditions on the liquid water distribution in the cathode gas diffusion layer

Previous experimental results indicate that the humidification conditions at the anode have an impact on the liquid water distribution in the cathode gas diffusion layer. Numerical simulations are developed to reproduce and analyze this effect. Results consistent with the experimental results are first obtained by playing with the partition coefficients of an advanced pore network model computing the liquid water formation and transfer in the cathode gas diffusion layer (GDL) for a large range of operating conditions. Then, a model for the full anode – cathode assembly is developed by combining the pore network model of the cathode GDL and a 1D model describing the heat and water transfer in the various components of the anode-cathode assembly. This enables one to generalize the dry – wet regime diagram introduced in a previous work by incorporating the effect of the humidity condition at the anode.     

Spatio-temporal evolution of the deformation around the Rio-Patras fault (Greece) observed by synthetic aperture radar interferometry from 1993 to 2017

We analysed the ground deformation across two blocks defined by the Rio-Patras fault from 1993 to 2017 using multi-temporal Synthetic Aperture Radar Interferometry (InSAR) techniques. Our main objective was to contribute to the assessment of seismic hazard near the large city of Patras. Multiple data-sets were used, each one covering different temporal periods. Descending and ascending acquisitions, providing different viewing geometries contribute to fully determine the ground displacement in 3D. The data-sets used are from the European Space Agency’s (ESA) European Remote Sensing (ERS), Environmental Satellite (ENVISAT) and SENTINEL-1 as well as German Aerospace Center (DLR) ’s TERRASAR-X missions. Considering ESA’s missions covering both acquisition geometries and long periods, the southern block, showing lack of a sufficient number of scatterers does not allow the displacement characterization. In contrary, the northern block is characterized by a high number of scatterers having values of maximum likehood ranging from ?3.5 to ?4.3 mm year^?1 for ascending geometry and from ?1.6 to ?2.7 mm year^?1 for the descending one. The fact that both geometries show negative values of displacements are consistent with downlift movement and at the same time the quantitative differentiation probably indicates an horizontal component as well.     

Defocusing image to pattern contact holes using attenuated phase shift masks

The patterning of contact holes by selecting out-of-focus image plane (defocus) using attenuated phase shift masks (APSM) has been studied. Defocus is found to enhance the image modulation at low partial coherence for contact holes with negative local average of mask function. Semi-dense holes up to 130 nm in 8% APSM have been printed by 0.5 μm defocus at a partial coherence of 0.31 using KrF scanner with highest numerical aperture of 0.68. However, these holes were closed with in-focus imaging. Defocus is also found to be beneficial for patterning the pitches that have extensive side lobes with in-focus imaging.     

Adaptive motion control using neural network approximations

In this paper, we present a new adaptive technique for tracking control of mechanical systems in the presence of friction and periodic disturbances. Radial Basis Functions (RBFs) are used to compensate for the effects of nonlinearly occurring parameters in the friction and periodic disturbance model. Theoretical analysis, such as stability and transient performance, is provided. Furthermore, the performance of the adaptive RBF controller and its non-adaptive counterpart are compared.     

Topology preservation of template-based 6-subiteration reduction operations

Generally, a reduction operation (e.g., thinning and shrinking) on 3D binary images can be represented as a set of reduction templates where every object voxel of the image satisfying any template is turned to a background voxel. Generally, it is rather difficult, error-prone and time-consuming for verifying the topological soundness of a 3D parallel reduction operation. This paper proposes sufficient conditions of time complexity O(n) for verifying the topological soundness of 3D parallel 6-subiteration reduction operations of n templates where such a kind of 3D reduction operations is performed alternatively from the six orthogonal directions to turn object voxels to background voxels. By such sufficient conditions, the topology soundness of a 3D 6-subiteration parallel reduction operation can be verified by checking each and every of its templates.     

Control of discrete time nonlinear systems with a time-varying structure

In this paper, we present a control methodology for a class of discrete time nonlinear systems that depend on a possibly exogenous scheduling variable. This class of systems consists of an interpolation of nonlinear dynamic equations in strict feedback form, and it may represent systems with a time-varying nonlinear structure. Moreover, this class of systems is able to represent some cases of gain scheduling control, Takagi-Sugeno fuzzy systems, as well as input-output realizations of nonlinear systems which are approximated via localized linearizations. We present two control theorems, one using what we call a “global” approach (akin to traditional backstepping), and a “local” approach, our main result, where backstepping is again used but the control law is an interpolation of local control terms. An aircraft wing rock regulation problem with varying angle of attack is used to illustrate and compare the two approaches.     

Stability robustness of networked control systems with respect to packet loss

This paper is concerned with stability analysis of discrete-time networked control systems over a communication channel subject to packet loss whose behavior is modeled by an i.i.d Bernoulli process with a packet dropping probability bounded by a constant. A necessary and sufficient condition for stability is obtained. A packet dropping margin is introduced as a measure of stability robustness of a system against packet dropping, and a formula for it is derived. A design method is proposed for achieving a large margin subject to a constraint that the system has a set of prescribed nominal closed-loop poles.