Key-dependent side-channel cube attack on CRAFT

CRAFT is a tweakable block cipher introduced in 2019 that aims to provide strong protection against differential fault analysis. In this paper, we show that CRAFT is vulnerable to side-channel cube attacks. We apply side-channel cube attacks to CRAFT with the Hamming weight leakage assumption. We found that the first half of the secret key can be recovered from the Hamming weight leakage after the first round. Next, using the recovered key bits, we continue our attack to recover the second half of the secret key. We show that the set of equations that are solvable varies depending on the value of the key bits. Our result shows that 99.90% of the key space can be fully recovered within a practical time.     

Influence of Different Additives on the Interaction of Quinolone Antibiotic Drug with Surfactant: Conductivity and Cloud Point Measurement Study

Conductometric and cloud point (CP) measurement studies have been performed to investigate the interaction of tetradecyltrimethylammonium bromide (TTAB) and Triton® X-100 (TX-100) with ciprofloxacin hydrochloride (CFH) in different solvents over the temperature range of 295.15–315.15 K. CFH is used for the treatment of various bacterial infections. The observed critical micelle concentration (CMC) values of TTAB were found to be reduced in the presence of electrolytes (Na₂SO₄/Na₃PO₄), and this reduction proceeds with the elevation of salt concentration. The order of the CMC of TTAB follows the trend: > >. The observed CMC values of TTAB were found to increase with increasing temperature and decrease with increasing concentration of CFH in aqueous medium. The values of Gibbs free energy of micellization () for the TTAB/TTAB + CFH mixture were found to be negative, implying spontaneous micellization. The estimated CP of TX-100 decreases with increasing concentration of TX-100 in aqueous medium. The CP values first decrease with increasing concentration of CFH and then increase at higher concentration of CFH almost in all cases investigated. The values of free energy of clouding were found to be positive in all cases studied implying that phase separation of TX-100 was nonspontaneous. The other thermodynamic parameters associated with the micellization of TTAB and the phase separation of TX-100 were estimated and explained.     

Mixed oxide supported hydrodesulfurization catalysts—a review

Support effects form important aspect of hydrodesulfurization (HDS) studies and mixed oxide supports received maximum attention in the last two decades. This review will focus attention on studies on mixed oxide supported Mo and W catalysts. For convenience of discussion, these are divided into Al₂O₃ containing mixed oxide supports, TiO₂ containing mixed oxide supports, ZrO₂ containing mixed oxide supports and other mixed oxide supports containing all the rest. TiO₂ containing mixed oxides received maximum attention, especially TiO₂–Al₂O₃ supported catalysts. A brief discussion about their prospects for application to ultradeep desulfurization is also included. An overview of the available literature with emphasis on research carried out in our laboratory form the contents of this publication.     

Thermal and hydraulic performance of a modified two-stage evaporative cooler

The thermal and hydraulic performance of a modified two-stage evaporative cooler is evaluated. Variables considered are the mode of operation, packing thickness, mass flow rate of the water flowing to the precooler, and the mass flux of water flowing over the packing media. The effectiveness of the system increased with the increase of the mass flow rate of water flowing to the precooler, decreasing the mass flux of water flowing to the packing, and with the increase of the packing thickness. The effectiveness of the system with structured packing was higher than that with sheathy leaf base or natural fiber packing.The air-side pressure drop per unit length in the direction of air flow was nearly constant when the structured packing was used. For the sheathy leaf and natural fiber packings, the air pressure drop increased at a uniform rate as the mass flux of water flowing over the packing increased. The air pressure drop was lowest for the setup with the structured packing.     

Protein-energy malnutrition and oxidative injury in growing rats

1. Weaning rats were fed ad libitum isocaloric diets containing 5% and 20% casein based proteins. 5% protein diet was protein deficient diet. Pair fed rats with the 5% protein group were maintained simultaneously on 20% protein diet but the amount restricted to the amount taken up by PEM group. 2. Glutathione, antioxidative enzymes, lipid peroxidation and histopathological studies in liver and only glutathione and antioxidative enzymes in blood were carried out. 3. Rats fed the 5% protein diet developed a severe protein energy malnutrition (PEM) whereas those on pair-fed diet developed mild to moderate PEM. 4. Glutathione related thiols superoxide dismutase, glutathione peroxidase, catalase and glutathione-Stransferase with (1 Chloro 2,4-dinitro benzene (CDNB) substrate) were decreased in liver with concomitant increase of lipid peroxidation in severe PEM. In blood glutathione, glutathione peroxidase and catalase were decreased while superoxide dismutase was increased in severe PEM group. 5. Mild to moderate PEM (pair-fed group) also resulted in similar changes in liver except glutathione peroxidase, lipid peroxidation in liver and superoxide dismutase in blood. 6. Hepatic injury was detectable only in the severe PEM group. 7. Oxidative-stress and hepatic injury occurred in severe PEM and to a lesser degree in mild to moderate PEM.     

Optimization Models for Layout and Pipe Design for Storm Sewer Systems

Optimization models are developed for simultaneously determining the pipe layout and the pipe design for storm sewer systems. The pipe design process includes computation of commercial diameters, slopes, and crown elevations for the storm sewer pipes. The optimization models aim to minimize the total costs of the layout and the pipe design for most of system elements. The optimization models are formulated as a 0–1 Integer Nonlinear Programming problem and solved using the General Algebraic Modeling System without the use of heuristic models which were characteristic of all previous models for the simultaneous determine of the pipe layout and pipe design of sewer networks. The models are based upon two different optimization approaches: (1) considers one or more commercial diameters of pipe connecting two manholes and (2) considers only one commercial diameter in a pipe connecting two manholes. The commercial diameters, pipe slopes, crown elevations, and total costs of the storm sewer system were compared for the two approaches using an example that illustrates the savings in cost by allowing multiple pipe sizes. The two new optimization modeling approaches developed herein can simultaneously determine the minimum cost pipe design (commercial diameters, slopes, and crown elevations) and pipe layout of storm sewer systems and satisfy all design constraints.