Consistent modeling of capacitances and transit times of GaAs-based HBTs

This paper investigates how time delays and capacitances observed under small-signal conditions can be consistently accounted for in heterojunction bipolar transistor (HBT) large-signal models. The approach starts at the circuit level by mapping the large-signal equivalent circuit (which consists of charge and current sources) to the well-known small-signal circuit (which consists of capacitances, transit-time, and resistances). It is shown that and how bias dependent charge sources at either pn-junction impact transit-time, base-collector capacitance, and their mutual dependence. It is demonstrated for the example of a GaAs-based HBT that the interrelation of the elements is observed in measurements as predicted. The results of the investigation enhance understanding of HBT model characteristics and provide a criterion to check model consistency.     

Analysis of the Survivability of GaN Low-Noise Amplifiers

This paper presents a detailed analysis of the stressing mechanisms for highly rugged low-noise GaN monolithic-microwave integrated-circuit amplifiers operated at extremely high input powers. As an example, a low-noise amplifier (LNA) operating in the 3-7-GHz frequency band is used. A noise figure (NF) below 2.3 dB is measured from 3.5 to 7 GHz with NF<1.8 dB between 5-7 GHz. This device survived 33 dBm of available RF input power for 16 h without any change in low-noise performance. The stress mechanisms at high input powers are identified by systematic measurements of an LNA and a single high electron-mobility transistor in the frequency and time domains. It is shown that the gate dc current, which occurs due to self-biasing, is the most critical factor regarding survivability. A series resistance in the gate dc feed can reduce this gate current by feedback, and may be used to improve LNA ruggedness     

Fabrication and selective surface modification of 3-dimensionally textured biomedical polymers from etched silicon substrates

A new method is described for producing biomedically relevant polymers with precisely defined micron scale surface texture in the x, y, and z planes. Patterned Si templates were fabricated using photolithography to create a relief pattern in photoresist with lateral dimensions as small as 1 micron. Electroless Ni was selectively deposited in the trenches of the patterned substrate. The Ni served as a resilient mask for transferring the patterns onto the Si substrate to depths of up to 8.5 microns by anisotropic reactive ion etching with a fluorine-based plasma. The 3-dimensional (3-D) textured silicon substrates were used as robust, reusable molds for pattern transfer onto poly (dimethyl siloxane), low density poly (ethylene), poly (L-lactide), and poly (glycolide) by either casting or injection molding. The fidelity of the pattern transfer from the silicon substrates to the polymers was 90 to 95% in all three planes for all polymers for more than 60 transfers from a single wafer, as determined by scanning electron microscopy and atomic force microscopy. Further, the 3-D textured polymers were selectively modified to coat proteins either in the trenches or on the mesas by capillary modification or selective coating techniques. These selectively patterned 3-D polymer substrates may be useful for a variety of biomaterial applications.     

Efficacy of venlafaxine and placebo during long-term treatment of depression: a pooled analysis of relapse rates

An assay was developed for the specific detection of Salmonella enterica serotype Enteritidis, using a novel application of the polymerase chain reaction (PCR). This PCR assay is based on the mismatch amplification mutation assay, an allele-specific reaction, and can discriminate Enteritidis from all other salmonella. PCR primers were selected to amplify a 351-base pair (bp) DNA fragment from the salmonella plasmid virulence A (spv A) gene of Enteritidis. A single base difference at position 272 is present between the nucleotide sequence of the spvA gene of Enteritidis and other salmonellae. The downstream PCR primer, that encompasses position 272 of the Enteritidis spvA gene, was designed to contain a single base mismatch at the penultimate position, resulting in a 1-base mismatch with Enteritidis and a 2-base mismatch with other salmonellae that harbour the virulence plasmid. The upstream primer was completely homologous with the region immediately 5' to the spvA gene. When these primers were used and the annealing and extension reactions were performed at the same temperature, the PCR assay was specific for Enteritidis; no PCR product was detected for 40 other serotypes and 28 different genera examined. In pure culture, 120 colony forming units (c.f.u.) could be detected; a PCR product was observed from template derived from a 5 h enrichment broth culture of chicken seeded with 1 c.f.u. per gram of Enteritidis. This PCR assay is specific, reproducible, and less time consuming than the standard bacteriological methods used to detect Enteritidis.     

Ratio of free-to-total prostate specific antigen in serum cannot distinguish patients with prostate cancer from those with chronic inflammation of the prostate

PURPOSE: We demonstrate the effect of chronic inflammation of the prostate on the ratio of free-to-total prostate specific antigen (PSA) in serum calculated as a percentage of free PSA and, therefore, that percentage of free PSA is an unspecific means to distinguish among prostate cancer, chronic prostatitis and benign prostatic hyperplasia (BPH). MATERIALS AND METHODS: Total, free and percentage of free PSA was measured in 66 men with prostate cancer, 119 with BPH and 17 with asymptomatic chronic prostatitis. In all patients the diagnosis was histopathologically confirmed by microscopic examination of prostatic specimens after sextant biopsy, transurethral prostatic resection or prostatectomy. RESULTS: The median values of total, free and percentage of free PSA were 4.11 microg./l., 0.75 microg./l. and 20.4% in patients with BPH, 10.0 microg./l., 0.84 microg./l. and 8.5% in those with prostate cancer, and 7.60 microg./l., 1.23 microg./l. and 10.6% in those with chronic prostatitis. Patients with prostate cancer and chronic prostatitis had a significantly lower percentage of free PSA than those with BPH. Receiver operating characteristics curve analysis showed that percentage of free PSA as a discriminator between prostate cancer and BPH was not suitable for differentiating between prostate cancer and chronic prostatitis. CONCLUSIONS: Chronic prostatitis is not characterized by elevated total PSA concentrations alone but also by a decreased percentage of free PSA, a tendency similar to that in prostate cancer. This unspecific change in percentage of free PSA must be considered to interpret the percentage of free PSA correctly.     

Electronic Kaleidoscopes for the Mind

The goal ofthis article is to present an informal introduction and tutorial on aestheticallypleasing kaleidoscopic images. The article is intended for the non-mathematical reader interested in computer art. Simple generating formulas and recipes are included.     

p53 tumour suppressor gene mutations in benign prostatic hyperplasia and prostate cancer

OBJECTIVE: Seminal vesicle cysts combined with ipsilateral renal agenesis represent a rare urological anomaly. We searched the literature to review the clinical presentation, diagnosis and therapeutic treatment options of this anomaly. METHODS: A pooled analysis was performed of 52 cases of seminal vesicle cysts combined with ipsilateral renal agenesis, including our own observation. The evaluation included: patient age at diagnosis, race, laterality (R/L), presence of ureteral remnant in the cyst, presenting symptoms, diagnostic examinations, treatment and outcome. RESULTS: The mean age at diagnosis was 30.2 years. The majority presented in the 2nd, 3rd and 4th decade of their lives. Only 2 patients (4%) were of African origin, all others were Caucasians. The distribution R:L was 2:1. Ureteral remnants were present in 14 patients (27%). The most common symptoms were: dysuria (37%), frequency (33%), perineal pain (29%), epididymitis (27%), pain following ejaculation (21%) and scrotal pain (13%). Infertility was found in 9 patients (17%). The cyst was palpable by digital rectal examination in 79%. All patients underwent intravenous urography, and 88% underwent cystoscopy. Other frequently performed investigations are: ultrasonography (27%), CT scanning (27%), vasovesiculography (46%) and urethrocystography (23%). The final treatment was open surgery in 74%, aspiration in 6%, transurethral deroofing of the cyst in 6% and spontaneous rupture in 4%. In 6% no treatment was given and in 4% the treatment is unknown. All patients were free of symptoms after open exploration. The success rates after transurethral deroofing and aspiration were 75 and 30% respectively. CONCLUSION: Seminal vesicle cysts combined with ipsilateral renal agenesis are a rare urological anomaly, occurring in men in the 2nd to 4th decade of their life. They present with symptoms of bladder irritation and obstruction and with pain in the perineum and scrotum. Epididymitis is frequently found. The diagnostic work-up consists of a digital rectal examination, transrectal and abdominal ultrasonography, CT scan and a cystoscopy. Open surgery and transurethral deroofing of the cyst give excellent results (100 and 75% cure respectively). Aspiration of the cyst should only be used for diagnostic purposes.     

Driving as a human: a track learning based adaptable architecture for a car racing controller

We present the evolution and current state of the Mr. Racer car racing controller that excelled at the corresponding TORCS competitions of the last years. Although several heuristics and black-box optimization methods are employed, the basic idea of the controller architecture has been to take over many of the mechanisms human racing drivers apply. They learn the track geometry, plan ahead, and wherever necessary, adapt their plans to the current circumstances quickly. Mr. Racer consists of several modules that have partly been adapted and optimized separately, where the final tuning is usually done with respect to a certain racing track during the warmup phase of the TORCS competitions. We also undertake an experimental evaluation that investigates how the controller profits from adding some of the modules to a basic configuration and which modules are most important for reaching the best possible performance.