Scattering and absorption by thin metal wires in rectangularwaveguide-FDTD simulation and physical experiments

The high-frequency internal impedance model of a round ohmic conductor is incorporated into the subcell thin-wire formulation of the finite-difference time-domain method to model the microwave properties of metal wires. For magnetic metals, such as steel, an effective conductivity is introduced to account for the increase in ohmic loss due to the high-frequency permeability. Physical experiments with half-wave resonant copper- and steel-wire inclusions, supported by a dielectric slab in a standard S-band rectangular waveguide, support the formulation     

GaN and AlGaN high-voltage rectifiers grown by metal-organic chemical-vapor deposition

In this paper, we report the study of the electrical characteristics of GaN and AlGaN vertical p-i-n junctions and Schottky rectifiers grown on both sapphire and SiC substrates by metal-organic chemical-vapor deposition. For GaN p-i-n rectifiers grown on SiC with a relatively thin “i” region of 2 μm, a breakdown voltage over 400 V, and forward voltage as low as 4.5 V at 100 A/cm² are exhibited for a 60-μm-diameter device. A GaN Schottky diode with a 2-μm-thick undoped layer exhibits a blocking voltage in excess of ∼230 V at a reverse-leakage current density below 1 mA/cm², and a forward-voltage drop of 3.5 V at a current density of 100 A/cm². It has been found that with the same device structure and process approach, the leakage current of a device grown on a SiC substrate is much lower than a device grown on a sapphire substrate. The use of Mg ion implantation for p-guard rings as planar-edge terminations in mesageometry GaN Schottky rectifiers has also been studied.     

Predicting postlaryngectomy voice outcome in an era of primary tracheoesophageal fistulization: a retrospective evaluation

The aim of this study was to investigate the effect of the absence of elongate spermatids (ES) from the rat seminiferous epithelium on the quantitative secretion and synthesis of the three major Sertoli cell secretory proteins--SGP-1, SGP-2 and CP-2. Seminiferous tubules (ST) were isolated (a) from normal 28-day-old rats, in which the most mature germ cell type is the round spermatid, (b) from normal adult rats at stages IX-XIV of the spermatogenic cycle, i.e. after spermiation, or at stages I-V and VI-VIII, when ES are still attached to the Sertoli cell, and (c) at stages VI-VIII from normal adult rats and from rats treated with methoxyacetic acid (MAA) in order to specifically deplete ES at these stages. Two-dimensional SDS PAGE combined with computerized image analysis was used to analyse 35S-methionine-labelled intracellular and secreted proteins. In the case of SGP-1 and SGP-2, almost all of the protein synthesized by ST was secreted. The total amount of both SGP-1 and CP-2 secreted by unstaged ST from immature rats was significantly lower than that secreted by unstaged ST from adult rats. The total amount of SGP-1 and CP-2 secreted by adult ST at stages IX-XIV of the spermatogenic cycle also declined dramatically compared to ST at earlier stages. The proportion of the total CP-2 synthesized by ST which was secreted also declined in all situations in which ES were absent from the seminiferous epithelium. The synthesis of only SGP-2 was changed by ES depletion from ST at stages VI-VIII, which was almost doubled compared to synthesis of this protein by ST from control rats. Our results suggest strongly that the secretion of SGP-1 and SGP-2 is via the constitutive pathway, and that regulation of these two proteins by ES is at the level of protein synthesis. In contrast, the regulation of CP-2 by ES is predominantly at the level of secretion, suggesting that this protein is secreted via a regulated pathway. Our findings add to the evidence showing that ES play a major role in the regulation of Sertoli cell function.     

ATMOSPHERIC DEPOSITION OF CHEMICAL SPECIES TO POLAR SNOW

Particles and gases can deposit from the atmosphere to polar snow by several mechanisms. Dry deposition can be considered to consist of three steps: aerodynamic transport from the free atmosphere to the viscous sublayer near the surface, boundary layer transport across the sublayer, and interactions with the surface. The particle dry deposition mass flux is dominated by the largest particles present in a size distribution. Wet deposition includes in-cloud and below-cloud scavenging, where the former refers to uptake of particles during nucleation of cloudwater as well as scavenging of particles and gases by existing droplets and ice crystals. Of all the wet deposition mechanisms, nucleation scavenging is often the most important mechanism for particles in the polar regions. Finally, incorporation of particles and gases into fog droplets and subsequent settling of the fog to the snow surface can be an important removal process in regions of frequent fog. For Summit, Greenland, the total deposition of MSA, SO₄^2-, Na⁺, K⁺, and Ca²⁺ during May 24-July 13, 1993 was dominated by wet deposition: this mechanism accounted for an average of 62% of the total deposition for these species. Fog and dry deposition accounted for 21% and 17% of the total, respectively. These results suggest that all three mechanisms may need to be considered when estimating total deposition of certain chemical species to polar snow.     

The influence of the fabrication process on the buckling of thin-walled steel box sections

Steel box sections are usually fabricated from flat plates which are welded at the corners. The welding process can introduce residual stresses and geometric imperfections into the sections which can influence their strength. For some thin-walled sections, large periodic geometric imperfections have been observed in manufactured sections. Subsequent investigations have indicated that the imperfections are in fact buckling deformations i.e. the box section has buckled due to welding residual stresses prior to any application of external load. The welding procedure and the behaviour of the box sections under load has been modelled using a finite element analysis that accounts for both geometric and material non-linearities. Tests have been carried out on box sections with a range of width to thickness ratios for the plate elements. Modelling has been shown to give good correlation with the test results. The conditions for buckling to take place as a result of the welding process have been established. A design method has been proposed.     

GELYMAC: a Macintosh application for calculating DNA fragment size from gel electrophoresis migration data

A program called GELYMAC takes data on the distances migrated by DNA fragments in a one-dimensional electrophoretic gel and, using a cubic-spline best-fit of marker fragment distance migrated versus molecular size, calculates the molecular sizes of the fragments. Written in the Rascal (Real-time Pascal) programming language, the program runs on the Macintosh family of microcomputers. Rapid entry of marker and experimental fragment migration data is afforded using a scroll bar system adjacent to a graphic representation of a gel. Output includes tabular listing of the data, graphic cartoons of the gel, and the fragment locations and molecular sizes for individual gel lanes, and the calibration curve used in data computations.     

Clinical significance of psychotherapy for unipolar depression: A meta-analytic approach to social comparison.

[Correction Notice: An erratum for this article was reported in Vol 55(3) of Journal of Consulting and Clinical Psychology (see record 2008-10745-001). The data presented in Table 2 were incorrect because a row and a column were inadvertently omitted. The corrected Table 2 appears in the erratum.] This study used meta-analysis to study the clinical significance of psychotherapy for symptoms of unipolar depression. The following questions were addressed: How similar is the posttherapy adjustment of depressed adults to that of nondepressed adults? Is this adjustment maintained at follow-up? What dimensions of treatment, therapists, or design are associated with clinical significance? Using the Beck Depression Inventory (BDI), we calculated composite BDI norms from 28 published studies. Sixty effect sizes (from 31 outcome studies utilizing the BDI) were calculated. The results indicated that psychotherapy produces outcomes that have moderate clinical significance and that are well-maintained at follow-up, that individual therapy is associated with greater clinical significance than group treatment, and that type of therapy is not related to improvement. Alternative approaches for operationalizing clinical significance as the return of individuals to normal levels of functioning are discussed. (PsycINFO Database Record (c) 2010 APA, all rights reserved)