Cytotoxic effects of topotecan combined with various anticancer agents in human cancer cell lines

BACKGROUND: Topotecan (TPT) is a topoisomerase I poison that exhibits antineoplastic activity. Analysis of the cytotoxic effects of combinations of TPT and other anticancer agents has been limited. PURPOSE: We assessed the cytotoxic effects produced by combinations of TPT and other antineoplastic agents in experiments involving multiple human cancer cell lines of diverse histologic origins. METHODS: The cytotoxic effects of various antimetabolites (fluorouracil, methotrexate, or cytarabine), antimicrotubule agents (vincristine or paclitaxel [Taxol]), DNA alkylating agents (melphalan, bis[chloroethyl]nitrosourea [BCNU], or 4-hydroperoxycyclophosphamide [4HC]), and a DNA-platinating agent (cisplatin), alone and in combination with TPT, were measured in clonogenic (i.e., colony-forming) assays. HCT8 ileocecal adenocarcinoma, A549 non-small-cell lung carcinoma, NCI-H82ras(H) lung cancer, T98G glioblastoma, and MCF-7 breast cancer cell lines were used in these assays. The data were analyzed by the median effect method, primarily under the assumption that drug mechanisms of action were mutually nonexclusive (i.e., completely independent of one another). For each level of cytotoxicity (ranging from 5% to 95%), a drug combination index (CI) was calculated. A CI less than 1 indicated synergy (i.e., the effect of the combination was greater than that expected from the additive effects of the component agents), a CI equal to 1 indicated additivity, and a CI greater than 1 indicated antagonism (the effect of the combination was less than that expected from the additive effects of the component agents). RESULTS: When the mechanisms of drug action were assumed to be mutually nonexclusive, virtually all CIs for combinations of TPT and either antimetabolites or antimicrotubule agents revealed cytotoxic effects that were less than additive. The CIs calculated at low-to-intermediate levels of cytotoxicity for combinations of TPT and the DNA alkylating agents melphalan, BCNU, and 4HC also showed drug effects that were less than additive; in most cases, however, nearly additive or even synergistic effects were observed with these same drug combinations at high levels of cytotoxicity (i.e., at > or = 90% inhibition of colony formation). Results obtained with combinations of TPT and cisplatin varied according to the cell line examined. With A549 cells, less than additive effects were seen at low-to-intermediate levels of cytotoxicity, and more than additive effects were seen at high levels of cytotoxicity. With NCI-H82ras(H) cells, synergy was observed over most of the cytotoxicity range. CONCLUSIONS AND IMPLICATIONS: TPT cytotoxicity appears to be enhanced more by combination with certain DNA-damaging agents than by combination with antimetabolites or antimicrotubule agents. Interactions between TPT and other drugs can vary depending on the cell type examined. Further investigation is required to determine the basis of the observed effects and to determine whether these in vitro findings are predictive of results obtained in vivo.     

Prolonged tamoxifen exposure selects a breast cancer cell clone that is stable in vitro and in vivo

The effects of long-term tamoxifen exposure on cell growth and cell cycle kinetics were compared between oestrogen receptor (ER)-positive (MCF-7) and ER-negative (MDA-MB-231) cell lines. In the MCF-7 cell line, prolonged tamoxifen exposure (0.5 mumol/l for > 100 days) blocked cells in G0-G1 of the cell cycle, and slowed the doubling time of cells from 30 to 59 h. These effects corresponded to an increase in the cellular accumulation of tamoxifen over time [mean area under concentration curve (AUC) = 77.92 mumoles/10(6)/cells/day]. In contrast, in the MDA-MB-231 cell line, long-term tamoxifen exposure had no obvious effect on the doubling time, and reduced cellular tamoxifen accumulation (mean AUC = 50.50 mumoles/10(6)/cells/day) compared to the MCF-7 cells. Flow cytometric analysis of MDA-MB-231 cells demonstrated that a new tetraploid clone emerged following 56 days of tamoxifen exposure. Inoculation of the MDA-MB-231 tetraploid clone and MDA-MB-231 wildtype cells into the opposite flanks of athymic nude mice resulted in the rapid growth of tetraploid tumours. The tetraploid tumours maintained their ploidy following tamoxifen treatment for nine consecutive serial transplantations. Histological examination of the fifth transplant generation xenografts revealed that the tetraploid tumour had a 25-30 times greater mass, area of haemorrhage and necrosis, a slightly higher mitotic index and was more anaplastic than the control neoplasm. The control wildtype MDA-MB-231 tumours maintained a stable ploidy following tamoxifen treatment until the eighth and ninth transplantation, when a tetraploid population appeared, suggesting that tamoxifen treatment may select for this clone in vivo. These studies suggest that prolonged tamoxifen exposure may select for new, stable, fast growing cell clones in vitro as well as in vivo.     

GaN and AlGaN high-voltage rectifiers grown by metal-organic chemical-vapor deposition

In this paper, we report the study of the electrical characteristics of GaN and AlGaN vertical p-i-n junctions and Schottky rectifiers grown on both sapphire and SiC substrates by metal-organic chemical-vapor deposition. For GaN p-i-n rectifiers grown on SiC with a relatively thin “i” region of 2 μm, a breakdown voltage over 400 V, and forward voltage as low as 4.5 V at 100 A/cm² are exhibited for a 60-μm-diameter device. A GaN Schottky diode with a 2-μm-thick undoped layer exhibits a blocking voltage in excess of ∼230 V at a reverse-leakage current density below 1 mA/cm², and a forward-voltage drop of 3.5 V at a current density of 100 A/cm². It has been found that with the same device structure and process approach, the leakage current of a device grown on a SiC substrate is much lower than a device grown on a sapphire substrate. The use of Mg ion implantation for p-guard rings as planar-edge terminations in mesageometry GaN Schottky rectifiers has also been studied.     

Hemodynamic response to in situ latissimus dorsi muscle stimulation: implications in dynamic cardiomyoplasty

Dynamic cardiomyoplasty (DCM) involves the electrical stimulation of a pedicled latissimus dorsi muscle flap wrapped around the falling ventricle as a means of cardiac assist. To further elucidate a potential neurohumoral mechanism for improvement of cardiac output after myoplasty, we evaluated the hemodynamic effects of in situ stimulation of the latissimus dorsi muscle (in the absence of cardiomyoplasty). In seven mongrel dogs, a nerve cuff electrode (Medtronic 6901) was placed around the left thoracodorsal nerve (TDN). This was attached to a pulse generator (Medtronic, Itrel 7420), delivering a 4.0 volt, 0.19 second on, 0.81 second off, 33 Hz, 210 microsecond pulse width, cyclic bursts similar to that used in DCM. Stroke volume index (SVI) and other hemodynamic parameters as well as plasma norepinephrine (NE) levels were measured at five stages: baseline, stimulator on at 0, 2, and 5 minutes, and stimulator off at 30 minutes after. The animals were then subjected to 4 weeks of rapid pacing at 240 beats/min (Medtronic 8329) to induce heart failure, and as the rapid pacing was discontinued, measurements were repeated as above. After rapid pacing, cardiac function was significantly depressed, and NE was elevated (133 +/- 69 versus 500 +/- 353 pg/mL, p < 0.05). In the normal hearts, TDN stimulation increased SVI, heart rate, systemic pressure, and NE levels. In heart failure, however, no significant changes in cardiac function and NE levels were noted. In conclusion, our data indicate that in the normal hearts, afferent impulses from TDN stimulation alone may augment cardiac function by means of a neurohumoral effect that is not seen in severe heart failure. The implications of these findings in DCM are discussed.     

Cell-mediated immunological responses in cervical and vaginal cancer patients immunized with a lipidated epitope of human papillomavirus type 16 E7

Human papillomavirus (HPV) infection has been causally associated with cervical cancer. We tested the effectiveness of an HLA-A*0201-restricted, HPV-16 E7 lipopeptide vaccine in eliciting cellular immune responses in vivo in women with refractory cervical cancer. In a nonrandomized Phase I clinical trial, 12 women expressing the HLA-A2 allele with refractory cervical or vaginal cancer were vaccinated with four E786-93 lipopeptide inoculations at 3-week intervals. HLA-A2 subtyping was also performed, and HPV typing was assessed on tumor specimens. Induction of epitope-specific CD8+ T-lymphocyte (CTL) responses was analyzed using peripheral blood leukapheresis specimens obtained before and after vaccination. CTL specificity was measured by IFN-gamma release assay using HLA-A*0201 matched target cells. Clinical responses were assessed by physical examination and radiographic images. All HLA-A*0201 patients were able to mount a cellular immune response to a control peptide. E786-93-specific CTLs were elicited in 4 of 10 evaluable HLA-A*0201 subjects before vaccination, 5 of 7 evaluable HLA-A*0201 patients after two vaccinations, and 2 of 3 evaluable HLA-A*0201 cultures after all four inoculations. Two of three evaluable patients' CTLs converted from unreactive to reactive after administration of all four inoculations. There were no clinical responses or treatment toxicities. The ability to generate specific cellular immune responses is retained in patients with advanced cervical cancer. Vaccination with a lipidated HPV peptide epitope appears capable of safely augmenting CTL reactivity. Although enhancements of cellular immune responses are needed to achieve therapeutic utility in advanced cervical cancer, this approach might prove useful in treating preinvasive disease.     

The influence of the fabrication process on the buckling of thin-walled steel box sections

Steel box sections are usually fabricated from flat plates which are welded at the corners. The welding process can introduce residual stresses and geometric imperfections into the sections which can influence their strength. For some thin-walled sections, large periodic geometric imperfections have been observed in manufactured sections. Subsequent investigations have indicated that the imperfections are in fact buckling deformations i.e. the box section has buckled due to welding residual stresses prior to any application of external load. The welding procedure and the behaviour of the box sections under load has been modelled using a finite element analysis that accounts for both geometric and material non-linearities. Tests have been carried out on box sections with a range of width to thickness ratios for the plate elements. Modelling has been shown to give good correlation with the test results. The conditions for buckling to take place as a result of the welding process have been established. A design method has been proposed.     

GELYMAC: a Macintosh application for calculating DNA fragment size from gel electrophoresis migration data

A program called GELYMAC takes data on the distances migrated by DNA fragments in a one-dimensional electrophoretic gel and, using a cubic-spline best-fit of marker fragment distance migrated versus molecular size, calculates the molecular sizes of the fragments. Written in the Rascal (Real-time Pascal) programming language, the program runs on the Macintosh family of microcomputers. Rapid entry of marker and experimental fragment migration data is afforded using a scroll bar system adjacent to a graphic representation of a gel. Output includes tabular listing of the data, graphic cartoons of the gel, and the fragment locations and molecular sizes for individual gel lanes, and the calibration curve used in data computations.