A 0.9 V 92 dB Double-Sampled Switched-RC Delta-Sigma Audio ADC

A 0.9 V third-order double-sampled delta-sigma audio ADC is presented. A new method using a combination of a switched-RC technique and a floating switched-capacitor double-sampling configuration enabled low-voltage operation without clock boosting or bootstrapping. A three-level quantizer with simple dynamic element matching was used to improve linearity. The prototype IC implemented in a 0.13 CMOS process achieves 92 dB DR, 91 dB SNR and 89 dB SNDR in a 24 kHz audio signal bandwidth, while consuming 1.5 mW from a 0.9 V supply. The prototype operates from 0.65 V to 1.5 V supply with minimal performance degradation.     

Isothermal interphase diffusion with consecutive reactions

For multi-step heterogeneous consecutive reactions affected entirely by interphase diffusion under isothermal condition, the equations for the effectiveness factors, the surface concentrations and the point yields were derived in terms of the Damkoehler numbers or the measurables from the mass balances set up on the assumption that the mass-transfer rate balances the surface-reaction rate at steady state. From the analyses of the equations derived, the effectiveness factors for the intermediate steps and the surface concentrations of intermediates were understood to be enhanced by the measurables inclusive of the concentrations and the mass-transfer coefficients. Then the effect of the concentrations was concluded to be most significant. The effects of these measurables to the effectiveness factors and the surface concentrations were qualitatively discussed for simple consecutive reactions and also for additive consecutive reactions. Especially, as for two-step additive consecutive reactions, the effects of measurables η Da and the concentrations to the effectiveness factors were examined with graphical presentations. Finally, the brief discussion of the dependency of the Damkoehler number upon reaction time and the effect of the Renolds number and diffusivity to the extent of the mass-transfer resistance were presented.     

In situ polymerization and characterization of polyester‐based polyurethane/nano‐silica composites

Polyester‐based polyurethane/nano‐silica composites were obtained via in situ polymerization and investigated by Fourier‐transform infrared spectroscopy (FTIR), or FTIR coupled with attenuated total reflectance (FTIR‐ATR), Transmission electron microscopy (TEM), atomic force microscopy (AFM), an Instron testing machine, dynamic mechanical analysis (DMA) and ultraviolet‐visible spectrophotometry (UV‐vis). FTIR analysis showed that in situ polymerization provoked some chemical reactions between polyester molecules and nano‐silica particles. FTIR‐ATR, TEM and AFM analyses showed that both surface and interface contained nano‐silica particles. Instron testing and DMA data showed that introducing nano‐silica particles into polyurethane enhanced the hardness, glass temperature and adhesion strength of polyurethane to the substrate, but also increased the resin viscosity. UV‐vis spectrophotometry showed that nano‐silica obtained by the fumed method did not shield UV radiation in polyurethane films. Copyright © 2003 Society of Chemical Industry     

地基设计基本原则的探讨

地基设计是整个建（构）筑物设计中的重要组成部分，它关系到建（构）筑物的安全及其功能能否正常发挥。本文着重分析探讨了在地基设计中应遵循的原则及注意事项。以保证建（构）筑物的安全和正常使用，充分发挥地基的作用。     

焊接史

本文追溯了19世纪末发明的电弧焊接的历史。当Oscar Kjellberg成立伊萨公司以探索他发明的涂层焊条时，伊萨从一开始就和电弧焊的发展结下了不解之缘。     

丰满流域可能最大暴雨与可能最大洪水分析研究

依据丰满漉域的水文气象资料,计算丰满流域可能最大暴雨,推求白丰区间的可能最大洪水并进行成果合理性分析.     

Multistage amplifier topologies with nested Gm-Ccompensation

This paper presents a multistage amplifier for low-voltage applications (<2 V). The amplifier consists of simple (noncascode) low gain stages and is stabilized using a nested transconductance-capacitance compensation (NGCC) scheme. The resulting topology is similar to the well known nested Miller compensation (NMC) multistage amplifier, except that the proposed topology contains extra G _m feedforward stages which are used to enhance the amplifier performance. The NGCC simplifies the transfer function of the proposed multistage amplifier which, in turn, simplifies its stability conditions. A comparison between the NGCC and NMC shows that the NGCC has wider bandwidth and is easier to stabilize. A four-stage NGCC amplifier has been fabricated using a 2-μm CMOS process and is tested using a ±1.0 V power supply. A dc gain of 100 dB has been measured. A gain bandwidth product of 1 MHz with 58° of phase margin and power of 1.4 mW can be achieved. The op amp occupies an active area of 0.22 mm². Step response shows that the op amp is stable