Stress distribution in thick-walled cylinder due to non-uniform radial pressure on the example of reinforcement corrosion in concrete

This paper presents an analytical solution to the non-uniform pressure on thick-walled cylinder. The formulation is based on the linear elasticity theory (plain strain) and stress function method. As an example, the proposed solution is used to model the stress distribution due to non-uniform steel reinforcement corrosion in concrete. The model is formulated considering different scenarios of corrosion pressure distribution. It is validated against the finite element model for different cases of non-uniform pressure distributions. The results show that the corrosion-induced cracks are likely to start just beyond the anodic zone. This is confirmed by the experimental tests on concrete cylinder exposed to non-uniform accelerated corrosion of steel reinforcement. The model can be effectively used to calculate the distribution of corrosion-induced stresses in concrete.     

Application of chitosan–alginate microspheres for the sustained release of bacteriophage in simulated gastrointestinal conditions

This study was designed to evaluate the acid stability, release property and antimicrobial efficacy of Escherichia coli O157:H7 bacteriophages encapsulated in chitosan–alginate microspheres under the simulated gastrointestinal conditions. The bacteriophages belonging to Myoviridae family were stable at the pH above 4 in trypticase soy broth. The chitosan–alginate microspheres exhibited protective effect on the viability of bacteriophages in the simulated gastric conditions at pH 2.0 and pH 2.5, showing 4.8 and 5.6 log PFU mL^‐1, respectively, after 1 h of incubation at 37 °C. The release per cent of bacteriophages from microspheres gradually increased up to 65% in the simulated intestinal condition (pH 7.5) at 37 °C for 6 h. The lytic efficacy of chitosan‐ and alginate‐encapsulated bacteriophages against E. coli O157:H7 was significantly maintained in the simulated intestinal conditions to 10 h of incubation (1.3 log reduction). The results suggest that the chitosan–alginate microspheres can be used as a reliable delivery system for bacteriophages.     

Inferring kinetic dissolution of NaCl in aqueous glycol solution using a low-cost apparatus and population balance model

An experimental methodology for inferring brine dissolution rate in monoethylene glycol (MEG) solutions at different temperatures using a webcam combined with a mathematical model is presented. The measurement system is designed to track the RGB (red, green, and blue) colour variations during the dissolution process. A dynamic model augmented with the population balance equation is applied to describe the dissolution process. Moreover, the dissolution rate is consistently related to the temperature and MEG concentration through the driving force based on the Gibbs energy and chemical affinity. The applied low-cost measurement apparatus proved to be a useful resource for tracking the dissolution dynamics in a wide range of undersaturation.     

Clarification of a wheat straw‐derived medium with ion‐exchange resins for xylitol crystallization

BACKGROUND: Xylitol bioproduction from lignocellulosic residues comprises hydrolysis of the hemicellulose, detoxification of the hydrolysate, bioconversion of the xylose, and recovery of xylitol from the fermented hydrolysate. There are relatively few reports on xylitol recovery from fermented media. In the present study, ion‐exchange resins were used to clarify a fermented wheat straw hemicellulosic hydrolysate, which was then vacuum‐concentrated and submitted to cooling in the presence of ethanol for xylitol crystallization. RESULTS: Sequential adsorption into two anion‐exchange resins (A‐860S and A‐500PS) promoted considerable reductions in the content of soluble by‐products (up to 97.5%) and in medium coloration (99.5%). Vacuum concentration led to a dark‐colored viscous solution that inhibited xylitol crystallization. This inhibition could be overcome by mixing the concentrated medium with a commercial xylitol solution. Such a strategy led to xylitol crystals with up to 95.9% purity. The crystallization yield (43.5%) was close to that observed when using commercial xylitol solution (51.4%). CONCLUSION: The experimental data demonstrate the feasibility of using ion‐exchange resins followed by cooling in the presence of ethanol as a strategy to promote the fast recovery and purification of xylitol from hemicellulose‐derived fermentation media. Copyright © 2008 Society of Chemical Industry     

Enhancement mode InP MISFET's with sulfide passivation andphoto-CVD grown P3N5 gate insulators

High performance enhancement mode InP MISFET's have been successfully fabricated by using the sulfide passivation for lower interface states and with photo-CVD grown P₃N₅ film used as gate insulator. The MISFET's thus fabricated exhibited exhibited pinch-off behavior with essentially no hysteresis. Furthermore the device showed a superior stability of drain current. Specifically under the gate bias of 2 V for 10⁴ seconds the room temperature drain current was shown to reduce from the initial value merely by 2.9% at the drain voltage of 4 V. The effective electron mobility and extrinsic transconductance are found to be about 2300 cm ²/V·s and 2.7 mS/mm, respectively. The capacitance-voltage characteristics of the sulfide passivated InP MIS diodes show little hysteresis and the minimum density of interface trap states as low as 2.6×10¹⁴/cm² eV has been attained     

Pressure effects on flow and fracture of Be-Al alloys

The flow and fracture behavior of Be-Al alloys were determined in tension with different levels of superimposed pressure. The Be-Al alloys were prepared by Brush Wellman, Inc. (Cleveland, OH) from prealloyed powders processed to either a hot isostatically pressed (“hipped”) or cold isostatically pressed and extruded condition. Significant effects of pressure on both the flow and ductility have been observed at room temperature, with implications on the formability of these materials. The effects of changes in processing conditions and stress state on the flow and fracture behavior are summarized in addition to both optical and scanning electron microscopy (SEM) examination of the fracture surfaces. Separate other studies on the alloy constituents (e.g., Al and Be) are also reported. The results are also compared to previous works on monolithic materials and composites tested with high pressure.     

Spatial learning deficits in mice with a targeted glucocorticoid receptor gene disruption

Previous studies in rats using the Morris water maze suggested that the processing of spatial information is modulated by corticosteroid hormones through mineralocorticoid and glucocorticoid receptors in the hippocampus. Mineralocorticoid receptors appear to be involved in the modulation of explorative behaviour, while additional activation of glucocorticoid receptors facilitates the storage of information. In the present study we used the water maze task to examine spatial learning and memory in mice homozygous and heterozygous for a targeted disruption of the glucocorticoid receptor gene. Compared with wild-type controls, homozygous and heterozygous mice were impaired in the processing of spatial but not visual information. Homozygous mutants performed variably during training, without specific platform-directed search strategies. The spatial learning disability was partly compensated for by increased motor activity. The deficits were indicative of a dysfunction of glucocorticoid receptors as well as of mineralocorticoid receptors. Although the heterozygous mice performed similarly to wild-type mice with respect to latency to find the platform, their strategy was more similar to that of the homozygous mice. Glucocorticoid receptor-related long-term spatial memory was impaired. The increased behavioural reactivity of the heterozygous mice in the open field points to a more prominent mineralocorticoid receptor-mediated function. The findings indicate that (i) the glucocorticoid receptor is of critical importance for the control of spatial behavioural functions, and (ii) mineralocorticoid receptor-mediated effects on this behaviour require interaction with functional glucocorticoid receptors. Until the development of site-specific, inducible glucocorticoid receptor mutants, glucocorticoid receptor-knockout mice present the only animal model for the study of corticosteroid-mediated effects in the complete absence of a functional receptor.