Hot corrosion Type II of FeCr‐based model alloys for boiler and heat exchanger applications

The hot corrosion Type II of the alloys FeCr20, FeCr20Ni10, FeCr20Ni20, and FeCr20Co10 is investigated at 700°C in air + 0.5% SO₂ with deposits consisting of Na₂SO₄ and a eutectic mixture of Na₂SO₄ and MgSO₄ for 24, 100, and 300 h. The alloying elements nickel and cobalt have a positive influence when tests are conducted using a MgSO₄‐Na₂SO₄ deposit. In this case, they reduce the metal loss and increase the time to the propagation stage. In contrast, when the alloys are exposed with a Na₂SO₄ deposit, these alloying elements increase the metal loss and allow for the transition to the propagation stage because they can form molten phases with the Na₂SO₄. During the incubation stage an oxide scale forms on the FeCr20 alloy, which is thicker than the one formed during exposure without a deposit, and iron oxides are observed, which precipitate in the deposit. The propagation stage occurs by a dissolution and precipitation mechanism forming localized pitting attack. Iron is the main species that dissolves and precipitates, while chromium remains mainly as an oxide beneath the initial surface. The additional elements are found in the pit and in the salt deposit.     

Accurate estimation of capacities and cross-traffic of all links in a path using ICMP timestamps

The estimation of the link capacity and its available bandwidth in an end-to-end path is crucial for network management, admission control and flow control for adaptive applications. This paper introduces an estimation mechanism able to accurately estimate the available bandwidth of all links in an end-to-end path, through its capacity and cross-traffic estimation. The estimation procedures resort to the dispersions of packet pairs and trains using the concepts of ICMP Timestamp and Traceroute that, efficiently used together, enable the measurement of the dispersions in all links in the path. These mechanisms were evaluated through simulation experiments, where we analyzed the influence of the several network parameters on each estimation mechanism. The results show that these estimation methods are able to accurately estimate both the capacity and the cross-traffic of all links in a path with moderate length and with low overhead.     

Synthesis of N,N-diethyl-N-{4-[(E)-(4-nitrophenyl)diazenyl]phenyl}amine via in situ diazotisation and coupling in supercritical carbon dioxide

The synthesis of azo dyes via a conventional aqueous-based diazotisation and coupling reaction requires the use of relatively high concentrations of mineral acids, which leads to high electrolyte concentrations in wastewater. Reported in this paper is an environmentally benign one-pot method for the synthesis of a nonionic azo dye, N,N -diethyl- N -{4-[( E )-(4-nitrophenyl)diazenyl]phenyl}amine, in supercritical carbon dioxide without using a mineral acid. The product yield increased significantly with temperature, with 91% theoretical yield afforded at 80 °C. The pressure of the system had little influence on product yield.     

Atmospheric corrosion of reference metals in Antarctic sites

This paper presents the results obtained at three Antarctic test sites participating in the “Ibero-American Map of Atmospheric Corrosiveness” (MICAT), a project on atmospheric corrosion carried out during the period 1988–1994 at some 70 sites distributed across 12 countries of the Latin-American region, Spain and Portugal. The three Antarctic sites are located near the coastline.The singular climatic characteristics of Antarctic regions are related with the purity of the air, the absence of rainfall and the formation of ice on the metallic surface during an important part of the exposure time. However, electrochemical activity is possible below ice layers. This situation affects the structure and morphology of corrosion product films and the resulting corrosion rates of metallic surfaces.     

Mechanical improvement of concrete by irradiated polypropylene fibers

Fiber reinforced concrete (FRC) contains fibers physically mixed with gravel, sand, cement, and water. So far, adequate mechanical performance of FRC has been obtained at high cost and using complex technologies; important here is the geometry and surface characteristics of the polymers. We have modified polymeric‐fiber surfaces by using gamma radiation. Irradiated polypropylene (PP) fibers were submitted to 0, 5, 10, 50, and 100 kGy of gamma irradiation dosages. First, tensile strength of PP fibers was evaluated, and then fibers blended at 0, 1.0, 1.5, and 2.0% in volume with Portland cement, gravel, sand, and water. The highest values of compressive strength were obtained with irradiated‐fibers at 10 kGy and 1.5% in volume of fiber. The result is 101 MPa, as compared to 35 MPa for simple concrete without fibers. POLYM. ENG. SCI., 45:1426–1431, 2005. © 2005 Society of Plastics Engineers     

Dynamics of [Ca2+] in the endoplasmic reticulum and cytoplasm of intact HeLa cells. A comparative study

We have measured the [Ca2+] in the endoplasmic reticulum ([Ca2+]er) of intact HeLa cells at both 22 degrees C and 37 degrees C using endoplamsic reticulum-targeted, low Ca2+ affinity aequorin reconstituted with coelenterazine n. Aequorin consumption was much slower at 22 degrees C, and this allowed performing a much longer study of the dynamics of [Ca2+]er. The steady-state [Ca2+]er (500-600 microM) was not modified by the temperature, although both the rates of pumping and leak were decreased at 22 degrees C. The behavior of both [Ca2+]er and cytoplasmic [Ca2+] ([Ca2+]c) after the addition of increasing concentrations of agonists and/or Ca2+-ATPase inhibitors, or following incubation in Ca2+-free medium were compared. We show that agonists induce a fast but relatively small decrease in [Ca2+]er, which is enough to produce a sharp increase in [Ca2+]c. Termination of Ca2+ release is controlled by feedback inhibition of the inositol 1,4,5-trisphosphate receptors by [Ca2+]c, a mechanism that appears to be designed to release the minimum amount of Ca2+ necessary to produced the required [Ca2+]c signal. We also show that Ca2+ release is inhibited progressively when [Ca2+]er decreases below a threshold of about 150 microM, even in the absence of Ca2+ pumping or -Ca2+-c increase. This effect is consistent with a regulation of the inositol 1,4,5-trisphosphate-gated channels by [Ca2+]er.     

Do individual factors matter? A survey of scientists’ patenting in Portuguese public research organisations

This paper addresses scientists’ behaviour regarding the patenting of knowledge produced in universities and other public sector research organisations (PSROs). Recent years have witnessed a rapid growth in patenting and licensing activities by PSROs. We argue that the whole process depends to a certain extent on scientists’ willingness to disclose their inventions. Given this assumption, we conduct research into individual behaviour in order to understand scientists’ views concerning the patenting of their research results. Data from a questionnaire survey of Portuguese researchers from nine PSROs in life sciences and biotechnology is presented and analysed and complemented with in-depth interviews. The results reveal that overall the scientists surveyed show a low propensity to become involved in patenting and licensing activities, despite the fact that the majority had no “ethical” objections to the disclosure of their inventions and the commercial exploitation of these. Perceptions about the impacts of these activities on certain fundamental aspects of knowledge production and dissemination are however divergent. This may account for the low participation levels. Furthermore, most scientists perceived the personal benefits deriving from this type of activity to be low. Similarly, the majority also believed that there are many difficulties associated with the patenting process and that they receive limited support from their organisations, which lack the proper competences and structures to assist with patenting and licensing.     

Medium and substitution pattern effects on the action of hydroxyflavones as photoprotectors against singlet molecular oxygen-mediated photooxidation of fats

The ability of mono-, di-, tri-and tetra-hydroxyflavones (7-and 3-hy-droxyflavones, 7, 8-dihydroxyflavone, baicalein and fisetin) to act as photoprotectors against singlet molecular oxygen [O²(Δ_g)]-initiated photooxidation of fats has been established by a kinetic study. The overall quenching rate constants for a series of five hydroxyflavones perfectly parallel their respective behaviour as inhibitors of the sensitized photooxidation of linoleic acid. The best antioxidative effect was exerted by 7-hydroxyflavone which does not chemically react with O²(¹Δ_g). Nevertheless for the remaining flavonoids of the series, the physical deactivation of O²(¹Δ_g) largely prevails over the chemical process. As for the cases of phenols and related hydroxy-aromatic derivatives, the ionization of the -OH group in the flavones, dramatically accelerates the rate of photooxidation. Under these conditions, the 7-hydroxyflavone also reacts effectively with O²(¹Δ_g). Given that flavonoids are natural oil components, this medium effect should be taken into account during the oil-refining process, in order to avoid the flavonoid photodestruction.     

On the use of tapered linearly chirped gratings asdispersion-induced distortion equalizers in SCM systems

We report on the use of tapered linearly chirped fiber gratings to equalize dispersion-induced distortion in long distance/broad-band subcarrier multiplexed (SCM) systems. Different apodization functions for the coupling factor of the fiber grating have been considered and their equalizing capability of fiber-induced distortion in a subcarrier system have been compared. The results of the theoretical analysis show that both harmonic and intermodulation distortions are significantly reduced when the equalizer parameters have been properly designed. Higher reduction of the nonlinear distortion is obtained when the length of the filter increases, even though a saturation effect on this reduction figure appears when the equalizer length is about four or five times its minimum value to achieve equalization, which is derived theoretically based on the SCM optical system parameters. The performance of a Tanh-type tapered linearly chirped grating equalizer on a realistic broadband SCM system is also considered. The results reveal that the dispersion-induced distortion can be neglected when the equalizer is employed