Controlling thickness to tune performance of high-mobility transparent conducting films deposited from Ga-doped ZnO ceramic target

Structure modification has been found to tune significantly the transparent-conducting performance, especially mobility and conductivity of hydrogenated Ga-doped ZnO (HGZO) films. The strong correlation between film thickness and mobility of the films is revealed. The mobility increases quickly with increasing the thickness from 350 to 900 nm, and then tends to be saturated at further thicknesses. A higher mobility than 50 cm²/Vs can be achieved, which is an extra-high value for polycrystalline ZnO films deposited by using the sputtering technique. The thickness-dependent mobility originates from scatterings on grain boundaries and dislocation-induced defects controlled by thin-film growth. Based on the Volmer-Weber model, an expansion model is built up to describe the thickness-dependent crystal growth of the HGZO films, especially at the thick films. As a result, the 800 nm-thick HGZO film obtains the highest performance with high mobility of 51.5 cm²/Vs, low resistivity of 5.3 × 10^?4 Ωcm, and good transmittance of 83.3 %.     

Negation as failure for disjunctive logic programming

We generalize the Negation-as-Failure procedure for disjunctive logic programming. Then we compare our method with related methods in the literature. We also propose a new completion theory for disjunctive logic programs which allows some program clauses to have inclusive meaning and the others exclusive meaning.     

Physical Aging of Amorphous Fructose

ABSTRACT: Physical aging of amorphous anhydrous fructose at temperature 5 °C and at 22 °C was studied using differential scanning calorimetry (DSC). The dynamic glass transition temperature, T_g0 for unaged samples was 16 °C and 13.3 °C for heating rate of 10 °C/min and 1 °C/min, respectively. The fictive temperature, T_f0 for unaged samples calculated by Richardson and Savill method was 12 °C, which is close to the dynamic value obtained from the lower DSC heating rate. The fictive temperature T_f of the aged fructose glasses at temperatures both below and above the transition region was fitted well by a non-exponential decay function (Williams-Watts form). Aging above the transition region (22 °C) for 18 d increased both the dynamic glass transition temperature T_g and the fictive temperature T_f. However, aging below the transition region (5 °C) for 1 d increased the dynamic glass transition temperature T_g but decreased the fictive temperature T_f.     

Algebraic decoding of (103, 52, 19) and (113, 57, 15) quadratic residue codes

In this paper, two algebraic decoders for the (103, 52, 19) and (113, 57, 15) quadratic residue codes, which have lengths greater than 100, are presented. The results have been verified by software simulation that programs in C++ language have been executed to check possible error patterns of both quadratic residue codes.     

Study of lithium intercalation into tungsten oxide films prepared by different methods

The interaction of lithium atoms into amorphous tungsten oxide films deposited by thermal evaporation, sputtering and sol-gel synthesis is studied spectroscopically. The mechanism of insertion of lithium into the film depends on the amount and the bonding state of water to the tungsten oxide network. Thermally evaporated tungsten oxide film contains water bonded chemically in the form of a hydrogen tungsten bronze which facilitates the accommodation of a high number of lithium atoms. In the sputtered film, water is physisorbed and the lithiation is incomplete. Tungsten oxide films prepared by sol-gel synthesis have structural water molecules directly involved in the lithiation process. The formation of lithium tungstate independent of the preparation method is demonstrated.     

Coating of carbon-fiber surface by silicon carbide via sol-gel mixtures of tetraethyl orthosilicate and phenolic resin

The preparation of a SiC coating on a carbon fiber surface using a sol-gel mixture of tetraethyl orthosilicat (TEOS) and phenolic resin was studied. FTIR and SEM investigations indicated that the SiC coating can be formed by carbothermal reduction of the sol-gel mixture at 1420°C for 15–20 min in an argon atmosphere. TGA of the coated fiber was also performed, showing that the SiC coating improves the thermooxidative stability of the carbon fiber. With the thickness of the obtained coating of 0.47 μm using a C/Si ratio of 4, this treatment does not affect the carbon fiber strength.     

Performance analysis of a COFDM/FM in-band digital audiobroadcasting system

In this paper, we present a performance analysis of a coded orthogonal frequency division multiplexing DAB system that is power multiplexed over a commercial FM station. We model the mobile channel with a time-frequency scattering function. Results show that the performance of the FM demodulator is crucial, since the level of the residual FM signal has a strong influence on the BER performance of the COFDM system. As with other mobile communication systems, the use of interleaving greatly enhances the performances     

Automated zebrafish chorion removal and single embryo placement: optimizing throughput of zebrafish developmental toxicity screens

The potential of the developing zebrafish model for toxicology and drug discovery is limited by inefficient approaches to manipulating and chemically exposing zebrafish embryos-namely, manual placement of embryos into 96- or 384-well plates and exposure of embryos while still in the chorion, a barrier of poorly characterized permeability enclosing the developing embryo. We report the automated dechorionation of 1600 embryos at once at 4 h postfertilization (hpf) and placement of the dechorionated embryos into 96-well plates for exposure by 6 hpf. The process removed ≥95% of the embryos from their chorions with 2% embryo mortality by 24 hpf, and 2% of the embryos malformed at 120 hpf. The robotic embryo placement allocated 6-hpf embryos to 94.7% ± 4.2% of the wells in multiple 96-well trials. The rate of embryo mortality was 2.8% (43 of 1536) from robotic handling, the rate of missed wells was 1.2% (18 of 1536), and the frequency of multipicks was <0.1%. Embryo malformations observed at 24 hpf occurred nearly twice as frequently from robotic handling (16 of 864; 1.9%) as from manual pipetting (9 of 864; 1%). There was no statistical difference between the success of performing the embryo placement robotically or manually.     

Investigation of long term drift of an intraocular pressure sensor

Microsystem Technologies - “Zero drift” behavior of an optical intraocular pressure sensor is studied using an analytical model based on the deflection of a circular membrane. Results...