A parallel elliptic curve crypto-processor architecture with reduced clock cycle for FPGA platforms

The Journal of Supercomputing - The Elliptic curve cryptosystem is a public-key cryptosystem that receives more focus in recent years due to its higher security with smaller key size when compared...     

Interaction of Ir and IrO2 thin films with polysilicon,W and WSIx

Abstract

Ir and IrO₂ thin films have been identified as potential electrode materials for ferroelectric capacitors. These electrodes have shown excellent electrical characteristics. The integration of ferroelectric capacitors into memory cell requires the bottom electrode material to be placed directly over a contact plug. This paper studies the interaction of Ir and IrO₂ with commonly used plug materials such as polysilicon, tungsten (W), and tungsten silicide (WSi_x) after a post-deposition annealing at 800°C. Film properties such as composition, resistivity, crystallinity, adhesion, and micro-structure have been examined before and after anneal. The results show that W is a possible plug material for Ir electrode; while polysilicon and WSi_x are potential candidates if IrO₂ electrodes are used.     

Optimal Algorithms for Load Balancing in Optical Burst Switching Networks

Data packet drop can happen in Optical Burst-Switched (OBS) when two data bursts are competing on the same wavelength. Recently, many techniques have been developed to solve this problem but they do not consider the congestion. Also, it is necessary to balance the load system in the OBS network. The Ant Colony Optimization (ACO) technique can be applied to determine the straight and the safest route. However, the ACO technique raises both power utilization as well as the execution time. In this study, Cuckoo Search (CS) and ACO methods based approach is proposed to avoid the congestion and load balancing in the OBS network. This strategy evaluates the intensity of hotspot data and then launches the congestion rate optimization process that depends on their load situations. The congestion rate optimization represents the available bandwidth, data distribution rate, queue size, and access rate, and also these factors are optimized through the CS technique. The fitness utility in the CS technique adjusts the distribution rate in the OBS network, and the proposed ACO technique solves the energy utilization problem. The simulation results proved that the presented strategy evades both the end-to-end delay as well as the possibility of packet drop.     

The effects of forming gas anneal on the electrical characteristics of ir-electroded BST thin film capacitors

Abstract

The effect of various temperature nitrogen anneals prior to top electrode deposition on the ability of Ba_0.7Sr_0.3TiO₃ (BST) thin-film capacitors with both Ir and Pt top electrodes to withstand hydrogen damage was investigated. Experimental results show that samples that underwent a 750 °C N₂ pre-top electrode anneal exhibited the lowest leakage current density at positive bias for both Ir- and Pt-electroded devices after forming gas anneal. It was also found that DRAM polarization values decreased slightly after forming gas anneal. Also, a post-top electrode deposition 550°C O₂ anneal improved both electrical characteristics (lowered leakage and increased DRAM polarization) of these devices. Complete recovery of the leakage level prior to hydrogen damage was obtained after a 550°C N₂ recovery anneal for some devices independent of the pre-top electrode anneal. Ir- and Pt-electroded BST (40nm) capacitors have been shown to meet the 1 giga-bit DRAM leakage current requirement of 10^?8 A/cm² at 1.7 V. These Ir- and Pt-electroded BST devices achieved capacitance density levels of approximately 50 fF/μm².