Low-temperature synthesis of SiC nanowires with Ni catalyst

SiC nano wires were fabricated on the silicon substrate dipped with a layer of Ni catalyst at 900 ℃ by gas pressure annealing processing. The morphologies and crystal structures were determined by scanning electron microscopy(SEM), transmission electron microscopy(TEM)and X-ray diffraction(XRD). The results show that the assynthesized nanowires are β-SiC single crystalline with diameter range of 50-100 nm, and length of tens of micron by directly annealing at 900 ℃. The SiC nano wires grow along the [111] direction with highly uniform morphology. And the possible growth mechanism of SiC nano wires is proposed.The present work provides an efficient strategy for the production of high-quality SiC nano wires.     

A novel InP/InGaAs TEBT for ultralow current operations

A novel InP/InGaAs tunneling emitter bipolar transistor (TEBT) is fabricated and demonstrated. The studied device exhibits a very small collector-emitter offset voltage of 40 mV and an extremely wide operation regime. The operation region is larger than 11 decades in magnitude of collector current (10/sup -12/ to 10/sup -1/A). A current gain of 3 is obtained even if the device is operated at an ultralow collector current of 3.9 /spl times/ 10/sup -12/A (1.56 /spl times/ 10/sup -7/A/cm/sup 2/). Furthermore, the common-emitter breakdown voltage of the studied device is higher than 2 V. Consequently, the studied device shows a promise for low supply voltage, and low-power consumption circuit applications.     

双乙醛草酰二肼直接快速光度法测定食品中痕量铜

研究了双乙醛草酸二肼与铜的显色反应，建立了分光光度法直接测定铜的新方法。试验结果表明，在pH8．0－10．0范围内，Cu2 与双乙醛草酸二肼形成稳定的紫红色配合物。该配合物在540nm处有一最大吸收峰，其表明摩尔吸光系数为2．4×104，铜量在0－12mg／50ml范围内符合比尔定律。共存离子干扰，误差仅 2.00％。用于食品中痕量钢测定．结果准确、可靠。     

香豆胶衍生物的化学结构及稳定性研究

将市售商品溶于水,用异丙醇沉析提纯,溶于0.1 mol/L NaNO3纯水溶液中,经0.5μm滤膜过滤后用水相凝胶渗透色谱法(GPC)测定,测得香豆胶(FG)、羟丙基香豆胶(HPFG)、阳离子香豆胶(CFG)的数均、重均相对分子质量Mn、Mw分别为:1.19×105、3.36×105,8.52×104、2.85×105,9.33×104、2.87×105。用甘露聚糖链在碱性条件下醚化时发生降解,解释两种改性FG的相对分子质量较FG低而多分散性(Mw/Mn)较FG高的测试结果。认为商品FG的1%水溶液黏度(1300 mPa.s)高于商品HPFG和CFG(分别为705和610 mPa.s)的原因是前者相对分子质量较高且残渣含量也较高(~10%,后二者为1%~2%)。HPFG的取代度为0.12,根据文献发表的13C-NMR数据确认HPFG分子链上羟丙基取代位置为C6。讨论了香豆胶(半乳甘露聚糖)的化学结构。热重分析法测定的热稳定性,HPFG高于CFG,CFG又高于FG。图6表3参13。     

Channel-carrier mobility parameters for 4H SiC MOSFETs

In this paper, mobility parameters for enhancement-mode N-channel 4H SiC MOSFETs are extracted and implemented into 2-D device simulation program and SPICE circuit simulator. The experimental data were obtained from lateral N-channel 4H SiC MOSFETs with nitrided oxide–semiconductor interfaces, exhibiting normal mobility behavior. The presence of increasing interface-trap density (D_it) toward the edge of the conduction band is included during the 2-D device simulation. Using measured distribution of interface-trap density for simulation of the transfer characteristics leads to a good agreement with the experimental transfer characteristic.     

A Web‐based and Group Learning Environment for Introductory Environmental Engineering

The use of computer‐based technology is becoming more prevalent in the classroom. As a part of an educational research project sponsored by the GE Foundation, strategies for augmenting a course, Introduction to Environmental Engineering (CE 280), were investigated including cross‐disciplinary experiences in teamwork, design, and the use of advanced teaching technologies such as the web. Interactive tools to assist student learning were developed and refined. Efforts have focused on developing an extensive website, web‐based quizzes and homework assignments, and tutorials. Base groups were used to provide both intellectual and emotional support to students. This paper summarizes the development of this course and the impact of rapid feedback on the progression of student understanding.     

Organic‐acid‐catalyzed sol–gel route for preparing poly(methyl methacrylate)–silica hybrid materials

In this study, a series of organic–inorganic hybrid sol–gel materials consisting of a poly(methyl methacrylate) (PMMA) matrix and dispersed silica (SiO₂) particles were successfully prepared through an organic‐acid‐catalyzed sol–gel route with N‐methyl‐2‐pyrrolidone as the mixing solvent. The as‐synthesized PMMA–SiO₂ nanocomposites were subsequently characterized with Fourier transform infrared spectroscopy and transmission electron microscopy. The solid phase of organic camphor sulfonic acid was employed to catalyze the hydrolysis and condensation (i.e., sol–gel reactions) of tetraethyl orthosilicate in the PMMA matrix. The formation of the hybrid membranes was beneficial for the physical properties at low SiO₂ loadings, especially for enhanced mechanical strength and gas barrier properties, in comparison with the neat PMMA. The effects of material composition on the thermal stability, thermal conductivity, mechanical strength, molecular permeability, optical clarity, and surface morphology of the as‐prepared hybrid PMMA–SiO₂ nanocomposites in the form of membranes were investigated with thermogravimetric analysis, differential scanning calorimetry, dynamic mechanical analysis, gas permeability analysis, ultraviolet–visible transmission spectroscopy, and atomic force microscopy, respectively. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

6LoWPAN在物联网中的应用仿真

提出了一种基于6LoWPAN的物联网总体方案,同时对协议中的Mesh字段进行了改进,然后在网络模拟环境下对本协议平均传输成功率、平均延迟时间的性能进行了比较分析,并在仿真环境中进行了实验验证工作。实验数据表明,改进后的协议具有更好的性能。     

Data preprocessing using hybrid general regression neural networks and particle swarm optimization for remote terminal units

Data corruption in SCADA systems refers to errors that occur during acquisition, processing, or transmission, introducing unintended changes to the original data. In SCADA-based power systems, the data gathered by remote terminal units (RTUs) is subject to data corruption due to noise interference or lack of calibration. In this study, an effective approach based on the fusion of the general regression neural network (GRNN) and the particle swarm optimization (PSO) technique is employed to deal with errors in RTU data. The proposed hybrid model, denoted as GRNN-PSO, is able to handle noisy data in a fast speed, which makes it feasible for practical applications. Experimental results show the GRNN-PSO model has better performance in removing the unintended changes to the original data compared with existing methods.