The First Template‐Free Growth of Crystalline Silicon Microtubes

A simple template‐free high‐temperature evaporation method was developed for the growth of crystalline Si microtubes for the first time. As‐grown Si microtubes were characterized using X‐ray diffraction, scanning electron microscopy, transmission electron microscopy, and room‐temperature photoluminescence. The lengths of the Si tubes can reach several hundreds of micrometers; some of them have lengths on the order of millimeters. Each tube has a uniform outer diameter along its entire length, and the typical outer diameter is ≈ 2–3 μm. Most of the tubes have a wall thickness of ≈ 400–500 nm, though a considerable number of them exhibit a very thin wall thickness of ≈ 50 nm. Room‐temperature photoluminescence measurement shows the as‐synthesized Si microtubes have two strong emission peaks centered at ≈ 589 nm and ≈ 617 nm and a weak emission peak centered at ≈ 455 nm. A possible mechanism for the formation of these Si tubes is proposed. We believe that the present discovery of the crystalline Si microtubes will promote further experimental studies on their physical properties and smart applications.     

SCB火工品的研究与发展

文章评述了半导体桥火工品问世以来的研究成果与发展趋势。主要内容有半导体桥作用机理、半导体桥的结构与封装、半导体桥火工品的特点、半导体桥火工品的应用、半导体桥火工品的研究和发展趋势。     

合成吡啶类化合物用催化剂的再生行为研究

对合成吡啶类化合物用的失活催化剂上的结焦物进行了元素分析 ,并着重对失活催化剂的再生行为进行了研究。得到了不同失活程度催化剂的再生曲线及相同失活程度、不同再生条件下的再生曲线。经回归求得了一简单的再生反应动力学经验方程式 ,其中反应级数为碳含量的 1.16 5级 ,活化能为 4 2 .5 72kJ/mol,计算值与实验值的平均相对误差为 6 .5 %。     

A new efficient method for one‐pot conversions of aryl carboxylic acids into nitriles without solvent

A new efficient method for synthesising nitriles, important organic reagents, is reported in this paper. In an environmentally benign solvent‐free system, aryl carboxylic acids were converted into the corresponding nitriles via one‐pot reactions, by amidation with ethyl carbamate followed by dehydration with thionyl chloride, in excellent yields. The results showed that the method has the advantages of lower cost, higher yield, less pollution and greater ease of work‐up. Copyright © 2008 Society of Chemical Industry     

Modeling wireless fading channels via stochastic differential equations: identification and estimation based on noisy measurements

This paper is concerned with modeling and identification of wireless channels using noisy measurements. The models employed are governed by stochastic differential equations (SDEs) in state space form, while the identification method is based on the expectation-maximization (EM) algorithm and Kalman filtering. The algorithm is tested against real channel measurements. The results presented include state space models for the channels, estimates of inphase and quadrature components, and estimates of the corresponding Doppler power spectral densities (DPSDs), from sample noisy measurements. Based on the available measurements, it is concluded that state space models of order two are sufficient for wireless flat fading channel characterization.     

镍氢电池负极用低成本储氢合金的研究

研究了ABS型储氢合金在低Co含量条件下，随B组元替代元素Co，Al，Si等含量的变化对合金电化学性能的影响规律，同时研究了A组元中不同La／Ce比对合金电化学性能的影响情况。结果表明，随合金中Co含量的降低，合金的活化性能和放电容量得以改善，但合金的循环寿命下降也比较明显；在试验范围内，随Al元素的加入，合金的循环寿命得以改善，但材料的放电容量和活化性能均有所下降；随合金La／Ce比的降低，合金的放电容量略有下降，但其循环寿命和放电电压平台有较大提高。     

智能工作站主机的MMPIS实验模型研究──一个全互连式结构MMPIS硬件环境的设计与实现

本文介绍中日国际合作开发研究的Ａ１型智能网（Ａ１型ＩＮ）智能工作站（ＩＷ）主机的并行推理硬件结构的实验模型设计与实现，给出了一种并行推理硬件支持环境实现方案和该方案在实现中若干问题的解决方法。     

大功率CO_2激光器非平衡态合成WO_3／Fe_2O_3新型陶瓷催化剂──Ⅱ．WO_3／Fe_2O_3烯烃歧化反应催化剂的催化活性

用大功率ＣＯ２激光器熔制ＷＯ３／Ｆｅ２Ｏ３新型烯烃歧化反应催化剂。考查了催化剂组成、激光功率及熔炼时间与丙烯歧化反应催化活性之间的关系。     

分子振动态及其跃迁的激光相干控制

讨论了激光合成相干叠加态的原理及其性质 ,针对 XY2 型分子 ,证明了合成局域模振动的可行性 ,然后给出相干叠加态的跃迁几率特征 ,发现它仍表现出相干的特性 ,对之进行分析研究表明 ,分子的振动态具有可控性 ,态跃迁几率具有可控性。     

OFA-II型定量荧光仪在油气勘探中的应用

定量荧光仪在现场应用中受到各种因素的影响:如岩屑样品浸泡时的干、湿;图谱是否出现了淬灭;环境温度的影响等等。文章通过具体事例给出解决这些问题的办法。