Improved performance of subcarrier multiplexed multichannel AM-VSBvideo signal transmission using Pr3+-doped fluoride fibreamplifier

The performance of 40 channel AM-VSB video signal transmission using a Pr³⁺-doped fluoride fibre amplifier (PDFA) was examined. The PDFA improves the loss budget by 10 dB for 52 dB CNR, and distortion levels almost satisfy the CATV trunk line specifications. The video quality degradation after PDFA amplification was `imperceptible' in subjective tests     

Lipid-Lowering Effect of Eriocitrin, the Main Flavonoid in Lemon Fruit, in Rats on a High-Fat and High-Cholesterol Diet

ABSTRACT:  Eriocitrin (eriodictyol 7- O -β-rutinoside) is the main flavonoid in lemon fruit. In this study, eriocitrin was investigated for its lowering effect on serum and hepatic lipids in high-fat and high-cholesterol fed rats. Rats in the control group ( N = 6) were fed a 20% lard and 1% cholesterol diet for 21 d, and rats in the 0.35% eriocitrin group ( N = 6) and 0.70% eriocitrin group ( N = 6) were fed a diet supplemented with eriocitrin 0.35% and 0.70%, respectively. The content of hepatic total cholesterol and triglyceride in the eriocitrin group was no different from that of the control group. The total cholesterol, VLDL+LDL, triglyceride, and phospholipid in the serum of the 0.35% eriocitrin group showed significantly lower concentrations than the control group ( P < 0.05), although there was no difference in the HDL concentrations among the groups. The lowering effect of eriocitrin for serum total cholesterol was thought to be caused by a decrease in VLDL+LDL. The 0.35% eriocitrin group was shown to have a significant increase in excretion of fecal bile acid ( P < 0.05) and a tendency for enhanced hepatic m-RNA levels of LDL receptor in comparison with the control group.     

A new voltage control equipment using fuzzy inference

Power system control equipment needs higher sensitivity and operational reliability. Advanced voltage control equipment is needed for reducing the frequency of tap changes and improving the characteristics (the relationship between the actual voltage and reference voltage) of the voltage to meet today's power system requirements. However, these objectives are in a trade-off relationship. Studies of voltage control derived from a knowledge base suitable for electric power systems can satisfy these objectives using fuzzy inference. Compared with corresponding conventional equipment, the new equipment improved the deviation of 30 min average voltage of 30 percent. This paper describes the design concept of new voltage control equipment using fuzzy inference. In addition, field test results are described along with rules of fuzzy inference, membership functions, and the deviation of 30 min average voltage through detailed simulation.     

Simulation with an improved plasma model utilized to design a new structure of microwave plasma discharge for chemical vapor deposition of diamond crystals

A new structure of microwave plasma for chemical vapor deposition of diamond crystal is proposed. The structure is designed numerically, for which an improved model given in our previous work [H. Yamada et al., J. Appl. Phys. 101 (2007), art. no. 063302.] is utilized. The experimental observations and numerical predictions agree well with each other. It is demonstrated experimentally that the proposed structure can achieve a growth rate larger than 50 μm/h over an area 1 in. in diameter.     

Different feeding and gustatory responses to ecdysone and 20-hydroxyecdysone by larvae of the silkworm,Bombyx mori

The feeding and gustatory responses to ecdysone and 20-hydroxyecdysone were investigated in the silkworm,Bombyx mori. 20-Hydroxyecdysone reduced feeding response strongly in fourth- and fifth-instar larvae, whereas ecdysone had no effect on feeding response. 20-Hydroxyecdysone stimulated the R receptor, the receptor to feeding deterrents, to a great degree. By contrast, ecdysone was much less effective for stimulating the R receptor. These results indicate that ecdysone and 20-hydroxyecdysone have different effects on feeding response due to different interactions with mouthpart chemoreceptors.     

Effect of perchloric acid on the molecular weight and yield of poly-THF

Polytetramethylene glycol (molecular weight range 1000–8000) was prepared by the polymerization of tetrahydrofuran (THF) using a binary catalyst system of fuming sulfuric acid and perchloric acid. When 28% fuming sulfuric acid alone was used as the catalyst, the average molecular weight of polymer was low, the maximum value being 1000–1100. By the combination of fuming sulfuric acid with a small amount of perchloric acid, the average molecular weight of the polymer was increased to about 8000. Furthermore, the molecular weight was readily controlled in the range of 1000 to 8000 by varying the amount of the binary catalyst.     

Silica-supported cobalt catalysts for the selective reduction of nitrogen monoxide with propene

Catalytic behavior of silica-supported transition metals for NO reduction with propene in the presence of oxygen was investigated. While both silica and cobalt oxides did not show any activity for the selective NO reduction, impregnated CoO/SiO₂ prepared from cobalt acetate showed good activity although the preparation conditions had significant effect on the activity. It was suggested that highly dispersed surface Co²⁺ ions on silica are responsible for the catalytic activity.     

Synthesis of Super-Microporous Aluminosilicate Having Excellent Water Vapor Adsorption Property as an Adsorbent for an Adsorption Heat-Pump

The synthesis of super-microporous aluminosilicate with a pore diameter of 14.6 Å has been achieved, by means of synthesis under specified conditions with a skeletal material comprising TMOS and a small quantity of sodium aluminate, and a conventional alkyl-trimethylammonium halide (C₁₀TMABr) as a template. This super-microporous aluminosilicate has an adsorption capacity of 0.2 ml/g at a relative water vapor pressure of 0.2, and thus is promising as an adsorbent for an adsorption heat-pump.     

Shear-rate dependence of first normal stress difference of poly(isoprene-b-styrene) in solution near the order-disorder transition temperature

Viscoelastic properties of poly(isoprene-b-styrene) in dioctylphthalate under steady shear flow were measured near the order—disorder transition temperature. In ordered states, first normal stress difference N₁ is proportional to shear rate at low region, but becomes proportional to at the high region, similar to the N₁ behaviour of polymer blends undergoing shear-induced homogenization. Because the existence of microdomains was confirmed at the high region by the flow birefringence method, it is concluded that the above N₁ behaviour is not caused by shear-induced homogenization, but is probably caused by the shear-induced alignment of the microdomain structure.