Distribution of carbon contamination in MgAl2O4 spinel occurring during spark-plasma-sintering (SPS) processing: I – Effect of heating rate and post-annealing

Carbon contamination from the carbon paper/dies during spark-plasma-sintering (SPS) processing was examined in the MgAl₂O₄ spinel. The carbon contamination sensitively changes with the heating rate during the SPS processing. At the high heating rate of 100 °C/min, the carbon contamination having organized structures occurred over almost the entire area from the surface to deep inside the SPSed spinel disk. In contrast, at the slow heating rate of 10 °C/min, the carbon contamination having disordered structures occurred only around the surface area. The carbon phases transform into high pressure CO/CO₂ gases by post-annealing in air and lead to pore formation along the grain junctions. The pore formation significantly occurs at the high heating rate due to the large amount of the contaminant carbon phases. This suggests that if once the carbon contamination was formed in the materials, it is very difficult to remove the carbon phases from the materials.     

Hot carrier analysis in low-temperature poly-Si thin-film transistors using pico-second time-resolved emission microscope

We have analyzed degradation of N-channel thin-film-transistor (TFT) under dynamic stress using a pico-second time-resolved emission microscope. We have successfully detected emission at pulse fall edge for the first time. Emission intensity increased with the decrease of pulse fall time. As the degradation depended on the pulse fall time, this dependence clearly illustrates that hot electrons are the dominant cause of the degradation under dynamic stress. Based on these dependences, we proposed a model considering electron traps in the poly-Si.     

Development and exploitation of a multipurpose CFD tool for optimisation of microbial reaction and sludge flow.

A numerical analysis technique for optimisation of microbial reaction and sludge flow has been developed in this study. The technique is based on the 3D multiphase Navier-Stokes solver with turbulence models. In order to make numerical analyses of the total processes in wastewater treatment plants possible, four numerical models, the microbial reaction model, a sludge settling model, oxygen mass transfer model from coarse bubbles, and a model from fine bubbles, are added to the solver. All parameters included in those models are calibrated in accordance with experimental results, and good agreements between calculated results and experimental results are found. Finally, this study shows that the numerical technique can be used to optimise wastewater treatment plants with an example of the operational optimisation of an intermittent agitation in anoxic reactors by coarse bubbles. With a proper appreciation of its limit and advantages, the exploitation of the CFD efficiently leads us to the right direction even though it is not quantitatively perfect.     

Visualization of mitochondria with green fluorescent protein in cultured fibroblasts from patients with mitochondrial diseases

cDNAs for green fluorescent protein (GFP) and for a GFP fusion protein containing the presequence of human ornithine transcarbamylase (pOTC-GFP) were transfected into cultured human fibroblasts. GFP cDNA gave diffuse fluorescence throughout the cytoplasm and the nucleus, whereas pOTC-GFP cDNA gave mitochondria-associated fluorescence. Fluorescent mitochondrial structures could be classified into five patterns: thread-like mitochondria, fine thread-like ones, rod-like ones, granular ones, and granular ones with weak cytosolic fluorescence. pOTC-GFP mutants resulted in a loss of mitochondrial fluorescence and an appearance of weak fluorescence throughout the cytoplasm. pOTC-GFP cDNA was transfected into fibroblasts from patients with various mitochondrial diseases. Higher ratios of fibroblasts with granular mitochondria and those with fine thread-like ones were observed in a patient with Reye's syndrome and a patient with Kearns-Sayre syndrome. Weak cytosolic fluorescence was sometimes observed in fibroblasts from these patients. This method will be useful to analyze mitochondrial structural alterations and disorders of mitochondrial protein import.     

Correlation between serum levels of alanine aminotransferase and ferritin in male blood donors with antibody to hepatitis C virus

Chronic hepatitis C has been demonstrated to be associated with hepatic iron overload, and the hypothesis that the disease activity of hepatitis C is associated with iron cytotoxicity was tested in male volunteer blood donors. Sera with either antibody to hepatitis C virus or hepatitis B surface antigen were selected for determination of ferritin concentration and alanine aminotransferase activity. A correlation between serum ferritin concentration (Y; microgram/l) and alanine aminotransferase activity (X; IU/l) was found in donors with antibody to hepatitis C (log Y = 0.65 x log X + 0.98, r = 0.53, and P < 0.01). The correlation was lower in donors with hepatitis B surface antigen (r = 0.37; P < 0.01). Hepatitis C virus infection probably induces time-dependent iron accumulation associated with the progression of disease activity, while hepatitis B virus infection results in a variety of iron loads with different clinical features. The high disease activity related to hyperferritinemia suggests the presence of iron-induced liver damage in donors with hepatitis C.     

High performance liquid chromatographic separation of diacylglycerol acetates to quantitate disaturated species of lung phosphatidylcholine

A high-performance liquid chromatographic (HPLC) separation of diacylglycerol acetates to quantitatite disaturated species of lung phosphatidylcholine (PC) was studied. The diacylglycerol acetates were applied on a reversed phase column, eluted by an isocratic solvent, acetonitrile/isopropanol/water (35:15:1, v/v/v) at a flow rate of 1 ml/min, and detected by differential refractometry (RI). This isocratic HPLC method was useful to separate disaturated species from the others of lung PC. The quantitative analysis of the molecular species separated by HPLC was studied by RI detection. Chroamtograms obtained by RI detection and radioactivity determination of diacylglycerol [³H]acetates prepared by [³H]acetic anhydride were almost identical. The RI detector responsed in the same degree for different, authentic standards of diacylglycerol acetates. The detection limit with RI detection was about 30 nmoles. Molecular species of PCs from human lung and carcinoma tissues were analyzed by this HPLC method. The contents of disaturated species were very similar to those reported previously. These results indicate that RI detection is very useful in the nmole range for the quantitative analysis among the molecular species containing disaturated species.     

An Analysis of Scheduling Policies In Multiechelon Production Systems

Results of a simulation study of the economics of frequency of rescheduling Material Requirements Planning (MRP) systems are presented for a single-product, two-stage system in which demand is uncertain. The results indicate that for systems with moderate demand uncertainty, frequent rescheduling to maintain customer service may be uneconomical when compared with the alternative of more stable schedules in conjunction with safety stock. This result arises primarily because the cost of “emergency” production setups which occur when rescheduling is frequent exceeds the cost of safety stock required to “protect” stable schedules.     

Acetazolamide challenge and technetium-99m-ECD versus iodine-123-IMP SPECT in chronic occlusive cerebrovascular disease

We compared the acetazolamide challenge test using 99mTc-ECD SPECT and 123I-IMP SPECT images in patients with chronic occlusive cerebrovascular disease. We also evaluated the usefulness of linearization correction for acetazolamide challenge test of 99mTc-ECD SPECT. METHODS: Twenty patients with unilateral chronic occlusive cerebrovascular disease (10 patients had middle cerebral arterial lesion and 10 had internal carotid lesion) were included in the study. Split-dose (a dose fractioning was 1:2), and sequential SPECT technique was used for 99mTc-ECD SPECT studies while only acetazolamide challenge test studies for 123I-IMP SPECT were performed. Permeability surface area product model (PS model) and back-diffusion model (Lassen's correction) were used for linearization correction of acetazolamide challenge with 99mTc-ECD SPECT. RESULTS: Six of 16 patients with reduced vasodilatory capacity in 123I-IMP SPECT were underestimated by 99mTc-ECD SPECT acetazolamide challenge test. Relative ECD uptake normalized by cerebellar uptake compared with IMP uptake showed a nonlinear relationship, indicating relatively less uptake in high flow range. The underestimations of limited vasodilatory capacity observed in 99mTc-ECD SPECT without linearization correction was modified by linearization algorithm. However, the effect of correction based on PS model was superior than that of Lassen's correction. The corrected 99mTc-ECD uptake ratio, based on PS model, and IMP uptake ratio demonstrated a better linear relationship than that of Lassen's correction. CONCLUSION: Technetium-99m ECD SPECT corrected based on the PS model is a better method of linearization for evaluating cerebrovascular reserve using acetazolamide challenge.     

HEURISTIC APPROACHES FOR LOADING PROBLEMS IN FLEXIBLE MANUFACTURING SYSTEMS

Flexible manufacturing systems (FMSs) are able to process a wide variety of operations, but the specific mix of operations that can be performed at any point in time depends upon the combination of tools loaded onto the machines. The machines have tool magazines with finite capacities. We consider the problem of assigning operations and their associated tools to machines (or groups of machines) to maximize the throughput for a specified steady-state mix of orders. Since this objective is difficult to deal with directly, we use an intermediate objective of meeting workload targets for each machine group as closely as possible. A certain form of this intermediate objective has been shown to correlate highly with the original objective.

Since it is computationally intractable to find optimal solutions for problems with more than 20 operations, fast heuristic algorithms are developed. These algorithms are adapted from multi-dimensional bin-packing algorithms. Computational results are reported.     

Preparation of polyimide-epoxy composites

The formation of a three dimensional network of crosslinked epoxy leads all unmodified epoxies to have inherent brittleness and relatively low degradation temperatures. Polyimides, on the other hand, are widely used for applications that require high degrees of flexibility and thermal resistance. Here, we have focused on the preparation of epoxy systems cured with polyamic acids instead of traditional amino-group-containing hardening agents. The cure behavior and potential reaction mechanisms of EPON 828 resin and polyamic acid mixtures were evaluated by DSC and TGA. Thermal analysis showed a complex reaction sequence taking place in the mixture and also determined the extent of reaction of the polyamic acid with itself and the competitive reaction of the polyamic acid with the epoxy. The compositions of the mixtures were varied to see the dependence of the cure behavior on component concentrations. Solutions of the two components did not phase separate and also phase separation was not apparent either optically or microscopically in the cured samples. This phase behavior was attributed to a unique in situ reaction. A novel solvent system for the polyamic acid precursor was also used.