基于可编程逻辑阵列的RS232至RS422的串行口扩展电路

介绍了利用可编程逻辑阵列把1路RS232扩展至4路RS422的串行口电路设计方法。该扩展电路不占用PC系统资源，同时具有结构简单，使用方便，通用性和可补性强等特点，可广泛应用于主从式多机通讯系统中。     

Microstructure and Mechanical Properties of Heat-treated GeSb_2Te_4 Thin Films

The effect of annealing on microstructure,adhesive and frictional properties of GeSb 2 Te 4 films were experimentally studied.The GeSb 2 Te 4 films were prepared by radio frequency(RF)magnetron sputtering,and annealed at 200℃and 340℃under vacuum circumstance,respectively.The adhesion and friction experiments were mainly conducted with a lateral force microscope(LFM)for the GeSb 2 Te 4 thin films before and after annealing.Their morphology and phase structure were analyzed by using atomic force microscopy(AFM)and X-ray Diffraction(XRD)techniques,and the nanoindention was employed to evaluate their hardness values.Moreover,an electric force microscope(EFM)was used to measure the surface potential. It is found that the deposited GeSb 2 Te 4 thin film undergoes an amorphous-to-fcc and fcc-to-hex structure transition;the adhesion has a weaker dependence on the surface roughness,but a certain correlation with the surface potential of GeSb 2 Te 4 thin films.And the friction behavior of GeSb 2 Te 4 thin films follows their adhesion behavior under a lower applied load.However,such a relation is replaced by the mechanical behavior when the load is relatively higher.Moreover,the GeSb 2 Te 4 thin film annealed at 340℃presents a lubricative property.     

川东石炭系气藏排水采气工艺技术及其应用

四川盆地东部石炭系气藏是中国石油西南油气田公司的主力气藏之一，经过20多年的开发，出水气井增多、开发难度加大，必须进行排水采气才能维持正常生产。由于石炭系气藏大部分生产井存在井深、地层压力系数低、温度高、静液面深、复产后井口套压高的特点，常规排水采气工艺不能满足气藏的要求。针对这些难点，研究出深井高压气举、低压深井的优选管柱、深井高温泡排三项适合石炭系气藏的排水采气工艺，并在现场十多口井上进行了试验，增产效果显著。     

GPRS无线DDN系统与应用

介绍基于GPRS网络无线DDN系统的构成、组网以及在电力系统的应用，同时对传输包长度、效率、时延等参数进行分析。     

铸造锌合金浇铸方式的改进

针对勺式定量浇铸装置浇铸铸造锌合金产品含渣多的问题,采用自流的方式浇铸,将保温炉升高,锌液通过自重流入转盘浇铸装置的分配盘,通过分配盘的旋转将合金液均匀浇铸到直线铸锭机的锭模里.     

稠油油藏的注汽量预测

利用HCZ预测模型，可对已开发油田的年产量和累计产量进行全程预测，并且在实际应用中取得了较好的预测结果。本文结合稠油田的实际情况，推导出HXZ预测模型在热采中注汽参数的预测公式。结合曙光油田曙1－7－5块的开发数据进行了预测，效果较好。     

石油系油浆与煤系闪蒸油的焦化性能——I．热解条件的影响

通过偏光显微镜观察了石油系油浆（LH）与煤系闪蒸油（SN）焦化后所得焦块的光学结构。结果表明，在较宽条件下两种原料单独焦化均得不到取向度高的流线型结构。将两种原料以一定比例混合后先热解丙焦化所得焦块的光学结构明显好于二者混合后直接焦化所得焦块的光学结构，其中LH和SN以3：2的重量比混合后在440℃、1MPa下热解3．5h然后再在530℃、1MPa下焦化8h所得焦块为具有较高取向度的流线型结构，适合于作为针状焦的起始原料。     

Preparation of a pitch-based activated carbon with a high specific surface area

Pitch based activated carbons (PAC) with a high specific surface area were produced by a direct chemical activation route in which oxidative stabilized pitch derived from ethylene tar oil was reacted with potassium hydroxide under various activation conditions. It was found that PACs with a surface area of around 2600–3600 m² g^-1 could be obtained under suitable activation conditions. N₂ adsorption (at 77 K) and X-ray photoelectron spectroscopy experiments showed that the PAC has a uniformly developed micropore structure and a narrow pore size distribution (radius 0.8–1.6 nm). Abundant oxygen-containing functional groups (such as C–OH, C–O–C, C=O, COOR etc.) were found to exist on its surface. Compared with a commercially available activated carbon (AC) and also a pitch based activated carbon fibre, PAC has a quicker adsorption–desorption velocity and a larger adsorptive capacity to benzene due to its higher surface area. Clear surface differences between PAC and AC were observed by transmission electron microscopy. This revised version was published online in November 2006 with corrections to the Cover Date.     

铅酸蓄电池的清洁生产

就中国铅酸蓄电池工业的可持续性发展与清洁生产问题进行了初步探讨,并就蓄电池正负极板水洗的清洁生产实例进行了介绍。     

东营凹陷古近系烃源岩超压特征及分布规律

统计分析1307口探井实测压力系数和83l口探井使用的钻井液密度数据，发现东营凹陷古近系沙三段、沙四段普遍存在异常超压，超压(压力系数1．1-1．5)主要出现在2100-3500m深度，强超压(压力系数大于1．5)主要出现在2800-3500m深度。东营凹陷沙三段、沙四段主力烃源岩超压平面分布具有北高南低、东高西低的总体特点，超压主要分布在洼陷带、断裂构造带和中央背斜带上。烃源岩压力系数等值线北部陡坡带比较密集，南部缓坡带相对稀疏。生油洼陷中心附近异常高压带的分布与生油洼陷基本一致，洼陷深陷区压力系数很大，向周围斜坡和构造高部位呈辐射状逐渐减小至正常，压力分布带与洼陷、边缘斜坡和构造较高部位的欠压实与压实带发育、分布规律的一致性很好。图3表l参9