Electrical Breakdown Properties and Space Charge Formation in High Temperature Region in Ultraviolet Ray Irradiated PVC

Polyvinyl chloride (PVC) is the most popular insulating material for electric wiring instruments. However, an exothermic reaction above 150 °C may cause deterioration of the insulating properties of PVC. Therefore, it is important to clarify the heat degradation in PVC, not only to investigate the ignition of electrical wiring products but also to use electrical products safely. It is known that ultraviolet (UV) irradiation causes chemical deterioration of PVC and an increase in its conductivity. Generally, it has been thought that the electrical breakdown properties, electrical conduction, and insulating performance are affected by space charge accumulation in an insulating material. A high temperature pulsed electroacoustic (PEA) system usable up to 250 °C has been developed, and the PEA system can measure the space charge distribution and conduction current in the high temperature range simultaneously. In this investigation, the space charge distribution and conduction current were measured up to electrical breakdown in a non‐UV irradiated sample (normal PVC) and in 353 nm and 253 nm UV‐irradiated PVC samples in the range from room temperature to 200 °C in a DC electric field. In the short wavelength UV irradiated PVC sample (253 nm, 300 h), a deterioration of breakdown strength at 90 °C to 150 °C and negative packet‐like charges were observed at 60 °C and 100 °C, a positive charge accumulated in front of both the anode and cathode above 90 °C, and a higher electric field near the cathode side because the positive charge of the cathode side was greater.     

Effects of the velocity saturated region on MOSFET characteristics

A simple, accurate and universal relationship between MOSFET drain current in saturation, effective channel length, and gate drive has been found. It can be explained by a simple analytical model, whose validity is supported by numerical simulation. The model shows that the length of a velocity saturated region is a crucial parameter for describing MOSFET performance, particularly for short channel devices. The shrinkage of the length deteriorates the merit of channel length scaling     

Experimental infection of Naegleria fowleri in mice

PURPOSE: To determine possible cognitive and behavioral effects of antiepileptic drug (AED) therapy by assessing children with newly diagnosed epilepsy before and after initiation of treatment. A comparison group of children with diabetes mellitus (DM) was included to control for the effects of practice, maturation, and chronic illness. METHODS: Baseline neuropsychological assessments were completed for children with epilepsy (n = 37) and children with DM (n = 26) recruited through outpatient clinics at a regional children's hospital. Children were reevaluated 6 months from baseline testing. At follow-up, children with epilepsy had therapeutic AED levels and controlled seizures. Statistical analysis included a between-group repeated measures ANCOVA with pretest scores serving as the covariate. RESULTS: Significant differences between groups were not found for any cognitive or behavioral factors, including attention (p < 0.24), immediate memory (p < 0.24), delayed memory (p < 0.10), complex motor speed (p < 0.19), or behavior problems (p < 0.89). CONCLUSIONS: Changes in performance on cognitive and behavioral measures were not different for children treated with AEDs and controls. Although adverse effects may be associated with prolonged treatment, results would not suggest adverse effects from AED monotherapy during the first 6 months of therapy.     

Evaluation of the wettability of spherical cement particle surfaces using penetration rate method

The wettability of cement particles is related to the fluidity of cement paste. This paper describes the mechanism of the higher fluidity imparted by the spherical cement particles in light of their wettability. In addition, the effects of gypsum on the wettability were also studied. This study has shown the following: (1) The weight of water and water-reducing agent solution penetrating the spherical cement powder bed is 24-150% higher than that for the ordinary Portland cement powder bed. This results in the improvement of the wettability of the particle surfaces of spherical cement. The high wettability of spherical cement contributes to its high fluidity. (2) The presence of many fine gypsum particles on the spherical cement particle surface reduces the wettability. (3) To prepare spherical cement, the optimum amount of gypsum added is determined by the acceleration of the formation of spherical particles and the wettability of particle surfaces.     

Growth of β-Alumina (Na2O · 11Al2O3) Single Crystals by the Flux Method

The crystal-growth process and growth conditions of β-alumina (Na₂O · Al₂O₃) were investigated using the Na₂B₄O₇-Na₃AlF₆ flux method. β-Alumina (electric fusion brick) was used as both nutrient and seed. Weight loss of the flux varied widely for various runs: ≅ 10 wt% of flux evaporated at 100 h, ≅ 17 wt% at 150 h, and 43 wt% at 600 h. When β-alumina crystal was grown, only 20 wt% Na₂B₄O₇ was added to the Na₃AlF₆ flux. The linear growth rates of the β-alumina single crystal grown by an Na₃AlF₆-20 wt% Na₂B₄O₇ flux method at 1040°C and Δ t = 18°C were ≅ 1.0 × 10⁻³ mm/h ( a face) and ≅0.3 × 10⁻³ mm/h ( c face). The β-alumina single crystals grown were bounded by only c [001] and a [100] and were colorless and transparent.     

Single-crystal growth and characterization of Cu2O and CuO

We have prepared a large number of crystals of cuprous oxide (Cu2O) by various procedures. Photoluminescence spectra of these crystals were studied to examine the concentration of defects, especially copper vacancy VCu to seek favourable conditions for growing Cu2O crystal. High-quality single crystals of Cu2O were prepared by the floating-zone melting method in air. Several synthetic crystals (specimens FA, FZ and GZ) and also a natural crystal were studied by X-ray analysis, inductively coupled plasma spectroscopy analysis, optical absorption, photoluminescence, photoconductivity and cyclotron resonance absorption, photoluminescence, photoconductivity and cyclotron resonance absorption to characterize their optical and electrical qualities. The best values of mobility and scattering time of photocarriers at T = 4.2 K are estimated to be h1.8 × 105 cm2 V–1 s–1 and h60 ps for positive holes, and 1.3 × 105 cm2 V–1 s–1 and 70 ps for electrons in Cu2O. Further, we report preliminary experimental results on transport property of crystals also of cupric oxide (CuO) purified by the floating-zone melting method.     

Preparation of VO2 thin film and its direct optical bit recording characteristics

Vanadium dioxide (VO2) film which has nearly the same transition point as single crystal has been obtained by reactive evaporation of vanadium on glass and subsequent annealing in N2 gas. Relations between optical properties of V02 film and its preparation conditions are presented. We made optical direct bit recording on V02 film using a laser diode as the light source. The threshold recording energy and bit density are 2 mJ/cm 2 and 350 bits/mm, respectively. We also made tungsten doping to lower the V02 film transition temperature.     

Dual frequency open-loop electric potential microscopy for local potential measurements in electrolyte solution with high ionic strength

Recent development of open-loop electric potential microscopy (OL-EPM) has enabled to measure local potential distribution at a solid/liquid interface. However, the operating environment of OL-EPM has been limited to a weak electrolyte solution (<1 mM). This has significantly limited its application range in biology and chemistry. To overcome this limitation, we have developed dual frequency (DF) mode OL-EPM. In the method, an ac bias voltage consisting of two frequency components at f(1) and f(2) is applied between a tip and sample. The local potential is calculated from the amplitudes of the f(1) and |f(1) - f(2)| components of the electrostatic force. In contrast to the conventional single frequency (SF) mode OL-EPM, the detection of the 2f(1) component is not required in DF mode. Thus, the maximum bias modulation frequency in DF mode is twice as high as that in SF mode. The high bias modulation frequency used in DF mode prevents the generation of electrochemical reactions and redistribution of ions and water, which enables to operate OL-EPM even in a strong electrolyte solution. In this study, we have performed potential measurements of nanoparticles on a graphite surface in 1 and 10 mM NaCl solution. The results demonstrate that DF mode OL-EPM allows measurements of local potential distribution in 10 mM electrolyte solution.