High-purity mullite ceramics, promising engineering ceramics for high-temperature applications, were fabricated using transient liquid phase sintering to improve their high-temperature mechanical properties. Small amounts of ultrafine alumina or silica powders were uniformly mixed with the mullite precursor depending on the silica-alumina ratio of the resulting ceramics to allow for the formation of a transient liquid phase during sintering, thus, enhancing densification at the early stage of sintering and mullite formation by the reaction between additional alumina and the residual glassy phase (mullitization) at the final stage of sintering. The addition of alumina powder to the silica-rich mullite precursor resulted in a reaction between the glassy silica and alumina phases during sintering, thereby forming a mullite phase without inhibiting densification. The addition of fine silica powder to the mullite single-phase precursor led to densification with an abnormal grain growth of mullite, whereas some of the added silica remained as a glassy phase after sintering. The resulting mullite ceramics prepared using different powder compositions showed different sintering behaviors, depending on the amount of alumina added. Upon selecting an optimum process and the amount of alumina to be added, the pure mullite ceramics obtained via transient liquid phase sintering exhibited high density (approximately 99%) and excellent high-temperature flexural strength (approximately 320 MPa) at 1500 °C in air. These results clearly demonstrate that pure mullite ceramics fabricated via transient liquid phase sintering with compositions close to those of stoichiometric mullite could be a promising process for the fabrication of high-temperature structural ceramics used in an ambient atmosphere. The transient liquid phase sintering process proposed in this study could be a powerful processing tool that allows for the preparation of superior high-temperature structural ceramics used in the ambient processing atmosphere. 相似文献
Due to the changes in the frequency of penicillin-resistant strains of S. pneumoniae, it is necessary to perform surveillance studies of bacterial resistance. Isolates from the upper respiratory tract of asymptomatic children have been useful. There is no information about the difference between isolates from children with and without upper respiratory tract infection (URTI). The objective of the authors in this paper is to establish the prevalence of carrier-state, serotype and antimicrobial resistance of S. pneumoniae isolates from children with and without acute upper respiratory tract infection (URTI) in a rural area in Mexico. A cross-sectional comparative study was performed in Tlaxcala, Mexico. Children from one month 5 years of age were included. Nasopharyngeal swabs were obtained. Identification was done by international microbiology standards. Serotyping was done by the capsular Quellung test. The susceptibility testing was performed by the agar dilution method. Four-hundred and fifty patients were included. S. pneumoniae was isolated in 134 children (29.7%). Frequency of carriers was greater in patients with URTI (107/323) than without URTI (27/127) (33.1% vs. 21.1% p = 0.012, OR 1.84, IC 95% 1.1-3.08). The six most frequent serotypes were: 6B (16.4%); 19F (11.9%); 19A (6.7%); 14, 23F, and 35 (5.2% each), with no difference among the groups. Only 3% of the strains had high level resistance to penicillin, and 12.6% had intermediate resistance, and for ampicillin 4%, amoxicillin 4%, amoxicillin-clavulanate 4%, ceftriaxone 3%, cefotaxime 1.5%, erythromycin 6%, miocamycin 3%, chloramphenicol 4%, and vancomycin 0%. Trimethoprim-sulfamethoxazole resistance was very high (42%). In conclusion, colonization is higher in children with URTI. Five of the most frequent serotypes identified in this study were the same as those identified in patients with S. pneumoniae invasive diseases in Mexico City. In Tlaxcala, Mexico, beta-lactams could be the drug of choice for the treatment of S. pneumoniae lower respiratory tract infections. It is necessary to perform clinical assays to evaluate the efficacy of trimethoprim-sulfamethoxazole due to the high resistance in vitro. 相似文献
Electrical properties of homoepitaxial diamond p–n+ junction of boron (B)-doped p-type layer and phosphorus-doped n-type layer on Ib (111) diamond single crystal have been characterized. Current–voltage characteristics show a clear rectifying property with rectification ratio of over 105 at ± 10 V. From capacitance–voltage characteristics, it is found that a spatial distribution of space-charge density Ni of the p–n+ junction is not uniform and Ni at a middle region of the space-charge layer formed at zero bias voltage is higher than that of other region of the space-charge layer. This peculiar characteristic can be explained by superposition of two effects; one is the deep dopant effect due to B atoms in the p-type layer, which makes to reduce Ni at around the edge of the space-charge layer formed at zero bias voltage. The other is the compensation of B acceptors by impurity atoms diffusing during the p–n+ interface and incorporating during the growth of p-type layer, which makes to reduce Ni at the vicinity of the p–n+ interface. 相似文献
Behaviormetrika - In this paper, we propose a new clustering method based on the concept of maximum likelihood (ML) estimation. In general, the problem of local minima arises when we try to use the... 相似文献
The incidence of Campylobacter jejuni and Campylobacter coli in broiler farms was 33.9% (19/56). C. jejuni-positive flocks accounted for 20.0% (17/85) and C. coli-positive ones was 4.7% (4/85). There were 14 patterns (fla type) of restriction fragment length polymorphism (RFLP) of flagellin A gene among these 22 strains of C. jejuni and C. coli including the standard strain C. jejuni ATCC 33560. Different fla types of Campylobacter were isolated from broilers in different growing cycles on the same farms. Four strains of C. jejuni were isolated from four breeder farms and four fla types of C. jejuni were detected from their progenies reared on growing farms. Three fla types of C. jejuni detected from the progenies were different from those of each breeder. Also, the other three fla types of C. jejuni were detected from different progenies of each growing farm during the next growing cycle. These findings indicate that the RFLP analysis may contribute to epidemiological studies of C. jejuni and C. coli contamination of broilers and suggest the risk of contamination with different types of Campylobacter in every growing cycle of broilers on the farm even on the same farm. They also supported that there was little likeliness of the vertical transmission of C. jejuni and C. coli from breeders to broilers. 相似文献
A serious problem in motion control is the occurrence of torque ripple. Since a direct drive (DD) motor with a magnet rotor uses a rare-earth magnet, the torque ripple is more serious than that of conventional servomotors. This paper presents an auto-compensation of torque ripple using a software-implemented torque observer. The frequency and amplitude of torque ripple can be obtained in the controller by using the estimated torque from an observer, and the autonomous generation of a compensating current component for a torque ripple is possible. The proposed algorithm has been verified by experiments. 相似文献
A compact, high-resolution analog-to-digital converter (ADC) especially for sensors is presented. The basic structure is a completely digital circuit including a ring-delay-line with delay units (DUs), along with a frequency counter, latch, and encoder. The operating principles are: (1) the delay time of the DU is modulated by the analog-to-digital (A/D) conversion voltage and (2) the delay pulse passes through a number of DUs within a sampling (= integration) time and the number of DUs through which the delay pulse passes is output as conversion data. Compact size and high resolution were realized with an ADC having a circuit area of 0.45 mm/sup 2/ (0.8-/spl mu/m CMOS) and a resolution of 12 /spl mu/V (10 kS/s). Its nonlinearity is /spl plusmn/0.1% FS per 200-mV span (1.8-2.0 V), for 14-b resolution. Sample holds are unnecessary and a low-pass filter function removes high-frequency noise simultaneously with A/D conversion. Thus, the combination of this ADC and a digital filter that follows can eliminate an analog prefilter to prevent the aliasing before A/D conversion. Also, both this ADC can be shrunk and operated at low voltages, so it is an ideal means to lower the cost and power consumption. Drift errors can be easily compensated for by digital processing. 相似文献
In this paper, we propose a new hierarchical clustering method, which is useful to find appropriate clusters of attributes from given dichotomous or frequency data. Important features of our method are 1) the similarity between two attributes is defined as a probability of their pattern vectors being observed under the hypothesis of independence, 2) for each generated cluster, one pattern vector is defined in a natural manner, and 3) it can be used freely without distinguishing the frequency data from the dichotomous one.
A typical frequency data is analyzed to illustrate how our method works effectively. The discussion on similarities among objects is also included to propose a new similarity measure based on our clustering method.
The sidemode suppression ratio of gain-coupled DFB lasers with periodically etched quantum wells is analysed by a more accurate model for amplified spontaneous emission. It is shown that the periodic etching of quantum wells is very effective for providing a high side-mode suppression. The mechanism for the high singlemode stability is explained by the effective modal gain. which has an enhancement at the longer wavelength side of the Bragg stopband 相似文献
We propose combined distributed-feedback/Fabry-Perot (DFB/FP) structures for surface-emitting semiconductor lasers. The analysis is based on coupled-wave equations modified for surface-emitting lasers. The proposed structures, which exhibit enhanced resonance due to a matching between the gain and field distributions resulting in a reduced threshold compared with simple FP structures, are formed by placing the DFB structure between two DBR mirrors of an FP resonant cavity and introducing phase layers between the DFB region and the mirrors. It was found that the periodic-gain structures are a special case of the combined DFB/FP structures in which the index coupling effect is assumed to be negligible due to a small fill factor or a small refractive-index difference. The effect of complex (gain and index) coupling on the design and the threshold characteristics of the structures is clearly illustrated. Some important design considerations that were neglected in the previous papers are addressed 相似文献