Intercomparison of scanning probe microscopes

Comparison measurements on reference standards are reported in which 13 partners with different instruments took part. A set of prototype standards which had been produced and calibrated within a European project were used for the measurements. Here, results of measurements on a 240 nm step height standard and a two-dimensional lateral standard with a nominal pitch of 1 μm are reported.     

The genetic relationship between the Finns and the Finnish Saami (Lapps): analysis of nuclear DNA and mtDNA

The genetic relationships between two Finno-Ugric-speaking populations, the Finns and the Finnish Saami (Lapps), were studied by using PCR for six nuclear-DNA marker loci, mitochondrial restriction-site polymorphism, and sequence variation of a 360-bp segment of the mitochondrial control region. The allele frequencies of each of the nuclear-DNA marker loci and the frequencies of mtDNA restriction haplotypes were significantly different between the populations. The Saami showed exceptionally low variation in their mtDNA restriction sites. The 9-bp deletion common in East Asian populations was not observed, nor did the haplotype data fit into the haplogroup categorization of Torroni et al. The average number of nucleotide substitutions from the mtDNA haplotype data indicated that the Finnish Saami may be closer to the Finns than to the other reference populations, whereas nuclear DNA suggested that the Finns are more closely related to the European reference populations than to the Finnish Saami. The similarity of the Finns to the other Europeans was even more pronounced according to the sequence data. We were unable to distinguish between the Finns and either the Swiss or Sardinian reference populations, whereas the Finnish Saami clearly stood apart. The Finnish Saami are distinct from other Circumarctic populations, although two of the lineages found among the Saami showed closer relationship to the Circumarctic than to the European lineages. The sequence data indicated an exceptionally high divergence for the Saami mtDNA control lineages. The distribution of the pairwise nucleotide differences in the Saami suggested that this population has not experienced an expansion similar to what was indicated for the Finns and the reference populations.     

Effect of pre-scalding brushing on contamination level of pork carcasses during the slaughtering process

The number of aerobic bacteria on the skin of pork carcasses was measured at seven different points on the slaughtering line in order to study the hygienic effect of pre-scalding brushing on the contamination level of carcasses. Eighty carcasses were investigated, of which 40 were brushed before scalding and 40 served as controls. Samples were excised from three sites: back, abdomen and ham. The total number of samples was 1368. The cleaning monitoring of the pre-scalding brushing machine and the blackscraping machine was done at the same time. After singeing and blackscraping there were significant differences (P<0·05) between brushed and non-brushed ham sites. After singeing, brushed ham sites had a contamination level of 2·11 (log(10) cm(-2)) and non-brushed ham sites a level of 1·57. After blackscraping the contamination of brushed ham sites was 3·45 (log(10) cm(-2)) and that of non-brushed ham sites 3·26. At the end of the slaughtering line brushed carcasses were more contaminated than those not brushed, although this difference was not significant.     

Metallocene‐based functionalized polyolefins as compatibilizers in polyolefin nanocomposites

This article reports a study of some functionalized polyolefins evaluated as compatibilizers in polyethylene nanocomposites. The functionalized polymers were prepared by direct metallocene‐mediated copolymerizations of ethylene and a functional comonomer. The prepared nanocomposites were evaluated for mechanical and barrier property enhancement. A good combination of mechanical and barrier properties was obtained with the metallocene‐based functionalized polyethylene. The toughness–stiffness balance was better than or comparable to that achieved with conventional functionalized polymers such as maleic anhydride grafted polyethylene. The results also indicated that these metallocene‐based functionalized polyolefins, when used as compatibilizers, could have relatively higher molar masses and lower functionality than those of conventional post‐reactor‐modified compatibilizers, and so the drawbacks associated with the latter could be avoided. Their inherent properties could also further improve the final nanocomposite properties. This was attributed to the more homogeneous nature of metallocene‐catalyzed polymers in comparison with post‐reactor‐modified products. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 94: 1094–1100, 2004     

Genetic effects of 1,3-butadiene and associated risk for heritable damage

A summary of the results of the studies conducted in the EU Project "Multi-endpoint analysis of genetic damage induced by 1,3-butadiene and its major metabolites in somatic and germ cells of mice, rats and man" is presented. Results of the project are summarized on the detection of DNA and hemoglobin adducts, on the cytotoxic and clastogenic effects in somatic and germinal cells of mice and rats, on the induction of somatic mutations at the hprt locus of experimental rodents and occupationally exposed workers, on the induction of dominant lethal mutations in mice and rats, and on heritable translocations induced in mice, after exposure to butadiene (BD) or its major metabolites, butadiene monoepoxide (BMO), diepoxybutane (DEB) and butadiene diolepoxide (BDE). The primary goal of this project was to collect experimental data on the genetic effects of BD in order to estimate the germ cell genetic risk to humans of exposure to BD. To achieve this, the butadiene exposure are based on data for heritable translocations and bone marrow micronuclei induced in mice and chromosome aberrations observed in lymphocytes of exposed workers. A doubling dose for heritable translocations in human germ cells of 4900 ppm/h is estimated, which, assuming cumulative BD exposure over the sensitive period of spermatogenesis, corresponds to 5-6 weeks of continuous exposure at the workplace to 20-25 ppm. Alternatively, the rate of heritable translocation induction per ppm/h of BD exposure is estimated to be approximately 0.8 per million live born, compared to a spontaneous incidence of balanced translocations in humans of approximately 800 per million live born. These estimates have large confidence intervals and are only intended to indicate orders of magnitude of human genetic risk. These risk estimates are based on data from germ cells of BD-exposed male mice. The demonstration that clastogenic damage was induced by DEB in preovulatory oocytes at doses which were not ovotoxic implies that additional studies on the response of mammalian female germ cells to BD and its metabolites are needed. The basic assumption of the above genetic risk estimates is that experimental mouse data obtained after BD exposure can be extrapolated to humans. Several points exist in the present report and in the literature which contradict this assumption: (1) the level of BMO-hemoglobin adducts was significantly elevated in BD-exposed workers; however, it was considerably lower than would have been predicted from comparable rat and mouse exposures; (2) the concentrations of the metabolites DEB and BMO were significantly higher in mouse than in rat blood after BD exposure. Thus, while metabolism of BD is qualitatively similar in the two species, it is quantitatively different; (3) no increase of HPRT mutations was shown in 19 workers exposed on average to 1.8 ppm of BD, while in a different population of workers from a US plant exposed on average to 3.5 ppm of BD, a significant increase of HPRT variants was detected; and (4) data from cancer bioassays and cancer epidemiology suggest that rat is a more appropriate model than mouse for human cancer risk from BD exposure. However, the dominant lethal study in rats gave a negative result. At present, we do not know which BD metabolite(s) may be responsible for the genetic effects even though the bifunctional alkylating agent DEB is the most likely candidate for the induction of clastogenic events. Unfortunately, methods to measure DEB adducts in hemoglobin or DNA are only presently being developed. Despite these several uncertainties the use of the mouse genetic data is regarded as a justifiable and conservative approach to human genetic risk estimation given the considerable heterogeneity observed in the biotransformation of BD in humans.     

Levels of mycotoxins and sample cytotoxicity of selected organic and conventional grain-based products purchased from Finnish and Italian markets

The contamination levels of 16 different Fusarium- and Aspergillus-mycotoxins were chemically determined from randomly selected organic and conventional grain-based products purchased from Finnish and Italian markets. The cytotoxicity of the samples was analyzed with an in vitro test using feline fetal lung cells. Overall, the concentrations of the mycotoxins studied were low in all of the samples. Enniatins B and B1 as well as deoxynivalenol were the most predominant mycotoxins in the samples, being present in 97%, 97%, and 90% of the samples, respectively. The geographical origin or the agricultural practice had no influence on the mycotoxin concentrations of the samples. The babyfoods included in the samples had significantly lower concentrations of mycotoxins than the other products with a mean total mycotoxin content of 47 microg/kg compared with 99 microg/kg for the other kinds of food. All the samples evoked toxicity in the in vitro test, but no correlation between cytotoxicity and the mycotoxin concentrations was observed.     

Furan in the baby-food samples purchased from the Finnish markets – Determination with SPME–GC–MS

A method applying solid-phase microextraction followed by gas chromatography–mass spectrometric determination was in-house validated and used to study furan concentrations in baby-food samples purchased from the Finnish markets. The validation parameters showed that the method was well applicable for the reliable analysis of furan. Furan was analysed in 21 different baby-food samples as three independent replicates. The mean levels of furan varied between 4.7 and 90.3 μg kg⁻¹ being well in accordance with the levels reported in other studies. The mean concentrations of similar product formulas based on their ingredients were 9.2, 37.0 and 49.6 μg kg⁻¹ for fruit-, vegetables- and meat-containing baby-foods, respectively. According to the statistical analyses, fruit-based baby-food samples had significantly lower concentrations of furan as compared to other formulas. Based on our exercise, it seems that a low margin of safety exists between the extreme worst case infant exposures and the deduced NOAEL of furan on experimental animals, particularly for a clear rodent carcinogen.     

Mannans as stabilizers of oil-in-water beverage emulsions

The stabilizing effect of spruce galactoglucomannan (GGM) on a model beverage emulsion system was studied and compared to that of guar gum and locust bean gum galactomannans, konjac glucomannan, and corn arabinoxylan. In addition, guar gum was enzymatically modified in order to examine the effect of the degree of polymerization and the degree of substitution of galactomannans on emulsion stability. Use of GGM increased the turbidity of emulsions both immediately after preparation and after storage of up to 14 days at room temperature. GGM emulsions had higher turbidity than the emulsions containing other mannans. The initial turbidity increased with increasing GGM content, but after 14 days storage at room temperature, the turbidity was the highest for GGM/oil ratio of 0.10:1 when ethanol-precipitated GGM was used. Increasing the storage temperature to +45 °C led to rapid emulsion breakdown, but a decrease in storage temperature increased emulsion stability after 14 days. Confocal microscopy showed that the average particle size in the bottom part of GGM emulsions stored for 14 days was smaller than 1 μm. A low degree of polymerization and a high degree of substitution of the modified galactomannans were associated with a decrease in emulsion turbidity.     

Ante- and perinatal factors and child characteristics predicting parenting experience among formerly infertile couples during the child's first year: A controlled study.

In this prospective controlled study, the authors examined (a) parenting experiences among couples with successful assisted reproduction treatment (ART; n = 367) and fertile spontaneously conceiving controls (n = 371) and (b) the impact of ante- and perinatal factors and child characteristics on parenting experiences. The results show that positive mothering experiences increased more during the 1st year of parenting and were generally higher among ART mothers than control mothers. No differences were found between ART fathers and controls in their fathering experience. Unpleasant birth experiences, low birth weight, and difficulty soothing the child were associated with high levels of parental stress in the control group, but this was not so among the ART parents. Psychosocial interventions in maternal care should take into account the various meanings that couples give to the history of infertility and conception and ante- and perinatal experiences. (PsycINFO Database Record (c) 2010 APA, all rights reserved)