Nitrogen incorporated diamond-like carbon films by microwave surface wave plasma CVD

Nitrogen incorporated diamond like carbon films have been deposited by microwave surface wave plasma chemical vapor deposition (MW-SWP-CVD), using methane (CH₄) as the source of carbon and with different nitrogen flow rates (N₂ / CH₄ flow ratios between 0 and 3). The influence of the nitrogen incorporation on the optical, structural properties and surface morphology of the carbon films were investigated using different spectroscopic techniques. The nitrogen has been incorporated into DLC:N films which was confirmed by the X-ray photoelectron spectroscopy (XPS) measurement. Moreover, the nitrogen incorporation was accompanied by a variation in the optical gap, which was attributed to the removal or creation of band tail states.     

Diamond-like carbon thin films by microwave surface-wave plasma CVD aimed for the application of photovoltaic solar cells

The nitrogen doped diamond-like carbon (DLC) thin films were deposited on quartz and silicon substrates by a newly developed microwave surface-wave plasma chemical vapor deposition, aiming the application of the films for photovoltaic solar cells. For film deposition, we used argon as carrier gas, nitrogen as dopant and hydrocarbon source gases, such as camphor (C₁₀H₁₆O) dissolved with ethyl alcohol (C₂H₅OH), methane (CH₄), ethylene (C₂H₄) and acetylene (C₂H₂). The optical and electrical properties of the films were studied using X-ray photoelectron spectroscopy, Nanopics 2100/NPX200 surface profiler, UV/VIS/NIR spectroscopy, atomic force microscope, electrical conductivity and solar simulator measurements. The optical band gap of the films has been lowered from 3.1 to 2.4 eV by nitrogen doping, and from 2.65 to 1.9 eV by experimenting with different hydrocarbon source gases. The nitrogen doped (flow rate: 5 sccm; atomic fraction: 5.16%) film shows semiconducting properties in dark (i.e. 8.1 × 10^{− 4} Ω^{− 1} cm^{− 1}) and under the light illumination (i.e. 9.9 × 10^{− 4} Ω^{− 1} cm^{− 1}). The surface morphology of the both undoped and nitrogen doped films are found to be very smooth (RMS roughness ≤ 0.5 nm). The preliminary investigation on photovoltaic properties of DLC (nitrogen doped)/p-Si structure show that open-circuit voltage of 223 mV and short-circuit current density of 8.3 × 10^{− 3} mA/cm². The power conversion efficiency and fill factor of this structure were found to be 3.6 × 10^{− 4}% and 17.9%, respectively. The use of DLC in photovoltaic solar cells is still in its infancy due to the complicated microstructure of carbon bondings, high defect density, low photoconductivity and difficulties in controlling conduction type. Our research work is in progress to realize cheap, reasonably high efficiency and environmental friendly DLC-based photovoltaic solar cells in the future.     

Synthesis of nitrogen incorporated diamond-like carbon thin films using microwave surface-wave plasma CVD

Nitrogenated diamond-like (DLC:N) carbon thin films have been deposited by microwave surface wave plasma chemical vapor deposition on silicon and quartz substrates, using argon gas, camphor dissolved in ethyl alcohol composition and nitrogen as plasma source. The deposited DLC:N films were characterized for their chemical, optical, structural and electrical properties through X-ray photoelectron spectroscopy, UV/VIS/NIR spectroscopy, Raman spectroscopy, atomic force microscope and current–voltage characteristics. Optical band gap decreased (2.7 to 2.4 eV) with increasing Ar gas flow rate. The photovoltaic measurements of DLC:N / p-Si structure show that the open-circuit voltage (V_oc) of 168.8 mV and a short-circuit current density (J_sc) of 8.4 μA/cm² under light illumination (AM 1.5 100 mW/cm²). The energy conversion efficiency and fill factor were found to be 3.4 × 10^{− 4}% and 0.238 respectively.     

Note: Compact high voltage pulse transformer made using a capacitor bank assembled in the shape of primary

The experimental results of an air-core pulse transformer are presented, which is very compact (<10 Kg in weight) and is primed by a capacitor bank that is fabricated in such a way that the capacitor bank with its switch takes the shape of single-turn rectangular shaped primary of the transformer. A high voltage capacitor assembly (pulse-forming-line capacitor, PFL) of 5.1 nF is connected with the secondary of transformer. The transformer output voltage is 160 kV in its second peak appearing in less than 2 μS from the beginning of the capacitor discharge. The primary capacitor bank can be charged up to a maximum of 18 kV, with the voltage delivery of 360 kV in similar capacitive loads.     

Availability and cost-centered preventive maintenance scheduling of continuous operating series systems using multi-objective genetic algorithm: A case study

This article presents a multi-objective (maximization of availability and minimization of maintenance cost) preventive maintenance (PM) scheduling model for a continuous operating series system (COSS) which do not provide an off-working period for PM. The objective functions are optimized by using a Multi-Objective Genetic Algorithm (MOGA). The effectiveness of the model is demonstrated through a coal-fired boiler-tube. The case study shows that the model can improve the availability along with profound reduction of the maintenance cost, i.e., increases the profit of the plant.     

Studies on curcumin and curcuminoids XVII. Variation in the content of curcuminoids inCurcuma longa L. from Nenal during one season

Summary The content of curcuminoids inCurcuma longa L. before, during and after a normal harvesting period was investigated. The plant material was grown in the Kathmandu area. Bis-demethoxycurcumin was found to be the main constituent. No significant change in the curcuminoid content was observed during a 17-week sampling period.

---

Studien über Curcumin und Curcuminoide. XVII. Veränderung des Gehaltes an Curcuminoiden inCurcuma longa L. (Zingiberaceae) aus Nepal warend der Ernte

Zusammenfassung Der Gehalt an Curcuminoiden inCurcuma longa L. (Zingiberaceae) wurde vor, während und nach der normalen Erntezeit untersucht. Das Pflanzenmaterial stammt aus dim Kathmandu-Tal in Nepal. Der Hauptinhaltsstoff ist Bisdemethoxycurcumin. Im Laufe von 17 Wochen konnten keine signifikante Schwankungen observiert werden.

     

Effect of strata properties and panel widths on chock performance

The selection of optimum chock (support) capacity is very crucial for a successful longwall mining. The selection of chock capacity depends on the site-specific geotechnical parameters, constraints and longwall panel geometry, which are generally not known in detail in priority. Hence, based on the field and laboratory data, various possible combinations should be analyzed to cater for the unforeseeable mining conditions. This paper discusses the use of numerical model for selecting an appropriate chock capacity based on the site-specific geological and geotechnical information and longwall panel geometry. The fracture mechanisms of immediate and main roofs are also discussed for various panel widths and support capacities. For the models considered, the chock convergence is predicted to increase by about 33% due to the increase in face width from 100 to 260 m. Similarly, the massive roof strata are found to yield higher chock convergence compared to bedded strata.     

151Eu Mössbauer studies on Zn-doped EuBa2Cu3O7−y

¹⁵¹Eu Mössbauer studies have been performed on the compounds EuBa₂(Cu_1?x Zn _x )₃O_7?y withx=0·0, 0·025, 0·05, 0·075 and 0·1. The parent compound, EuBa₂Cu₃O_7?y is superconducting with a transition temperature (T _c ) of 88 K.T _c is depressed as Zn is substituted for Cu in this system and the compounds withx>0·05 do not show superconductivity down to 12 K.¹⁵¹Eu Mössbauer studies at 295 K show a single Mössbauer line in all the compounds (whether superconducting or not) with isomer shift value typical of Eu^{3 +} ion. Further, the isomer shift values are nearly independent ofx and the temperatures down to 10 K. These observations imply that the Cu-O network responsible for superconductivity is very weakly coupled to the Eu sublattice.     

Boron-doped hydrogenated amorphous carbon films grown by surface-wave mode microwave plasma chemical vapor deposition

We report the effects of boron (B) doping on optical and structural properties of the hydrogenated amorphous carbon thin films grown by surface-wave mode microwave plasma (SW-MWP) chemical vapor deposition (CVD) on n-type silicon and quartz substrates at room temperature. Argon and acetylene were used as a carrier and carbon source gases respectively. Analytical methods such as X-ray photoelectron spectroscopy (XPS), Nanopics 2100/NPX200 surface profiler, JASCO V-570 UV/VIS/NIR spectroscopy, Fourier transform infrared spectroscopy (FT-IR) and Raman spectroscopy were employed to investigate the properties of the films. Low atomic concentration of B (0.08 at.%) was found in the doped film. The optical band gap of the undoped film was 2.6 eV and it decreased to 1.9 eV for the B-doped film. Structural property shows the crystalline structure of the film and it has changed after incorporating B as a dopant. The structural modifications of the films leading to being more graphite in nature were confirmed by the Raman and FT-IR characterization.