β″－Al_2O_3陶瓷的强化和韧化

研究了稳定ＺｒＯ＿２和部份稳定ＺｒＯ＿２对β″－Ａｌ＿２Ｏ＿３陶瓷的强化和韧化作用，观察了不同种类、不同含量的ＺｒＯ＿２对β″－Ａｌ＿２Ｏ＿３陶瓷的显微结构、力学性能和电导率的影响，探讨了β″－Ａｌ＿２Ｏ＿３的韧化机理。     

The maximum bit rates of soliton communication systems with lumpedamplifiers and filters in different distances

The maximum bit rate of a soliton communication system with lumped amplifiers and optical filters is considered. When the dispersion of the fiber varies from one amplifier spacing to another amplifier spacing, the maximum bit rate is significantly reduced. To overcome the effect, the amplitude of the soliton is amplified so that it is still the average soliton corresponding to the fiber dispersion for an amplifier spacing. Thus, the maximum bit rate is only slightly less than that without the dispersion variations. For a given distance, the maximum bit rate limited by the stability and soliton interaction is obtained. The result is compared with that limited by the Gordon-Haus effect. For shorter transmission distance, the maximum bit rate is limited by the stability and soliton interaction. For longer transmission distance, the maximum bit rate is limited by the Gordon-Haus effect     

Optical phase conjugation of multiwavelength signals in adispersion-shifted fiber

Optical phase conjugation (OPC) of multiwavelength signals in a dispersion-shifted fiber (DSF), which can be used for dispersion compensation in the wavelength division multiplexing communication system, is theoretically studied. The multiwavelength phase-conjugate signals are generated by four-wave mixing (FWM) in the dispersion-shifted fiber. There are the pulse-shape distortion and the induced frequency chirping in the phase-conjugate signals owing to pump depletion and the cross-phase modulation among the signals and phase-conjugate signals, respectively. The FWM among the pump wave, signals, and phase-conjugate signals causes unequal conversion efficiencies for the multiwavelength signals and enhances the induced frequency chirping in the phase-conjugate signals. The induced frequency chirping may deteriorate the restoration of the pulse shape. Both the pulse-shape distortion and induced frequency chirping increase with the signal and pump powers. The formula for the induced frequency chirping that is only caused by the signals through cross-phase modulation is derived. The requirement of the signal power in the dispersion-shifted fiber for the restoration of the pulse shape by the optical phase conjugation is estimated and numerically verified     

TEM study of PLZT ceramics

The microscopic structures of PLZT(7.9/70/30 and x/65/35, x = 7 or 8) ceramics were studied by means of transmission electron microscopy. The presence of micro-regions in PLZTs was first verfied.     

Study on phase behavior–impact strength relationship of unsaturated polyester/polyurethane hybrid polymer network

The phase behavior of a hybrid polymer network (HPN) composed of poly[(propylene glycol maleate)-co-(propylene glycol phthalate)] crosslinked with styrene and polyester–urethane crosslinked with methylene-bis-ortho-chloroaniline was examined. The correlation between phase separation and impact strength of the HPNs is discussed. The composition of HPNs has an effect on their properties.     

大力发展循环经济实现企业可持续发展

莱钢始建于1970年1月,现控股莱钢股份、鲁银投资两个上市公司及齐鲁证券等25个子公司。莱钢是中国冶金行业首批通过ISO9002质量管理体系、ISO14001环境管理体系和OHSAS18001职业安全健康管理体系国家认证的企业。2005年,莱钢被国家发改委确定为国家第一批循环经济试点单位。     

Nanocrystalline CeO2 in SBA-15: Performance of Pt/CeO2/SBA-15 Catalyst for Water-gas-shift Reaction

CeO₂ particles confined within the pores of an SBA-15 mesoporous silica host were prepared by incipient wetness impregnation (IMP) and deposition precipitation (DP) methods. The materials were characterized by XRD, N₂-adsorption and temperature programmed reduction (TPR) to evaluate the structure, texture, and redox properties. The preparation procedure had significant impact on the assembling mode of CeO₂ inside the SBA-15 mesopores. A high dispersion of CeO₂ particles was achieved via DP, whereas the dispersion of CeO₂ prepared by IMP was found to be inhomogeneous and CeO₂ partially blocked the pores. The CO conversion in the water-gas-shift reaction was enhanced over 1 wt% Pt supported on CeO₂-modified SBA-15 obtained by DP.     

Preparation,characterization and salt-resistance of a coal based super absorbent composite

Potassium humate was extracted from brown coal.A novel super absorbent composite,poly (acrylic acid-co-acrylamide)/potassium humate (PAA-AM/KHA),was prepared by graft polymerization of acrylic acid,acrylamide and coal based potassium humate using N,N'-methylenebisacrylamide as a crosslinker and potassium peroxydisulfate as an initiator.The effects of reaction temperature,degree of neutralization of the poly (acrylic acid) and the amounts of crosslinker,initiator and potassium humate were investigated.Salt resistance tests were also carried out.The composite prepared under optimal conditions had a potassium humate content of 10% and exhibited a water absorption of 770 g/g in distilled water,and 349,286 and 41 g/g in 0.5 mol/L KC1,MgCl2 and AlCl3 solutions respectively.The results indicate that the salt resistance of PAA-AM/KHA was superior to that of poly (acrylic acid-co-acrylamide) because of the collaborative effect of functional groups of the coal based potassium humate.The PAA-AM/KHA micro powder was characterized by IR spectroscopy and the micrographic surface was characterized by scanning electron microscopy.Introduction of potassium humate into the poly (acrylic acid-co-acrylamide) structure creates a composite more suitable for use as a water-managing material in the renewal of arid and desert environments.The salt resisting property of the composite is improved,production costs are reduced and the growth stimulant effect is still present.