Reliable Mark-Embedded Algorithm for Verifying Archived/Encrypted Image Contents in Presence Different Attacks with FEC Utilizing Consideration

Wireless Personal Communications - Due to the widely spreading of fake news utilizing image manipulation and its bad effects, this paper investigates efficient image contents verification and...     

A Novel Approach to Analyzing the Occupancy of the Geo/Geo/∞ Queueing System

Discrete time queueing systems have been successfully used to model packet queues in computer and digital communications systems. In this article we introduce a novel approach to analyzing the Geo^X/Geo^Y/∞ queueing system, which is suitable for modelling high speed computer and communications systems. The approach is based on characterizing the system by a functional equation which is then solved recursively to give identical results to those obtained using other approaches.     

Model Validation for Bridge-Road-Vehicle Dynamic Interaction System

The dynamic response of highway bridges subjected to moving truckloads has been observed to be dependent on (1) dynamic characteristics of the bridge; (2) truck configuration, speed, and lane position on the bridge; and (3) road surface roughness profile of the bridge and its approach. Historically, truckloads were measured to determine the load spectra for girder bridges. However, truckload measurements are either made for a short period of time [for example, weigh-in-motion (WIM) data] or are statistically biased (for example, weigh stations) and cost prohibitive. The objective of this paper is to present results of a 3D computer-based model for the simulation of multiple trucks on girder bridges. The model is based on the grillage approach and is applied to four steel girder bridges tested under normal truck traffic. Actual truckload data collected using a discrete bridge WIM system are used in the model. The data include axle loads, truck gross weight, axle configuration, and statistical data on multiple presence (side by side or following). The results are presented as a function of the static and dynamic stresses in each girder and compared with code provisions for dynamic load factor. The study provides an alternate method for the development of live-load models for bridge design and evaluation.     

Evaluation of Laminated Circular Elastomeric Bearings

This paper evaluates the behavior and performance of laminated circular elastomeric bearings and compares them to those of square and rectangular bearings. The study included an experimental evaluation and a nationwide survey of state Department of Transportations on the use and performance of circular bearings and bearings in general in their states. The experimental investigation studied the bearings' behavior in compression, compression and rotation, and compression and shear. Results from this limited study showed that the three bearings have similar stress-strain behavior in compression and they are in agreement with the AASHTO LRFD guide stress–strain curves. In compression and rotation, the AASHTO LRFD substructure moments are slightly less than the measured values for circular bearings and rectangular bearings rotated about their strong axis for a compressive stress of 10.3?MPa (1.5?ksi) and slightly higher than those of rectangular bearings rotated about their weak axis. In compression and shear, the shear stiffness of circular and square bearings is in agreement with theoretical values within the range of design displacements. Results from the survey showed that many states are using circular bearings and more states would consider using them, however no maintenance or monitoring data were available on their short-term and long-term performance.     

Effect of the percentage carbon equivalent on the nodule characteristics,density and modulus of elasticity of ductile cast iron

Successful melting and Mg treatment were conducted using a vortex unit which produced spheroidal graphite (SG) Fe ingots having a percentage carbon equivalent (%CE) ranging from 3.782 to 5.240. Microstructure examination revealed graphite nodules embedded in a white matrix (unetched condition). The variation of %CE proved to have a pronounced effect on the nodule characteristics. The nodule count showed a maximum value at %CE of 4.613. For metal-mould ingots it reached a value of 1584 nodules mm^–2, while for sand-mould ingots it reached a value of 970 nodules mm^–2. Nodule size was found to be inversely proportional to the nodule count for both sand- and metal-mould ingots. The nodularity of all ingots was, in general, higher than 95%. The density of SG Fe was found to decrease gradually (at %CE=3.782) from 7242 to 6969 kg m^–3. The modulus of elasticity (E) showed a boat-like curve having minimum values of 189 and 192 GPa for the sand and metal moulds, respectively.     

Analysis and Optimization of Noise in Bipolar RF Harmonic Mixers

A noise analysis of bipolar harmonic mixers (BHM) used for direct-conversion receivers is presented in this paper. Analytical and simulated results for the transfer function of the mixer are presented. Simple analytical expressions describing noise contribution from all sources are derived. Estimation of flicker noise quite agrees with harmonic-balance simulation results. Based on the derived expressions, total time average noise power spectral density (PSD) at the output is compared with simulation results. For the recommended regions of operation, error is less than 20%. The overall BHM noise figure (NF) is calculated and optimized based on a simple extracted formula. Errors introduced by analysis remain within a 1.5-dB margin with respect to simulation results. The validity of analysis for high frequencies is justified. The effect of flicker noise coefficient on the overall mixer NF is compared for different available processes.     

Effects of a single dose of N-Acetyl-5-methoxytryptamine (Melatonin) and resistance exercise on the growth hormone/IGF-1 axis in young males and females

Melatonin and resistance exercise alone have been shown to increase the levels of growth hormone (GH). The purpose of this study was to determine the effects of ingestion of a single dose of melatonin and heavy resistance exercise on serum GH, somatostatin (SST), and other hormones of the GH/insulin-like growth factor 1 (IGF-1) axis. Physically active males (n = 30) and females (n = 30) were randomly assigned to ingest either a melatonin supplement at 0.5 mg or 5.0 mg, or 1.0 mg of dextrose placebo. After a baseline blood sample, participants ingested the supplement and underwent blood sampling every 15 min for 60 min, at which point they underwent a single bout of resistance exercise with the leg press for 7 sets of 7 reps at 85% 1-RM. After exercise, participants provided additional blood samples every 15 min for a total of 120 min. Serum free GH, SST, IGF-1, IGFBP-1, and IGFBP-3 were determined with ELISA. Data were evaluated as the peak pre- and post-exercise values subtracted from baseline and the delta values analyzed with separate three-way ANOVA (p < 0.05). In males, when compared to placebo, 5.0 mg melatonin caused GH to increase (p = 0.017) and SST to decrease prior to exercise (p = 0.031), whereas both 0.5 and 5.0 mg melatonin were greater than placebo after exercise (p = 0.045) and less than placebo for SST. No significant differences occurred for IGF-1; however, males were shown to have higher levels of IGFBP-1 independent of supplementation (p = 0.004). The 5.0 mg melatonin dose resulted in higher IGFBP-3 in males (p = 0.017). In conclusion, for males 5.0 mg melatonin appears to increase serum GH while concomitantly lowering SST levels; however, when combined with resistance exercise both melatonin doses positively impacts GH levels in a manner not entirely dependent on SST.     

Obesity: Prevalence,Theories, Medical Consequences,Management, and Research Directions

Obesity and its associated disorders are a growing epidemic across the world. Many genetic, physiological, and behavioral factors play a role in the etiology of obesity. Diet and exercise are known to play a valuable role in the treatment and prevention of obesity and associated disorders such as hypertension, heart disease, and diabetes. Therefore, the purpose of this review is to examine the prevalence, etiology, consequences, and treatment of obesity.