基于有限元的低成本塔桅设计及承载能力分析

为研究铁塔公司发布的最新《低成本铁塔标准图集V1.0》的共享改造能力,文章选取了单斜撑三管塔0.65 kN/m2基本风压下的系列塔图,从各塔段的主管应力比和塔顶位移角两个角度,考虑新增天线设备、馈线、爬梯荷载,以及天线设备之间的相互遮挡,利用有限元软件SAP2000对每种塔型进行了常规设计分析和改造增载后的研究分析.由分析结果可知,每种塔型均有可共享改造能力,且随着塔身高度的增加,共享改造的能力逐渐降低.     

广东早期砖薄壳结构的建构技术研究——1957-1958年新会的"逼拱"实验

揭示1957-1958年华南工学院土木系薄壳结构研究小组在新会的砖薄壳结构实验图景.以田野调查、文献分析、三维图示、超声波检测等方法发现、确认此研究小组在新会的6处薄壳建筑及其遗存情况.它们是广东地区推广砖薄壳建筑的起点,其中的回旋砖薄壳实验是从结构角度探索中国建筑民族形式的重要案例,弥补国内结构工程史学研究的薄弱点,也是共和国早期节约"三材"约束下的薄壳建造技术自主创新设计的重要内容.     

X70配套埋弧焊丝用H08D盘条的研制

介绍了北营公司X70配套埋弧焊丝用H08D盘条的开发研制情况.其生产工艺的关键点为:转炉采用“双渣法除磷”,脱氧合金化在转炉和LF炉两个阶段完成,连铸采用结晶器电磁搅拌及末端电磁搅拌、恒定拉速;盘条采用控冷控轧及轧后延迟型斯太尔摩冷却工艺等措施.生产的成品盘条成分、力学性能、金相组织等指标均满足客户拉拔工艺要求.     

低觉醒脑电识别与唤醒的可穿戴系统研究

为智能化地识别警戒作业人员出现的低觉醒、注意力下降的生理状态，本文介绍了一种基于FPGA和脑电信号处理的低觉醒状态检测与唤醒系统，系统通过传感器从大脑头皮采集脑电信号，转换为数字信号，经傅里叶变换获取了脑电信号的θ相对能量、α相对能量、重心频率、谱熵等4个特征量，由4个特征量表征低觉醒状态并运用支持向量机对低警戒状态进行识别，当识别出低觉醒状态时采用声音报警模块发出声音，唤醒警戒作业人员。设计系统能够较好地识别出低觉醒状态，识别率达90.8%，可为提高警戒作业工作绩效提供一种可穿戴的智能装备。     

海上稠油油田蒸汽吞吐产量确定新方法

针对目前蒸汽吞吐产量预测模型假设条件简单、普适性差等问题,一般采用测试法和类比法综合确定海上稠油油田蒸汽吞吐初期产量。由于目前海上油田通常只开展常规测试,无法直接获得热采开发初期产量。笔者提出海上稠油油田蒸汽吞吐初期产量确定新方法,建立蒸汽吞吐相对于常规开发的初期产量倍数预测模型,通过蒸汽吞吐产量倍数,将常规测试确定的产量转化为蒸汽吞吐产量。研究表明,蒸汽吞吐初期产量倍数主要受储集层渗透率、原油黏度、注入强度、蒸汽干度等因素影响,利用正交试验设计和多元回归等方法,建立海上稠油油田蒸汽吞吐初期产量倍数与油藏地质参数及注入参数之间的非线性预测模型,该模型经实际生产数据验证,预测误差小于5%,可靠性高,能够为海上稠油油田蒸汽吞吐初期产量的确定提供依据。     

Uplink Scheduling in CDMA Packet-Data Systems

Uplink scheduling in wireless systems is gaining importance due to arising uplink intensive data services (ftp, image uploads etc.), which could be hampered by the currently in-built asymmetry in favor of the downlink. In this work, we propose and study algorithms for efficient uplink packet-data scheduling in a CDMA cell. The algorithms attempt to maximize system throughput under transmit power limitations on the mobiles assuming instantaneous knowledge of user queues and channels. However no channel statistics or traffic characterization is necessary. Apart from increasing throughput, the algorithms also improve fairness of service among users, hence reducing chances of buffer overflows for poorly located users. The major observation arising from our analysis is that it is advantageous on the uplink to schedule “strong” users one-at-a-time, and “weak” users in larger groups. This contrasts with the downlink where one-at-a-time transmission for all users has shown to be the preferred mode in much previous work. Based on the optimal schedules, we propose less complex and more practical approximate methods, both of which offer significant performance improvement compared to one-at-a-time transmission, and the widely acclaimed Proportional Fair (PF) algorithm, in simulations. When queue content cannot be fed back, we propose a simple modification of PF, Uplink PF (UPF), that offers similar improvement. Hereafter, we refer to users with low recieved power at the base even when transmitting at peak transmit power as “weak” users, and the strongly recieved users at the base as “strong” users. Krishnan Kumaran is currently a member of the Complex Systems Modeling section in the Corporate Strategic Research of ExxonMobil Corp., Clinton, NJ. Formerly, he was a Member of Technical Staff in the Mathematics of Networks and Systems Research Department at Bell Labs in Murray Hill, NJ, where his research interests were in modeling, analysis and simulation of design, resource management and scheduling issues in telecommunication networks. Lijun Qian is an assistant professor in the Department of Electrical Engineering at Prairie View A&M University. He received his B.S. from Tsinghua University in Beijing, M.S. from Technion-Israel Institute of Technology, and Ph.D. from WINLAB, Rutgers University, all in electrical engineering. Before joining PVAMU, he was a researcher at Networks and Systems Research Department of Bell Labs in Murray Hill, NJ. His major research interests are in wireless communications and networking technologies, especially in radio resource management, protocol design, TCP/RLP optimization and MPLS traffic engineering.     

结构化编程实现Sniffer

随着各高校校园网络规模的不断扩大和各种应用的急剧增加,各种新的网络问题也在不断出现。Sniffer是网络管理员进行网络管理的有效工具,可以有效地对网络进行实时监控,及时发现网络中存在的各种问题。本文首先介绍了Sniffer的工作原理,其次给出了实现Sniffer功能的编程流程图,并用C语言给出了编程所需的关键代码。     

采用区内C／I平衡的多区峰窝CDMA系统下行链路的性能

本文对采用区内Ｃ／Ｉ平衡的多区蜂窝ＣＤＭＡ系统下行链路的性能进行分析，给出两种区内Ｃ／Ｉ平衡算法并比较它们的性能，考虑呈对数正态分布的阴影和Ｒ＾－４规律的路径损失的综合影响，采用与传统不同的小区平均中断概率来评价系统的性能。     

A mechanism for transgranular stress-corrosion cracking

A model is proposed to explain transgranular-stress corrosion cracking (T-SCC) in face-centered cubic (fcc) materials. Crack propagation is shown to be anisotropic, in that growth near {110} < 001> is discontinuous due to crack arrest by dislocation blunting whereas growth away from this growth orientation is continuous. For the former case, renucleation of arrested cracks involves active dissolution of shear bands at the crack tip, which changes the stress state at Lomer-Cottrell locks, causing them to fail by cleavage. Once the crack is nucleated, its instantaneous macroscopic crack-growth velocity is considered to be comprised of multiple nucleation of microcracks with intervening arrests. This microcracking results from the interaction of the stress fields from neighboring cracks which are forming simultaneously, the crack-opening constraint due to ligaments which act as “bridges” behind the crack front, and the localized dissolution at the microcrack tip which affectsK _IC and leads to the “cobblestone” appearance. Experimental evidence and theoretical considerations are presented to support the model. The system studied was Cu-25 at. pct Au in 0.6 M NaCl solution at potentials between 300 and 400 mV (sce), which precludes hydrogen embrittlement. This article is based on a presentation made in the symposium “Quasi-Brittle Fracture” presented during the TMS fall meeting, Cincinnati, OH, October 21–24, 1991, under the auspices of the TMS Mechanical Metallurgy Committee and the ASM/MSD Flow and Fracture Committee.