EGD级环保型润滑油及其生物降解性

 经生物降解性评定和粘度测量确定了EGD级生物降解二冲程润滑油复合基础油的组成；通过发动机清净性试验确定了添加剂组成配方和总添加量。在此基础上，研制了生物降解二冲程油(Oil B)，其达到了ISO EGD级二冲程油标准中规定的6个发动机性能指标和2个理化性能指标，生物降解性达到73.1%。     

基于多抽样率信号处理的无源雷达MTD方法

以数字电视信号为机会照射源的雷达系统研究为背景 ,提出用以多抽样率信号处理为基础的多级抽取信号处理算法解决运动目标检测中海量数据处理问题。文中叙述了数字电视广播信号回波的数学模型、多级抽取基本原理、目标检测算法 ,以数字电视信号为反射回波做了仿真 ,对运动目标进行检测 ,并对仿真结果做了分析。     

Prolonged tamoxifen exposure selects a breast cancer cell clone that is stable in vitro and in vivo

The effects of long-term tamoxifen exposure on cell growth and cell cycle kinetics were compared between oestrogen receptor (ER)-positive (MCF-7) and ER-negative (MDA-MB-231) cell lines. In the MCF-7 cell line, prolonged tamoxifen exposure (0.5 mumol/l for > 100 days) blocked cells in G0-G1 of the cell cycle, and slowed the doubling time of cells from 30 to 59 h. These effects corresponded to an increase in the cellular accumulation of tamoxifen over time [mean area under concentration curve (AUC) = 77.92 mumoles/10(6)/cells/day]. In contrast, in the MDA-MB-231 cell line, long-term tamoxifen exposure had no obvious effect on the doubling time, and reduced cellular tamoxifen accumulation (mean AUC = 50.50 mumoles/10(6)/cells/day) compared to the MCF-7 cells. Flow cytometric analysis of MDA-MB-231 cells demonstrated that a new tetraploid clone emerged following 56 days of tamoxifen exposure. Inoculation of the MDA-MB-231 tetraploid clone and MDA-MB-231 wildtype cells into the opposite flanks of athymic nude mice resulted in the rapid growth of tetraploid tumours. The tetraploid tumours maintained their ploidy following tamoxifen treatment for nine consecutive serial transplantations. Histological examination of the fifth transplant generation xenografts revealed that the tetraploid tumour had a 25-30 times greater mass, area of haemorrhage and necrosis, a slightly higher mitotic index and was more anaplastic than the control neoplasm. The control wildtype MDA-MB-231 tumours maintained a stable ploidy following tamoxifen treatment until the eighth and ninth transplantation, when a tetraploid population appeared, suggesting that tamoxifen treatment may select for this clone in vivo. These studies suggest that prolonged tamoxifen exposure may select for new, stable, fast growing cell clones in vitro as well as in vivo.     

Dy3+激活的几种硼酸盐在VUV-VIS范围的光谱性质

本文报道了SrAl2B2o7:Dy^3 、BaAl2B2O7:Dy^3 、SrAl3BO7:Dy^3 、La2CaB10O19:Dy^3 的紫外－真空紫外（UV－VUV）激发光谱和UV激发下的发射光谱。根据发射光谱讨论了Dy^3 离子在这几种基质中发光的黄蓝比（Y／B）。在VUV激发光谱中推测了Dy^3 的f-d跃迁及电荷迁移态（CTS）和基质吸收的位置。     

Photoluminescence and X-ray Diffraction of Distributed Bragg Reflector

Spectral and structural characteristics of distributed Bragg reflector (DBR) in vertical-cavity surface-emitting lasers were studied with photoluminescence and double- crystal X- ray diffraction measurement. The expected high quality epitaxial DBR structure was verified. In the X- ray double- crystal rocking curves of DBR the zeroth- order peak, the first and second order satellite peaks were measured. Splitting of diffraction peak appeared in the rocking curves was analyzed. The effects of introduced deep energy levels on the structural perfection and optical properties were discussed.     

引水发电系统无压隧洞中弃水堰位置的数值模拟研究

水电站引水发电系统无压隧洞中的水力过渡过程是近年来电站设计中出现的一个新课题,特别是流域梯级电站开发中经常遇到。结合工程实例应用扩散法,给出了无压隧洞水力过渡过程数值模拟的基本方程以及上下游及弃水堰等边界附加方程,模拟了弃水堰布置在不同位置下,无压隧洞内的水位变化过程。研究成果和讨论对实际工程应用具有参考意义。     

Accuracy of using computed tomography to identify pedicle screw placement in cadaveric human lumbar spine

STUDY DESIGN: Utility of using computed tomography to predict pedicle screw misplacement. OBJECTIVE: This study defines the sensitivity and specificity of predicting pedicle screw placement by experienced clinicians using a CT scan image. SUMMARY OF BACKGROUND DATA: In clinical and research settings, the method most commonly used to evaluate pedicle screws placement has been computed tomography. However, no current literature describes the accuracy of this method of evaluating screw placement. METHOD: Cobalt-chrome and titanium alloy pedicle screws of identical size were placed in six cadaveric human lumbar spine. Wide laminectomy was performed to allow complete visualization of the pedicles. Three consecutive lumbar levels were instrumented in each spine, giving 36 pedicle screw placements to identify. The instrumented spines were imaged, and four orthopaedic spine surgeons and a musculoskeletal radiologist were asked to read the images to identify the accuracy of screw placement within the pedicles. RESULTS: The sensitivity rate of identifying a misplaced screw was 67 +/- 6% for cobalt-chrome screws compared with 86 +/- 5% for titanium screws (P < 0.005). The specificity rates of radiographic diagnosis of misplaced pedicle screws were 66 +/- 10% for cobalt-chrome screws and 88 +/- 8% for titanium screws (P < 0.005). Similarly, a statistically significant difference was found in the sensitivity rates of identifying screws placed correctly in the pedicle: 70 +/- 10% for cobalt-chrome screws versus 89 +/- 8% for titanium screws (P < 0.005). Overall accuracy rates were 68 +/- 7% for cobalt chrome screws versus 87 +/- 3% for titanium screws (P < 0.002). CONCLUSION: Reliance on the computed tomography scan data alone in determining accuracy of pedicle screws can lead to inaccuracies in both clinical and research conditions.     

机械合金化的原理及在磁性材料研究中的应用

介绍了机械合金化的原理和描述机械合金化过程的理论模型。综述了机械合金化在磁性材料研究中的应用，并对目前研究中的存在的问题及发展前景进行了分析。     

网格曲面中孔洞的光滑填充算法研究

三角网格模型是几何描述的一种重要形式，有着广泛的应用。但三角网络模型常常会存在孔洞缺陷。这些孔洞的存在一方面影响视觉效果，另一方面会影响许多后续的操作，如快速原型制造、有限元分析等，因此有必要对这些孔洞进行修补。目前绝大多数孔洞填充算法是将网格模型中的孔洞提取成空间多边形，并对孔洞多边形进行三角化。这种处理方法的主要缺陷是没有考虑网格曲面在孔洞附近的几何形态，因而填充部分不能与整个曲面光滑地融为一体。笔者提出了一种三角网格曲面中孔洞的光滑填充算法。该算法根据孔洞周围网格曲面的几何信息来增加孔洞内部的采样点，然后再对增加的采样点进行三角化，较好地解决了填充部分与整体曲面光滑连接的问题。     

高压乙烯压缩机出入口管线振动分析及改造

为减轻高压乙烯压缩机出入口管线的振动,采用有限元建模方法,对管线结构固有频率及各阶振型进行分析计算,详细讨论了在管线同一位置加不同约束和在不同位置加同一约束的情况对管线振动的影响.最后,结合测试数据和现场实际情况提出了改造方案.实际使用结果证明改造措施有效,达到了预期的防振效果.