Finite-difference time-domain analysis and experimental examinationof the performance of a coupled-cavity MQW laser/active waveguide at1.54 μm

The performance characteristics of a coupled cavity InGaAsP-InP MQW laser/active waveguide made by one-step epitaxy and well-controlled reactive ion etching (RIE) have been theoretically analyzed and experimentally determined. A theoretical model based on a finite-difference time-domain (FDTD) technique was used to simulate the propagation of an optical wave launched in the coupled system and determine the reflectivity of the facets created by RIE. The calculated effective reflectivity of the coupling region consisting of two facets and an air gap is between 0.45 and 0.55, which is in good agreement with the experimentally measured value of 0.5. The reflectivity of a single etched mirror derived from this value is estimated to be 0.3. A 120-μm-long monolithically integrated active waveguide when biased as a modulator and excited by the laser shows a maximum extinction ratio of 8 dB and a modulation bandwidth ⩾14 GHz at a dc bias of -0.5 V with a bias swing of 2 V     

DSP-based digital FM demodulation for GMSK signals

Demodulation of Gaussian Minimum Shift Keying (GMSK) using a limiter-discriminator is a low complexity alternative to coherent demodulation. This so-called digital FM demodulation is followed by clock recovery, sampling, and thresholding. Conventionally, clock recovery is done in hardware, and matched filtering is usually not possible when the Gaussian pulse is wider than a bit duration. We propose a clock recovery technique based on discrete-time processing of the demodulated baseband signal. This technique couples very nicely with a new maximum likelihood sequence estimator for the data that uses a whitening filter followed by a Viterbi decoder. The entire detection algorithm can be implemented in an efficient manner on a Digital Signal Processor (DSP). Computer simulation results are presented to show that the new algorithm performs better than the conventional slicer by as much as 5.5 dB.     

Effect of ultrasound on bubble breakup within the mixing chamber of an effervescent atomizer

Gas bubbles introduced into a liquid in the mixing chamber help to break up the liquid into fine droplets on being expanded to the ambient pressure. The passage of gas bubbles through the orifice of the nozzle requires that the size of the bubbles be much smaller than the diameter of the orifice. In the present work, the effectiveness of 20 kHz ultrasound to increase number density of fine bubbles within the mixing chamber of an effervescent atomizer by breaking up bubbles introduced in it by an aerator was investigated. Bubbles of initial size in the range of 5-10 mm were shown to get disintegrated into clusters of micron and sub-micron sized bubbles. A fine spray was produced in the presence of ultrasound at a gas-to-liquid mass flowrate ratio (GLR) of 0.063%. The half-cone angle of spray was in the range of 6-10°, which compares favorably with conventional atomizers. The experimental findings of bubble breakup were theoretically modeled by the Rayleigh-Plesset equation. The results of the model indicate that bubbles having initial radius less than 3 mm undergo growth and subsequent disintegration at 20 kHz for the given acoustic pressure of 0.3 MPa.     

Studies on micro-structural and electrical properties of spray-deposited fluorine-doped tin oxide thin films from low-cost precursor

Thin films of fluorine-doped tin oxide (SnO₂:F) on glass were prepared by spray pyrolysis technique using stannous chloride (SnCl₂) and ammonium fluoride (NH₄F) as precursors. The as-prepared films were characterized for their structural and electrical properties and are discussed in detail in this article. The surface morphology studies revealed that the films are grainy and the roughness of undoped films has been reduced on fluorine doping. X-ray diffraction (XRD) studies revealed that the films are polycrystalline. It further revealed that the undoped films grow along the preferred orientation of (211), whereas all the doped films grow along (200). The minimum sheet resistance 1.75 Ω/□ achieved in the present study for the films doped with 15 wt.% F is the lowest among the reported values for these materials prepared using SnCl₂ precursor. The electrical transport phenomenon has been analyzed in order to find out the possible scattering mechanism that limiting the mobility of charge carriers.     

Low temperature flash vaporization for desalination

The feasibility of desalination by low pressure vaporization of seawater at temperatures between 26°C and 32°C was demonstrated in a pilot plant. The plant operated at vacuum pressures between 1.3 KPa and 2.3 KPa. The saline water was sprayed into the vaporizer as fine droplets using a swirl nozzle and evaporated at the low pressure. The maximum flow rate was 1,000 1/h. Condensation of the vapor so formed, was carried out in a shell and tube heat exchanger. The yield of fresh water was up to 4% as predicted by theory. The quality of the condensed water was excellent. The investigation demonstrated a novel concept of devising a desalination system by using warm water from the upper strata of the ocean for flash vaporization at low pressures and condensing the vapors using cold water from the lower strata of the ocean. The performance of the pilot plant was determined for different feed water temperatures, vacuum and water injection pressures.     

Total sugar content in sorghum stalks and grains of selected cultivars from the world germplasm collection

Seventy sorghum cultivars from the world germplasm collection maintained at the International Crops Research Institute for the Semi-Arid Tropics (ICRISAT) were screened for total sugar content of the stalks. The total sugar content in stalks harvested after physiological maturity ranged from 17.8 to 40.3% on dry weight basis. The total sugar content in grains of 15 selected cultivars ranged from 1.02 to 2.23%. Nine cultivars having more than 34% total sugar content in stalks showed consistency for sugar content when grown for two seasons. Juiciness of stalks from five cultivars as estimated by the quantity of juice extracted varied from 266 to 464 ml per kilogram of fresh stalks. The total sugar content in the juice of five cultivars varied from 7.0 to 15.9%.     

Self-learning fuzzy logic system for in situ, in-processdiagnostics of mass flow controller (MFC)

An improvement in the yield of better quality wafers requires an accurate control of various process variables. The control should include timely diagnosis and appropriate in-situ, in-process adjustments for drifts in these variables. One such scheme, a self-learning fuzzy logic system, is developed in this study for correcting drifts in the calibration of mass flow controllers (MFC's) that control the flow of gases into a process chamber. It consists of two components; a diagnostic system and a self-learning system. The diagnostic system uses fuzzy logic to diagnose the problem and initiate suitable remedial action, The self-learning system automatically builds the knowledge base used for diagnosis. The knowledge base is initialized using clustering principle and is tuned for better performance using a set of heuristic rules. The system is capable of learning the behavior of different types of makes and models of MFC's under various flow rates. It has been tested on two different types of MFC's under different flow rates and encouraging results have been obtained