全文获取类型
收费全文 | 759篇 |
免费 | 29篇 |
国内免费 | 7篇 |
专业分类
电工技术 | 38篇 |
综合类 | 3篇 |
化学工业 | 209篇 |
金属工艺 | 14篇 |
机械仪表 | 15篇 |
建筑科学 | 11篇 |
能源动力 | 38篇 |
轻工业 | 57篇 |
水利工程 | 3篇 |
无线电 | 67篇 |
一般工业技术 | 158篇 |
冶金工业 | 40篇 |
原子能技术 | 39篇 |
自动化技术 | 103篇 |
出版年
2022年 | 6篇 |
2021年 | 7篇 |
2019年 | 12篇 |
2018年 | 13篇 |
2016年 | 14篇 |
2015年 | 9篇 |
2014年 | 14篇 |
2013年 | 26篇 |
2012年 | 36篇 |
2011年 | 45篇 |
2010年 | 29篇 |
2009年 | 27篇 |
2008年 | 33篇 |
2007年 | 29篇 |
2006年 | 25篇 |
2005年 | 27篇 |
2004年 | 36篇 |
2003年 | 26篇 |
2002年 | 21篇 |
2001年 | 12篇 |
2000年 | 17篇 |
1999年 | 19篇 |
1998年 | 28篇 |
1997年 | 22篇 |
1996年 | 12篇 |
1995年 | 13篇 |
1994年 | 9篇 |
1993年 | 17篇 |
1992年 | 7篇 |
1991年 | 9篇 |
1990年 | 9篇 |
1989年 | 17篇 |
1988年 | 15篇 |
1987年 | 10篇 |
1986年 | 8篇 |
1985年 | 6篇 |
1984年 | 11篇 |
1983年 | 10篇 |
1982年 | 6篇 |
1981年 | 9篇 |
1980年 | 13篇 |
1979年 | 14篇 |
1978年 | 8篇 |
1977年 | 8篇 |
1976年 | 10篇 |
1975年 | 7篇 |
1973年 | 6篇 |
1972年 | 3篇 |
1968年 | 5篇 |
1965年 | 3篇 |
排序方式: 共有795条查询结果,搜索用时 0 毫秒
1.
Yoshihiro Iida Toshikatsu Tsuyuki Takao Mashima Takeo Takashima Kunito Okuyama 《亚洲传热研究》2002,31(1):28-41
This paper presents a series of experimental results on a passive augmentation technique of boiling heat transfer by supplying solid particles in liquid. A cylindrical heater 0.88 mm in diameter is placed in saturated water, in which a lot of mobile particles exist, and the nucleate and film boiling heat transfer characteristics are measured. Particle materials used were alumina, glass, and porous alumina, and the diameter ranged from 0.3 mm to 2.5 mm. Particles are fluidized by the occurrence of boiling without any additive power, and the heat transfer is augmented. The maximum augmentation ratio obtained in this experiment reaches about ten times the heat transfer coefficient obtained in liquid alone. The augmentation ratio is mainly affected by the particle material, diameter, and the height of the particle bed set at no boiling condition. The augmentation mechanism is discussed on the basis of the experimental results. © 2001 Scripta Technica, Heat Trans Asian Res, 31(1): 28–41, 2002 相似文献
2.
3.
Masako Yudasaka Rie Kikuchi Takeo Matsui Yoshimasa Ohki Mark Baxendale Susumu Yoshimura Etsuro Ota 《Thin solid films》1996,280(1-2):117-123
Thin film formation of graphite by chemical vapor deposition using 2-methyl-1,2′-naphthyl ketone as a starting material was carried out on Ni film substrates. On Ni films directly deposited on quartz glass, the graphite films were obtained when the Ni film thickness was above 1 000 Å and above 5 000 Å at 700 °C and 1 000 °C, respectively. Depositions on thinner Ni film substrates comprise amorphous carbon (a-C) or graphite tubes which was owing to the thermal coagulation of the Ni film into droplets. On the other hand, graphite film was obtained on the Ni film with thickness 10 Å when a-C was inserted between the Ni film and the quartz glass. The coagulation of the Ni film is considered to be avoided by inserting a-C layer. 相似文献
4.
Yi Jin Chieko Toeda Takeo Kawaguchi Toshinobu Seki Kazuhiko Juni 《Drug development and industrial pharmacy》1996,22(7):653-658
Permeation of zidovudine (3'-azido-3'-deoxythymidine, AZT) and probenecid from oily bases containing an alcohol through rat skin was examined. Isopropyl myristate (IPM), as an oily vehicle, showed a penetration enhancing effect for AZT and probenecid. Ethanol, n-propanol, and n-butanol were used as additives in IPM and were examined for their own permeation and the enhancing effect on the permeation of AZT and probenecid. The skin permeation of AZT and probenecid from IPM was enhanced by addition of the alcohol in IPM. The degree of the enhancement was decreased with increasing lipophilicity of the alcohol used. me permeation rate of the drug from those systems was shown to be governed by penetration-enhancing effects of the oily base and alcohol, and the penetration of the alcohol itself through the skin. 相似文献
5.
Koichi Itagaki Md. Mortuza Ali Hiroshi Kitamura Takeo Maruyama 《Electrical Engineering in Japan》1992,112(2):1-10
Several sealed-off triggered vacuum gaps are connected in series to improve hold-off voltage. The characteristics of impulse breakdown voltage of these series-connected gaps are investigated experimentally. The sum hold-off voltage of series-connected gaps decreases to a unit hold-off voltage when the maximum value of voltage division ratio across the gaps increases to unity. Self-breakdown probability of the series-connected gaps is always higher than that of a single gap under the same conditions. Hence, stage efficiency of the multistage gap decreases with increasing number of stages. Its value is 90 percent with 2-stage gap and 75 percent with 5-stage gap, respectively, under the same voltage division ratio and the same gap length (2.0 mm) in each stage. Triggered breakdown voltage of 2- or 3- stage gap is several hundred volts when all gaps are triggered simultaneously at the peak of the main impulse wave and a working voltage range is nearly 100 percent in this case. The working voltage range decreases with number of stages. Its value is 45 percent with 3-stage gap and 15 percent with 5-stage gap, respectively, when one triggered gap is fired for switching. 相似文献
6.
Digitally recording dynamic events, such as sporting events, for experiencing in a spatio-temporally distant and arbitrary setting requires 4D capture: three dimensions for their geometry and appearance over the fourth dimension of time. Today's computer vision techniques make 4D capture possible. The virtualized reality system serves as an example on the general problem of digitizing dynamic events. In this article, we present the virtualized reality system's details from a historical perspective 相似文献
7.
8.
The integral experiment on beryllium with D-T neutrons for verification of tritium breeding 总被引:1,自引:0,他引:1
Yury Verzilov Satoshi Sato Kentaro Ochiai Masayuki Wada Axel Klix Takeo Nishitani 《Fusion Engineering and Design》2007,82(1):1-9
A clean benchmark experiment on beryllium was performed with D-T neutrons at the FNS facility of the Japan Atomic Energy Agency. The main objective was to verify the integral data related to the tritium production on lithium isotopes. Tritium production rates, as well as activation reaction rates were measured inside the beryllium assembly that was shaped as a pseudo-cylindrical slab with an area-equivalent diameter of 628 mm and a thickness of 355 mm. Experimental results were analyzed with a three-dimensional Monte Carlo transport code MCNP-4C and FENDL/MC-2.0, JENDL-3.2/3.3 neutron transport libraries. Evaluation of reaction rates was based on the cross section data taken from the JENDL Dosimetry File and ENDF B-VI data libraries. Analysis shows that all calculation combinations (transport and activation cross section libraries) used for evaluation of reaction rates give data that is agreeable with measured values within 10%. 相似文献
9.
10.
Summary Spontaneous copolymerizations of cyclic acyl phosphonite (SPO) and phosphite (SPI) with an electron-deficient vinyl monomer
such as methyl acrylate (MA), methyl vinyl ketone (MVK), and acrolein (AL), gave the corresponding alternating copolymers.
These copolymerizations took place without added initiator and proceeded through zwitterion intermediates. Copolymer structures
1a, 1b, 2 and 3 have been established, all of which were derived in a regiospecific manner of ambident anions. The scheme of the copolymerizations
is presented. 相似文献